Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Replacement evaluation

In Section IV we considered a categorical performance metric y. Although that represents a common practice, especially when y defines the quality of a product or process operation, there are many instances where system performance is measured by a continuous variable. Even when y is quality-related, it is becoming increasingly clear that explicit continuous quality cost models should be adopted and replace evaluations of performance based on categorical variables. [Pg.117]

The results of in vitro experiments, however, are important in alerting the toxicologist to potential toxic effects that may be expected in whole animals, or indicating the likely potency of the chemical. They might show that a potential drug is not worth further development, perhaps in comparison with others being developed. For these reasons, the use of in vitro tests will increase in the safety evaluation of all chemicals. But in vitro tests cannot replace evaluation of the effect of a chemical on the whole animal, where possible adverse effects to each organ and system, and the interactions between them, are studied. As we shall see later in the chapter, this is necessary for risk assessment, where the toxic effect that occurs at the lowest dose level in vivo is used. [Pg.296]

Refrigeration, cost of 811, 815 Regression analysis, 759-765 Renf cost of 205, 210 Repairs, cost of 203, 210, 269-270 Replacement evaluation, 329-336 Replacement value, definition of 277 Reports ... [Pg.907]

T. Nakamura, T. Yamamuro, S. Higashi, T. Kokubo and S. Ito (1985) A New Glass-Ceramic for Bone Replacement Evaluation of its Bonding to Bone Tissue, J. Biomed. Maters Res. 19, 685-698. [Pg.357]

A mudlog provides only qualitative information, hence it is unsuitable for an accurate formation evaluation. Mudlogging is therefore nowadays partly replaced by logging while drilling techniques (LWD) which will be covered in Section 5.3. [Pg.27]

Evaluation data taken from the more than 8 thousand reports of the laboratory and field wire ropes inspections show that the visual methods and life time criteria are non adequate to real durability of the ropes in service [4]. The data show that only a very small percentage of all ropes was replaced in a proper time, when one has used a visual inspection. [Pg.334]

The rotational energy of a rigid molecule is given by 7(7 + l)h /S-n- IkT, where 7 is the quantum number and 7 is the moment of inertia, but if the energy level spacing is small compared to kT, integration can replace summation in the evaluation of Q t, which becomes... [Pg.583]

The evaluation of the integral in equation (A3.11.35) needs to be done carefiilly as there is a pole at /d = k. A standard trick to do it involves replacing k by /r+ie where e is a small positive constant that will be set to zero in the end. This reduces equation (A3.11.35) to... [Pg.966]

The particle can be assumed to be spherical, in which case M/N can be replaced by (4/3)ttR P2, and f by 671770R- In this case the radius can be evaluated from the sedimentation coefficient s = 2R (p2 - p)/9t7o. Then, working in reverse, we can evaluate M and f from R. These quantities are called, respectively, the mass, friction factor, and radius of an equivalent sphere, a hypothetical spherical particle which settles at the same rate as the actual molecule. [Pg.638]

In the next section we shall pursue the scattering by fluctuations in density. In the case of solutions of small molecules, it is the fluctuations in the solute concentration that plays the equivalent role, so we shall eventually replace 6p by 6c2. First, however, we must describe the polarizability of a density fluctuation and evaluate 6p itself. [Pg.679]

It is the net intensity, not the electric field, which concerns us. We previously used the fact that intensity is proportional to E to evaluate i. Using complex numbers to represent E requires one slight modification of this procedure. In the present case we must multiply E by its complex conjugate -obtained by replacing / 1 by to evaluate intensity ... [Pg.696]

There is no combination of chemical or physical analyses which can, or is ever likely to, replace human sensory evaluation completely. Sensory examination of wines employs two major approaches detecting differences and evaluating quaUty or, more briefly, analytical and hedonic (16,19). The former can be objective and the latter is inevitably somewhat subjective regardless of the expertise of the judges. [Pg.369]

Other Models for Mass Transfer. In contrast to the film theory, other approaches assume that transfer of material does not occur by steady-state diffusion. Rather there are large fluid motions which constantiy bring fresh masses of bulk material into direct contact with the interface. According to the penetration theory (33), diffusion proceeds from the interface into the particular element of fluid in contact with the interface. This is an unsteady state, transient process where the rate decreases with time. After a while, the element is replaced by a fresh one brought to the interface by the relative movements of gas and Uquid, and the process is repeated. In order to evaluate a constant average contact time T for the individual fluid elements is assumed (33). This leads to relations such as... [Pg.23]

