Rugosity

Washouts, rugosity, and drillstring wobbling (or vibration) will affect the LWD density readings. However, the LWD density data are generally suitable for formation evaluation. 

Yerba buena, or Cuban mint, specified in recipes as the mojito s native mint, is peppermint, though die classification is also loosely applied hi Cuba to bergamot and die rugose form of spearmint, according to Dr. Art Tucker from die Department of Agriculture and Natural Resources at Delaware State University. Dr. Tucker is an expert on mint. 

Factors affecting the mix of active ingredients and excipients should be discussed. These should include particle size and shape, rugosity, charge, flow properties, and water content. Since the dose delivery for these products is dependent on air flow characteristics, an attempt should be made to establish an in vivo-in vitro correlation. 

The formulation of this type of product usually employs a small number of ingredients and sometimes only the active ingredient. Particle size and particle size distribution, rugosity, and particle charge should be considered for all ingredients, and the specific grade of excipients should be stated. The excipients should be sourced from a single supplier (with data to demonstrate the suitability of different batches of material), but if multiple sources are used, additional data will be required to establish the suitability of different batches from each supplier. 

There are substantial changes in fiber surface area with associated variations in rugosity depending on the oxidative treatment medium. 

I just love those imbricated ophite petals Incidentally, H. R Lovecraft also enjoyed using unfamiliar adjectives like eldritch, rugose, cyclopean, and squamous. ... 

Tubing should be supplied with a material certification sheet for material construction and rugosity and be precleaned and capped. Handle material in such a way as to prevent introduction of contaminants into the piping system. 

Vouyoucalos (V7), 1961 Experimental study of absorption and desorption of S02 by water film in channel of 10 X 40 cm., slope 25°. Channel floor covered with regular transverse rugosities of large dimensions. Also dye-tracer studies of flow patterns, wave profiles. 

For instance, a high porosity can increase the extent of adsorption of certain molecules, but at the same time, the internal surface of the pores is not fully irradiated so that the density of photoproduced active species inside the pores can be lower than on the external surface. Photons are not only absorbed but also reflected and scattered by the semiconducting particles, whether they are in the form of powders or films. Consequently, the texture, surface rugosity, and agglomeration of particles affect the fraction of photons that are absorbed and therefore are potentially useful for photocatalytic chemical transformations. In addition, scattering depends on the refractive index of the medium and is therefore very different depending on whether Ti02 is exposed to air or liquid water. 

Perimeter, Hausner shape factors, Martins diameter, Feret diameter, two dimensional sphericity, rugosity. 

Typically, PAN attacks spongy mesophyll tissue surrounding the substomatal chambers on the lower side of the leaf. When tissue immediately beneath the lower epidermis is killed, the epidermis dries, producing a glazed or bronzed appearance on the lower leaf surface. Usually there is no evidence of injury on the upper surface when the glazed or bronze symptom develops. Later, as the upper part of the leaf continues to grow, it cups downward, becomes rugose, and distorted. 

The first coefficients (2higher order are related to its rugosity. C0 gives the average radius of the particle and C, the error in the definition of the position of the centroid [81,88]. 

Fractal dimension is used to give information on rugosity at the microscopic level of details. Different algorithms are available. In the Richardson s walk [91],... 

Fig. 31. Visualization of 3D shape by visual texture rugose (a) and smooth (b) surfaces c young and d old P. roqueforti colonies...

Rugosity and porosity give rise to the so-called constant phase element (CPE), which can be described by groups of parallel or branched transmission lines. The CPE is manifested in real systems by an impedance spectrum altered from the expected shape, especially in the... 

Rugosity as ratio between total volume/total surface... 

---