Pyridine ring reduction

However, the reaction always led to some overreduction of the pyridine ring. Reduction with BH /THF was unsuccessful. However, NaBH /BF2 Et20 proved to be an excellent reagent for the reduction step, resulting in the formation of the desired polymer. The polymer was shown by UV and NMR spectroscopy to be 67% functionalized primarily with 4-pyrrolidinopyridine moieties by UV and NMR spectroscopy according to these data no starting polymer is present anymore, and the nature of the remaining 23% of functionalization is unknown. 

Reduction. Quinoline may be reduced rather selectively, depending on the reaction conditions. Raney nickel at 70—100°C and 6—7 MPa (60—70 atm) results in a 70% yield of 1,2,3,4-tetrahydroquinoline (32). Temperatures of 210—270°C produce only a slightly lower yield of decahydroquinoline [2051-28-7]. Catalytic reduction with platinum oxide in strongly acidic solution at ambient temperature and moderate pressure also gives a 70% yield of 5,6,7,8-tetrahydroquinoline [10500-57-9] (33). Further reduction of this material with sodium—ethanol produces 90% of /ra/ j -decahydroquinoline [767-92-0] (34). Reductions of the quinoline heterocycHc ring accompanied by alkylation have been reported (35). Yields vary widely sodium borohydride—acetic acid gives 17% of l,2,3,4-tetrahydro-l-(trifluoromethyl)quinoline [57928-03-7] and 79% of 1,2,3,4-tetrahydro-l-isopropylquinoline [21863-25-2]. This latter compound is obtained in the presence of acetone the use of cyanoborohydride reduces the pyridine ring without alkylation. 

Reduction of isoindoles with dissolving metals or catalytically occurs in the pyrrole ring. Reduction of indolizine with hydrogen and a platinum catalyst gives an octahydro derivative. With a palladium catalyst in neutral solution, reduction occurs in the pyridine ring but in the presence of acid, reduction occurs in the five-membered ring (Scheme 38). Reductive metallation of 1,3-diphenylisobenzofuran results in stereoselective formation of the cw-1,3-dihydro derivative (Scheme 39) (80JOC3982). 

The formation of cotar none from cotar nine methine methiodide by the action of potash (IX—X) led Roser to represent cotarnine and its salts by the following formulae, the loss of a molecule of water in the formation of cotarnine salts being explained by the production of a partially reduced pyridine ring, which is fully hydrogenated in the reduction of cotarnine to hydrocotarnine. In the reverse process, oxidation of liydrocotarnine to cotarnine, Roser assumed the scission of the ring at the point indicated, with the formation of a hydration product, and oxidation of the latter to cotarnine thus —... 

Hydrogenation of the pyridine ring in the reduction of 2-amino-j3yrido[2,3-d]pyrimidin-4 3/7)-one was proved by synthesis. ... 

A thioamide of isonicotinic acid has also shown tuberculostatic activity in the clinic. The additional substitution on the pyridine ring precludes its preparation from simple starting materials. Reaction of ethyl methyl ketone with ethyl oxalate leads to the ester-diketone, 12 (shown as its enol). Condensation of this with cyanoacetamide gives the substituted pyridone, 13, which contains both the ethyl and carboxyl groups in the desired position. The nitrile group is then excised by means of decarboxylative hydrolysis. Treatment of the pyridone (14) with phosphorus oxychloride converts that compound (after exposure to ethanol to take the acid chloride to the ester) to the chloro-pyridine, 15. The halogen is then removed by catalytic reduction (16). The ester at the 4 position is converted to the desired functionality by successive conversion to the amide (17), dehydration to the nitrile (18), and finally addition of hydrogen sulfide. There is thus obtained ethionamide (19)... 

The key intermediate 21 is in principle accessible in any of several ways. Thus reaction of thiophenecarbox-aldehyde with amninoacetal would lead to the Schiff base 20 treatment with acid would result in formation of the fused thiophene-pyridine ring (21). Alkylation of that intermediate with benzyl chloride gives the corresponding ternary imini urn salt 23. Treatment with sodium borohydride leads to reduction of the quinolinium ring and thus formation of ticlopidine (24). ... 

After reduction of the nitro function of the porphyrin, the porphyrinamine intermediate can be reacted with z./l-unsaturated carbonyl compounds to yield porphyrins with a fused pyridine ring, which is formed by Michael addition, imine formation and dehydrogenation. 

Compared with monocyclic aromatic hydrocarbons and the five-membered azaarenes, the pathways used for the degradation of pyridines are less uniform, and this is consistent with the differences in electronic structure and thereby their chemical reactivity. For pyridines, both hydroxylation and dioxygenation that is typical of aromatic compounds have been observed, although these are often accompanied by reduction of one or more of the double bonds in the pyridine ring. Examples are used to illustrate the metabolic possibilities. 

Another classic reaction of pyridinium salts is reduction of the pyridine ring. Donohoe and co-workers reported the partial reduction of A-alkylpyridinium salts <060BC1071>, which is accompanied by subsequent alkylation and hydrolysis to furnish a range of 2,3-dihydropyrid-4-ones. This sequence has the potential to introduce a variety of functional groups at the C-2 position of 2,3-dihydropyrid-4-ones. Reduction of pyridinium ylides with sodium borohydride has also been reported in fair to good yields <06JHC709>. 

Moderate to good enantioselectivities were obtained for nearly all examples, but the products from 83a-c could be recrystallized to higher enantiomeric purity. Addition of iodine was critical for catalysis as was the use of a ligand with electron-poor para-fluorophenyl groups on the phosphorous atom. Substitution at the 3 position of the pyridine ring was described as being difficult for both the quinolines and pyridine systems. The resulting hydrazine derivatives could be easily converted to piperdines by reduction with Raney nickel or under Birch conditions. 

---