Radical stoichiometric yield

Fenton Reagent The interaction of H2O2 with Fe(II) yields OH radicals stoichiometrically ... 

Liquid-phase chlorination of butadiene in hydroxyhc or other polar solvents can be quite compHcated in kinetics and lead to extensive formation of by-products that involve the solvent. In nonpolar solvents the reaction can be either free radical or polar in nature (20). The free-radical process results in excessive losses to tetrachlorobutanes if near-stoichiometric ratios of reactants ate used or polymer if excess of butadiene is used. The "ionic" reaction, if a small amount of air is used to inhibit free radicals, can be quite slow in a highly purified system but is accelerated by small traces of practically any polar impurity. Pyridine, dipolar aptotic solvents, and oil-soluble ammonium chlorides have been used to improve the reaction (21). As a commercial process, the use of a solvent requites that the products must be separated from solvent as well as from each other and the excess butadiene which is used, but high yields of the desired products can be obtained without formation of polymer at higher butadiene to chlorine ratio. 

In spirooxaziridines like (114), /3-scission proceeds with ring opening. Stoichiometric amounts of iron(II) salt in acidic solution lead to the dicarboxylic acid derivative (115). The radical undergoes some interesting reactions with added unsaturated compounds. For example, pyridine yields a mixture of 2- and 4-alkylation products in 80% yield. Catalytic amounts of iron(II) ion are sufficient here since the adduct of the radical with pyridine is oxidized by iron(III) ion to the final product (116), thus regenerating iron(II) ion (68TL5609). 

Stronger reducing agents than Cu1 can be used for reactions that are related to the classical Meerwein reaction. Tim salts not only catalyze the formation of aryl radicals from diazonium ions but, as shown by Citterio and Vismara (1980) and Cit-terio et al. (1982 a), in stoichiometric proportions they also reduce the primary aryl-ethane radical to the arylethyl anion, which is finally protonated by the solvent SH (Scheme 10-61). This method is the subject of a contribution to Organic Syntheses (Citterio, 1990), in which 4-(4 -chlorophenyl)buten-2-one is obtained in 65-75% yield from 4-chlorobenzenediazonium chloride and but-3-en-2-one. 

A completely different method of synthesis of azo compounds from diazonium salts involving radical intermediates was found by Citterio et al. (1980, 1982 c), Cit-terio and Minisci (1982), and Fontana et al. (1988). It is a new general synthesis of arylazoalkanes based on the addition of an alkyl radical to an arenediazonium ion followed by reduction of the intermediate azo radical cation adduct by a metal salt (Scheme 12-80). The preferred source for the alkyl radical R in this reaction is an alkyl iodide, which gives rise to alkyl radicals cleanly in the presence of an arenediazonium salt and a Ti3+ or Fe2+ salt as in Scheme 12-81. The overall stoichiometric equation is therefore as given in Scheme 12-82. The yields vary between 36% and 79% (with respect to alkyl iodide). 

The number of reported reactions in which the radical derived from the decomposition of AIBN plays a role in the termination process has increased considerably. Often these reactions are not radical chain reactions, since the initiator is used in stoichiometric amounts. A few examples of rearomatization of cyclohexadienyl radicals by disproportionation have been reported herein. Below are some other examples, where the phenyl selenide 61 reacts with (TMSfsSiH (3 equiv), AIBN (1.2 equiv) in refluxing benzene for 24 h to give the coupling product of radicals 63 and 64 in good yields (Scheme 9).i24,i25 these cases,... 

HO-oxidation of an individual NMHCj produces H02 radicals with a yield aj, and oxidation of the NMHC oxidation product produces H02 in stoichiometric amount The lumped coefficients or yields a and p need not be integers, and represent the effectiveness of a particular NMHCj in producing RO2. and H02 radicals (lumped together as HO2) that will then oxidize NO. to N02 in processes such as R6 and R13, producing one net ozone molecule each. Alternatively, when the NO. concentration is low, peroxyl radicals may form PAN (as in R22) or hydrogen peroxide (as in R33) which are other oxidant species. In this formulation, transport is expressed by an overall dilution rate of the polluted air mass into unpolluted air with a rate constant (units = reciprocal time dilution lifetime=1// ). This rate constant includes scavenging processes such as precipitation removal as well as mixing with clean air. 

Sheldon et al. have combined a KR catalyzed by CALB with a racemization catalyzed by a Ru(II) complex in combination with TEMPO (2,2,6,6-tetramethylpi-peridine 1-oxyl free radical) [28]. They proposed that racemization involved initial ruthenium-catalyzed oxidation of the alcohol to the corresponding ketone, with TEMPO acting as a stoichiometric oxidant. The ketone was then reduced to racemic alcohol by ruthenium hydrides, which were proposed to be formed under the reaction conditions. Under these conditions, they obtained 76% yield of enantiopure 1-phenylethanol acetate at 70° after 48 hours. 

Different yields, mainly of the oxidizing species, were found by Koulkes-Pujo and Berthou who studied the system Fe /DMSO in the presence of high concentration of H2SO4. They found that the yields of the primary species in acidic media are Gh = 2.1 + 0.3 and Gqx (for the oxidizing species) = 3.8 + 0.4. These results are supported by studies of the system Ce /DMSO in the presence of H2SO4 . Assuming that the radicals have stoichiometric equivalence to those found in water-DMSO mixtures, we may write the observed G(-Ce ) = 13.9 + 0.4 as equal to = 3Gqx + Gh = 13.5. The difference between the yields in acidic media and for pure DMSO is due to reaction of H with the precursors of these species. 