Life cycle cost analysis is the proper tool for evaluation of alternative systems (11,12). The total cost of a system, including energy cost, maintenance cost, interest, cash flow, equipment replacement and/or salvage value, taxes, inflation, and energy cost escalation, can be estimated over the useflE life of each alternative system. A Hst of life cycle cost items which may be considered for each system is presented in Tables 3 and 4. Reference 14 presents a cash flow analysis which also includes factors such as energy cost escalation. [Pg.363]

Textiles. A unique combination of desirable quaUties and low cost accounts for the demand for acetate ia textiles. In the United States, acetate and triacetate fibers are used ia tricot-knitting and woven constmctions, with each accounting for approximately half the total volume. This distribution changes slightly according to market trends. The main markets are women s apparel, eg, dresses, blouses, lingerie, robes, housecoats, ribbons, and decorative household appHcations, eg, draperies, bedspreads, and ensembles. Acetate has replaced rayon filament ia liner fabrics for men s suits and has been evaluated for nonwoven fabrics (79—81). [Pg.299]

Residue Hea.tup. Equations 27—30 can be used to estimate the time for residue heatup, by replacing the Hquid properties, such as density and heat capacity, with residue properties, and considering the now smaller particle in evaluating the expressions for ( ), and T. In the denominator of T, 0is replaced by and is replaced by T the ignition temperature of the residue. [Pg.56]

These rosin-based sizes, whether paste, Hquid, or emulsions, can be used to size all grades of paper that are produced at acid pH. The latter include bleached or unbleached kraft Hnerboard and bag paper, bleached printing and writing grades, and cylinder board. In addition, polyaluminum compounds have been used in place of alum, most notably, polyaluminum chloride (48), which can reduce barium deposits where these have been a problem. The barium chloride by-product is more water-soluble than barium sulfate. Other polyaluminum compounds such as polyhydroxylated forms of alum and polyaluminum siHcosulfate have been evaluated as alum replacements. [Pg.18]

MicrobaUoons have been used for gap filling, where the spheres dampen sound or vibration in the stmcture. In the medical area, microbaUoons have been evaluated as a skin replacement for bum victims and phantom tissue for radiation studies. An important appHcation is in nitroglycerin-based explosives, in which microbaUoons permit a controUed sequential detonation not possible with glass spheres. [Pg.308]

A fermented-egg product (EEP), patented as an attractive bait for synanthropic flies, has been shown to be attractive to coyotes and repeUent to deer (79). Its components are variable, with relative concentrations of 77% fatty acids, 13% bases, and 10% (primarily) neutrals composed of at least 54 volatiles such as ethyl esters, dimethyl disulfide, and 2-mercaptoethanol. Synthetic formulations have been evaluated to find a replacement for a patented fermented-egg protein product that attracts coyotes and repels deer. Ten aUphatic acids (C-2 to C-8), four amines (pentyl, hexyl, heptyl, and trimethyl), dimethyl disulfide, 2-mercaptoethanol, and 54 more volatiles (C-1 to C-5 esters of C-1 to C-8 acids) have been tested as synthetic fermented egg (SEE) (80) in approximately the same proportions that are present in EEP. Weathering was a problem that caused decreased efficacy, which suggests trials of controUed-release formulations. Eourteen repeUents have been examined against white-taU deer in Peimsylvania in choice tests when treated onto sheUed com (81). [Pg.121]


See other pages where Replacement evaluation is mentioned: [Pg.243]    [Pg.243]    [Pg.31]    [Pg.1809]    [Pg.326]    [Pg.428]    [Pg.461]    [Pg.2]    [Pg.145]    [Pg.85]    [Pg.645]    [Pg.237]    [Pg.173]    [Pg.116]    [Pg.612]    [Pg.638]    [Pg.231]    [Pg.360]    [Pg.285]    [Pg.427]    [Pg.470]    [Pg.236]    [Pg.267]    [Pg.123]    [Pg.150]    [Pg.350]    [Pg.317]    [Pg.467]    [Pg.265]    [Pg.272]   
See also in sourсe #XX -- [ Pg.329 , Pg.330 , Pg.331 , Pg.332 , Pg.333 , Pg.334 , Pg.335 ]




SEARCH



© 2024 chempedia.info