Factor Resolution

But we want the tensile yield strength, A tensile stress a creates a shear stress in the material that has a maximum value of t = a/2. (We show this in Chapter 11 where we resolve the tensile stress onto planes within the material.) To calculate cr from t,, we combine the Taylor factor with the resolution factor to give... 

The right chromatography column should separate the sample sufficiently to enable identification or quantitative measurement of the components within a reasonable period of time. The resolution factor (Rs) for two sample components is determined by the width of the two peaks and the distance between the peak maxima. In general, Rs values of 1.0 are required for good qualitative or quantitative work, whereas Rs values >1.5 indicate baseline resolution for two components (3). 

TABLE 4.2 Comparison of Protein Resolution Factors (Rs) on TSK-GEL SW Columns"... 

TABLE 4.3 Resolution Factors (Rs) of Proteins with Various Ionic Species Added to the Elution Buffer" ... 

Resolution factors Column length ("f) Pore volume ( ) Column length ( ) Column length ( ) Void volume ( ) Column length ( ) Channel thickness ( i )... 

The improvements in resolution achieved in each deconvolution step are shown in Figure 3-3. While the initial library could only afford a modest separation of DNB-glutamic acid, the library with proline in position 4 also separated DNP derivatives of alanine and aspartic acid, and further improvement in both resolution and the number of separable racemates was observed for peptides with hydrophobic amino acid residues in position 3. However, the most dramatic improvement and best selectivity were found for c(Arg-Lys-Tyr-Pro-Tyr-(3-Ala) (Scheme 3-2a) with the tyrosine residue at position 5 with a resolution factor as high as 28 observed for the separation of DNP-glutamic acid enantiomers. 

In the elucidation of retention mechanisms, an advantage of using enantiomers as templates is that nonspecific binding, which affects both enantiomers equally, cancels out. Therefore the separation factor (a) uniquely reflects the contribution to binding from the enantioselectively imprinted sites. As an additional comparison the retention on the imprinted phase is compared with the retention on a nonimprinted reference phase. The efficiency of the separations is routinely characterized by estimating a number of theoretical plates (N), a resolution factor (R ) and a peak asymmetry factor (A ) [19]. These quantities are affected by the quality of the packing and mass transfer limitations, as well as of the amount and distribution of the binding sites. 

Plate number N (as for Gaussian peaks) Resolution factor R ... 

Racemate Separation factor a Resolution factor R S Note Refe- rence... 

Resolution factor (= l./(2 x variance of chromatogram of truly monodisperse sample))... 

Peedc-to-peak resolution in SEC can be calculated by the ratio of peak separation at the peak maxiaut to the sum of the baseline peak widths. This general definition of resolution is less useful in SEC, where a measure of the ability of the column to separate solutes of different molecular weight is required. For this purposes, we define a new term, the specific resolution factor, R, which relates peak resolution to sample molecular weight, assuming all measurements are made within the linear region of the molecular weight calibration curve, equation (4.41)... 

Inject 10 pL of solution (3). The test is not valid unless the resolution factor between the peaks due to miconazole and econazole is at least 10. 

Aboul-Enein and Ali [78] compared the chiral resolution of miconazole and two other azole compounds by high performance liquid chromatography using normal-phase amylose chiral stationary phases. The resolution of the enantiomers of ( )-econazole, ( )-miconazole, and (i)-sulconazole was achieved on different normal-phase chiral amylose columns, Chiralpak AD, AS, and AR. The mobile phase used was hexane-isopropanol-diethylamine (400 99 1). The flow rates of the mobile phase used were 0.50 and 1 mL/min. The separation factor (a) values for the resolved enantiomers of econazole, miconazole, and sulconazole in the chiral phases were in the range 1.63-1.04 the resolution factors Rs values varied from 5.68 to 0.32. 

The chiral recognition ability of a CSP is quantitatively evaluated from the results of chromatographic separation of enantiomers. Figure 3.4 shows a chromatogram of the resolution of benzoin (19) on cellulose tris(3,5-dimethylphenylcarbamate). The (+)-isomer elutes first followed by the (—)-isomer complete baseline separation is achieved. The results of the separation can be expressed by three parameters—capacity factors (k1), separation factor (a), and resolution factor (Rs)—defined as follows ... 

Table 1 Gas chromatographic resolution factors of N-pentafluoropropionyl amino acid isopropyl esters on polysiloxanes carrying chiral L-valine t-butylamide groups (Val-NtBu)... 

Table 2 Resolution factors of N(0)-pentafluoropropio-nyl derivatives of chiral compounds on polysiloxanes carrying different chiral amino acid residues.

Chiral resolution factor, ScMraU as the ratio between the homochiral and the heterochiral ion abundance ratios. 

Later, a commercially available TAG CSP was tested in the enantioseparation of 10 secondary a-amino acids, by using RP mobile mode systems [154]. The chromatographic results, compared with those obtained on a native teicoplanin CSP, were given as the retention, separation, and resolution factors, together with the enanti-oselective free energy difference corresponding to the separation of the investigated enantiomers. 

System suitability tests for chromatographic impurities procedures, such as precision, resolution factor, calibration standard, and tailing factor, should be considered as appropriate. In the presence of multiple peaks, a resolution factor between the two closest peaks should be proposed. For reliable quantitation, baseline resolution of the impurities will provide accurate measurement of the... 

The BP assay of betamethasone 17-valerate states that it must be resolved from betamethasone 21-valerate so that the resolution factor Is > 1.0. Which of the following ODS ... 

---