Catalytic turn-over [59,60] in McMurry couplings [61], Nozaki-Hiyama reactions [62,63], and pinacol couplings [64,65] has been reported by Fiirst-ner and by Hirao by in situ silylation of titanium, chromium and vanadium oxo species with McaSiCl. In the epoxide-opening reactions, protonation can be employed for mediating catalytic turn-over instead of silylation because the intermediate radicals are stable toward protic conditions. The amount of Cp2TiCl needed for achieving isolated yields similar to the stoichiometric process can be reduced to 1-10 mol% by using 2,4,6-collidine hydrochloride or 2,6-lutidine hydrochloride as the acid and Zn or Mn dust as the reduc-tant (Scheme 9) [66,67]. 

In the presence of zinc chloride, stereoselective aldol reactions can be carried out. The aldol reaction with the lithium enolate of /-butyl malonate and various a-alkoxy aldehydes gave anti-l,2-diols in high yields, and 2-trityloxypropanal yielded the syn-l,2-diol under the same conditions.633 Stoichiometric amounts of zinc chloride contribute to the formation of aminoni-tropyridines by direct amination of nitropyridines with methoxyamine under basic conditions.634 Zinc chloride can also be used as a radical initiator.635... 

Recently, the iron-promoted Barbier-type addition of alkyl halides to aromatic aldehydes has been reported (Equation (26)).326 According to the proposed mechanism, the initial step is the formation of an alkyl radical, which can be reduced to the corresponding carbanion. This carbanion nucleophile can react, while coordinated to the iron pentacarbonyl complex, with the corresponding aldehyde. This stoichiometric method is limited with respect to substrate scope and yield. The same authors have also developed the Reformatsky-type addition of cr-halosub-stituted carbonitriles to aldehydes and ketones in the presence of iron pentacarbonyl.3... 

As in the reductive ring-opening, titanocene—oxygen bonds have to be protonated. Here, a titanium enolate, which is generated after reductive trapping of an enol radical, has to be protonated, in addition to a simple titanocene alkoxide. As before, 2,4,6-collidine hydrochloride constitutes a suitable acid to achieve catalytic turnover, but here zinc dust turned out to be the reductant of choice [31c], The features of the stoichiometric reaction are preserved under our conditions. Acrylates and acrylonitriles are excellent radical acceptors in these reactions. Methyl vinyl ketone did not yield the desired addition product. Under the standard reaction conditions, a-substituted acceptors are readily tolerated, but (3-substitution gives the products only in low yields. 

The hexahydro-l//-pyrrolo[2,l-f][l,4]oxazin-l-one 82 (obtained by radical cyclization see Section 11.11.7.3) was transformed into the proline derivative 83 by hydrogenation in the presence of the Pearlman s catalyst and a stoichiometric amount of trifluoroacetic acid (TFA) (Scheme 10). This reaction led with high yield to the disub-stituted proline 83 in an enantiomerically pure form <2003SL1058>. In an analogous approach, the chiral (4/ ,7/ ,8aA)-methyl 6,6-dimethyl-l-oxo-4-phenylhexahydro-l//-pyrrolo[2,l-r-][l,4]oxazine-7-carboxylate 84 was hydrogenated on Pd(OH)2 in the presence of TFA to give enantiomerically pure 5,5-dimethylproline derivatives 85 <2001SL1836> (Scheme 10). 

Tris[(2-perfluorohexyl)ethyl]tin hydride has three perfluorinated segments with ethylene spacers and it partitions primarily (> 98%) into the fluorous phase in a liquid-liquid extraction. This feature not only facilitates the purification of the product from the tin residue but also recovers toxic tin residue for further reuse. Stoichiometric reductive radical reactions with the fluorous tin hydride 3 have been previously reported and a catalytic procedure is also well established. The reduction of adamantyl bromide in BTF (benzotrifluoride) " using 1.2 equiv of the fluorous tin hydride and a catalytic amount of azobisisobutyronitrile (AIBN) was complete in 3 hr (Scheme 1). After the simple liquid-liquid extraction, adamantane was obtained in 90% yield in the organic layer and the fluorous tin bromide was separated from the fluorous phase. The recovered fluorous tin bromide was reduced and reused to give the same results. Phenylselenides, tertiary nitro compounds, and xanthates were also successfully reduced by the fluorous fin hydride. Standard radical additions and cyclizations can also be conducted as shown by the examples in Scheme 1. Hydrostannation reactions are also possible, and these are useful in the techniques of fluorous phase switching. Carbonylations are also possible. Rate constants for the reaction of the fluorous tin hydride with primary radicals and acyl radicals have been measured it is marginally more reactive than tributlytin hydrides. ... 

This reaction is based on a stoichiometric reaction of multifunctional olefins (enes) with thiols. The addition reaction can be initiated thermally, pho-tochemically, and by electron beam and radical or ionic mechanism. Thiyl radicals can be generated by the reaction of an excited carbonyl compound (usually in its triplet state) with a thiol or via radicals, such as benzoyl radicals from a type I photoinitiator, reacting with the thiol. The thiyl radicals add to olefins, and this is the basis of the polymerization process. The addition of a dithiol to a diolefin yields linear polymer, higher-functionality thiols and alkenes form cross-linked systems. 

The results summarised in Table 4 show clearly that good yields of the 1 1 Michael adducts can be obtained in cathodically initiated reactions. It is not clear, however, why the reaction should fail for acrylonitrile even if dimerisation of the initially formed radical-anion is much faster thaq,protonation the resulting dimeric dianion should still be sufficiently basic to deprotonate dialkylmalonate esters. A feature of especial significance is the usefulness of esters of ethenetetracarboxylic acid. Apart from their use in EGB catalysed reactions they have been much used in stoichiometric amount. 

The stoichiometric oxidation of alkenes by Mn(OAc)3 in acetic acid at 120 °C affords 7-lactones n good yield, via the homolytic addition of carboxymethyl radical to the double bond (equations 104 and 205).504-506... 

---