Sensing device sensor

O Toole M, Diamond D (2008) Absorbance based light emitting diode optical sensors and sensing devices. Sensors 8 2453-2479... 

Bulk-wave piezoelectric quartz crystal sensors indirecdy measure mass changes of the coating on the surface of the sensing device. This change in mass causes changes in the resonant frequency of the device, and measurements ate based on frequency differences. 

There are many types of sen.sors used to feed-back the process operating conditions to the switching logistics of an inverter unit. They can be in terms of temperature, pressure, volume, flow, time or any activity on which depends the accuracy and quality of the process. Direct sensing devices used commonly for the control of a drive and used frequently in the following text are speed. sensors, as noted below. 

Diaz-Garcia M.E., Badia R., Molecularly imprinted polymers for optical sensing devices" in Optical Sensors Industrial, Environmental and Diagnostic Applications, R. Narayanaswamy, O. S. Wolfbeis, (Eds.), Springer, 2004. 

Another example of an Si-based pH sensing device is an electrolyte-insulator-semiconductor (EIS) structure. In a typical EIS sensor, a voltage applied to the semiconductor back gate (Vgate) attracts ions in the electrolyte to the oxide surface. The... 

The most common control functions in these early appliances are the control of temperature, pressure, position or distance. Mechanical sensing devices were introduced for these purposes, such as bimetal temperature switches or liquid expansion temperature switches for ovens, washing machines, dishwashers, refrigerators, etc. Electromechanical pressure switches and potentiometric level sensors have also been introduced quite early. 

Instead of sharing the measurements related to the target state among the collaborating sensors, sharing the information form of the observations results in a simple additive fusion framework that can be run on each of the tiny sensing devices. The distributed data fusion equations are... 

Infrared radiation has a very low energy and cannot eject electrons from most common photoemissive surfaces. The initial infrared sensors were temperature-sensing devices. Thermocouples and thermistors are forms of bolometers used for detecting infrared radiation. 

Two of the primary applications for wireless data communications systems are to enable mobile or remote connections to a LAN, and to establish wireless communications links between SCADA remote telemetry units (RTUs) and sensors in the field. Wireless card connections are usually used for LAN access from mobile computers. Wireless cards can also be incorporated into RTUs to allow them to communicate with sensing devices that are located remotely. 

We recently published a chapter in the book Silicon Carbide Recent Major Advances by Choyke et al. [19] that describes SiC gas sensor applications in detail. In this book, we emphasize device properties applications are only briefly reviewed at the end. The device and gas sensing properties of various field-effect chemical gas sensing devices based on SiC are described, and other wide bandgap material devices are reviewed. The detection principle and gas response is explained, and the buried channel SiC-FET device is described in detail. Some special phenomena related to the high-temperature influence of hydrogen at high temperature are also reported. 

The importance of recognition chemistry has been highlighted in several of the previous sections. Developments in recognition chemistry are important for the design of in situ sensors and are a high-priority research area. In practice, the surfaces or membranes of any in situ sensing device will contain chemical soecies that interact selectively and reversibly with... 

---