Reason, light

We also use small rechargeable batteries to power cell phones and portable computers. They are reasonably light and have the capacity to go for some hours before requiring recharging, but improvements are still needed. As chemists and chemical engineers develop better battery technology we can expect to be freed... 

It should be noticed that linear polymers DGEBA/HA or DGEBA/DMHMDA lead to very brittle samples for this reason lightly crosslinked systems were used instead. 

Once again, the experiments are best done on overcoated polymer films where the overcoatitig consists of a thin layer of sensitive photoconductor so that CV0 of charge can be photogenerated with reasonable light intensity values. 

Therefore, the ring polymer collapses into a single point Ri. This is the classical limit (p=l). In this case, the classical description is reasonable. Light nuclei, such as protons have relatively longer thermal wave lengths than those for heavier nuclei. Therefore, it is desirable to describe them quantum mechanically, especially at low temperatures. Usually, a large but limited p is enough to describe such systems. [9,78,80]... 

FIGM NT5 must be insoluble and reasonably light-fast. They are prepared for use by grinding finely into a paste with a little water using a glass muller on a glass surfiace Of coarse, grind in a pesde and mortar first). For oil paint use oil instead oi water. 

Properties Good resistance to bleeding, reasonable light resistance, good transparency. Produces inks with good flow. 

SIT ISIT. Can tolerate a reasonable light flux without any substantially adverse effects. However, precautions are necessary to avoid actual damage to the photocathode. 

Cq thus increases as the well fills up and W decreases. Before the well fills up, if (2ee5N ) /Co <(KG), then the oxide capacitance will be much larger than the depletion layer capacitance and (f) will track Vq. For this reason lightly doped material and thin gate oxide layers ( 1000 A) are needed. Examination of (6.1) also shows that barriers can be permanently built into the device by varying and/or by changing the oxide thickness (which changes C ). These techniques are used to form channel stops to define the CCD channel and can also be used to provide the built-in barriers necessary for two-phase CCD operation. 

---