Pyridines Grignard reagents from

When the additional nitrogen atom is included in one of the aromatic rings, on the other hand, there is obtained a compound with antihistaminic properties. Reaction of the Grignard reagent from 4-chlorobromobenzene with pyridine-2-aldehyde gives the benzhydrol analog (12). The alcohol is then converted to its sodium salt by means of sodium, and this salt is alkylated with W-C2-chloroethyl)dimethylamine. Carbinoxamine (13) is thus obtained. ... 

Apart from the technical route described to p-apo-8 -carotenal, readily available vitamin A alcohol (Cjo) has served as an intermediate in the form of the phosphonium salt by reaction with the monodiethyl acetal of a Cio dial (ref. 54). The required Cjo monodiethylacetal was obtained (ref.5, p409) by the reaction of the mono aldehyde-protected derivative, the enol ether of methylmalonaldehyde, (C4) with the acetylenic Grignard reagent from trans 3-methyl-2-penten-4-yn-l-ol (C ) followed by acidic dehydration and partial reduction with Lindlar catalyst to give firstly 8-hydroxy-2,6-dimethylocta-2, 4,6-triene-l-al (Cio). Protection of the hydroxyl group by acetylation in pyridine solution with acetyl chloride and formation of the diethyl acetal with ethyl orthoformate followed by hydrolysis of the acetyl group and oxidation afforded the final CIO aldehyde component (D)shown in Scheme 15a. 

Grignard reagent comes from the substitution products it gives with various reactive substrates. When the low-temperature adduct is heated in an autoclave at 90 to 170 C for 3 to 6 hr, it does not rearrange to 2-ethylthiazole (12) as is the case in the pyridine series (436). 

The addition of Grignard reagents to aldehydes, ketones, and esters is the basis for the synthesis of a wide variety of alcohols, and several examples are given in Scheme 7.3. Primary alcohols can be made from formaldehyde (Entry 1) or, with addition of two carbons, from ethylene oxide (Entry 2). Secondary alcohols are obtained from aldehydes (Entries 3 to 6) or formate esters (Entry 7). Tertiary alcohols can be made from esters (Entries 8 and 9) or ketones (Entry 10). Lactones give diols (Entry 11). Aldehydes can be prepared from trialkyl orthoformate esters (Entries 12 and 13). Ketones can be made from nitriles (Entries 14 and 15), pyridine-2-thiol esters (Entry 16), N-methoxy-A-methyl carboxamides (Entries 17 and 18), or anhydrides (Entry 19). Carboxylic acids are available by reaction with C02 (Entries 20 to 22). Amines can be prepared from imines (Entry 23). Two-step procedures that involve formation and dehydration of alcohols provide routes to certain alkenes (Entries 24 and 25). 

Aluminum-free titanocene-methylidene can be generated by thermolysis of titana-cyclobutanes 6, which are prepared by reaction of the Tebbe reagent with appropriate olefins in the presence of pyridine bases [9]. Alternatively, the titanacyclobutanes are accessible from titanocene dichloride and bis-Grignard reagents [10] or from 71-allyl titanocene precursors [11]. The a-elimination of methane from dimethyltitanocene 7 provides a convenient means of preparing titanocene-methylidene under almost neutral conditions [12] (Scheme 14.5). 

While chlorosilanes are susceptible to hydrolysis, aryltrialkoxysilanes are not Treating the Grignard reagent generated from aryl bromide 127 with SiCL, then with a solution of pyridine in methanol furnished aryltrimethoxysilane 128 [104], Subsequent Pd-catalyzed coupling between 128 and 3-bromopyridine assembled biaryl 129 in 72% yield with the aid of TBAF. 

An asymmetric synthesis of 1,2-dihydropyridines has been achieved by the addition of Grignard reagents to the pyridinium salt generated from 3-(triisopropylstannyl)pyridine and the chloroformate of 8-arylmenthyl based chiral auxiliaries (Scheme 22) (91JOC7167). 

An improved route to the key intermediate 326 was also developed (165). Namely, 322 was converted to the monoprotected 1,4-dione 327 by sequential addition of the Grignard reagent derived from 2-(2-bromoethyl)-2-methyl-l,3-dioxolane followed by oxidation of the resulting benzylic alcohol with pyridin-ium dichromate (PDC). The ketone 327 was then smoothly transformed to the 2-azadiene 328 by olefination with BAMP. The regioselective addition of n-butyllithium to 328 as before followed by alkylation of the resulting metalloenamine with benzyl A-(2-bromoethyl)-A-methylcarbamate and acid-catalyzed hydrolysis furnished 325, which was converted to the cyclohexenone 326 by base-induced cycloaldolization and dehydration. 

---