Propane reaction with oxygen atoms

One molecule (or mole) of propane reacts with five molecules (or moles) of oxygen to produce three molecules (or moles) or carbon dioxide and four molecules (or moles) of water. These numbers are called stoichiometric coefficients (v.) of the reaction and are shown below each reactant and product in the equation. In a stoichiometrically balanced equation, the total number of atoms of each constituent element in the reactants must be the same as that in the products. Thus, there are three atoms of C, eight atoms of H, and ten atoms of O on either side of the equation. This indicates that the compositions expressed in gram-atoms of elements remain unaltered during a chemical reaction. This is a consequence of the principle of conservation of mass applied to an isolated reactive system. It is also true that the combined mass of reactants is always equal to the combined mass of products in a chemical reaction, but the same is not generally valid for the total number of moles. To achieve equality on a molar basis, the sum of the stoichiometric coefficients for the reactants must equal the sum of v. for the products. Definitions of certain terms bearing relevance to reactive systems will follow next. 

Cyclopentenes behave differently and often act through radical mechanisms this can lead to photoreduction to cyclopentanes, or photoaddition of the kind exemplified by norborneneand propan-2-ol 12.57). The photoadduct in this process is linked through the carbon atom of the alcohol, and not the oxygen atom. A related addition to acetonitrile 12.58) takes place when norbornene is irradiated in the presence of a silver(i) compound. It is likely thal a metal complex of the alkene is the real irradiation substrate, and the same may be true for copper(i)-promoted additions of haloalkanes to electron-deficient alkenes (2.59). When dichloromelhane is used in such a reaction the product can be reduced electrochemically to a cyclopropane (2.60), which is of value because the related thermal addition of CH.I, to alkenes in the presence of copper does not succeed with electron-poor compounds. 

In 1992 Kobayashi et al. [47] reported the first catalytic and enantioselective cyclo-propanation using the Furukawa modification [48] of the Simmons-Smith reaction of allylic alcohols in the presence of a chiral bis(sulfonamide)-Zn complex, prepared in-situ from the bis(sulfonamide) 63 and diethylzinc. When cinnamyl alcohol 62 was treated with EtgZn (2 equiv.), CHgIg (3 equiv.), and the bis(sulfonamide) 63 (12 mol %) in dichloromethane at -23 °C, the corresponding cyclopropane 64 was obtained in 82 % yield with 76 % ee (Sch. 26). They proposed a transition state XXIII (Fig. 5) in which the chiral zinc complex interacts with the oxygen atom of the allylic alkoxide and the iodine atom of iodomethylzinc moiety. They also reported the use of the bis(sulfonamide)-alkylaluminum complex 65 as the Lewis acidic component catalyzing the Simmons-Smith reaction [49]. 

Figure 3 compares the molecular (left) and acetone (right) TPD data for the reaction of 3.0 L of oxygen (approximately 0.30 ML of O atoms, or 60% of monolayer saturation) with varying amounts of 2-propyl iodide on Ni( 100). A 0.5 L exposure of 2-propyl iodide leads to the desorption of hydrogen, propene and propane, but not acetone, and results in TPD traces quite similar to those obtained from the same 2-C3H7I dose on the clean surface. The onset of acetone formation is seen as a small peak around 350 K only after a 2.0 L alkyl halide dose, and the molecular desorption data shows that monolayer saturation of 2-propyl iodide on this surface occurs between 2.0 and 4.0 L. Notice in particular that the 2.0 L marie corresponds to the point at which all the nickel sites become occupied (see Figure 1). This suggests that, in order for acetone to be produced, a particular surface ensemble is required with the 2-propyl groups adsorbed next to oxygen atoms [19-21].

Ammoxidation refers to the formation of nitriles by oxidation of hydrocarbons with oxygen in the presence of ammonia (Figure 1) [1]. Ammoxidation is best conducted with olefins, or with aromatic or heteroaromatic compounds, containing a readily abstractable H atom (allylic or benzylic intermediates are formed), although the ammoxidation of alkanes (e. g. propane to acrylonitrile [e. g. 2-4] or ethane to acetonitrile [e. g. 5]) is also possible. An exceptional example is the ammoxidation of methane to hydrogen cyanide by the Andrussov reaction [6]. 

The moderately rich flames are similar in mechanism to the lean flames except that the initial attack of the hydrocarbon is predominantly by H atom reaction and the attack of methyl radical is almost certainly by oxygen atoms. In the primary reaction zone of these flames there is usually neither radical recombination nor reaction of radicals with oxygen or oxygen atoms to form oxygenated intermediates. The best evidence for this is that in the study of the propane flame no evidence was found for the forma-... 

Consider the combustion of propane (CsHg). Commonly used as fuel in gas grills, propane (a gas) combines with oxygen (O2, a gas) to form carbon dioxide (CO2, a gas) and water (H2O, a liquid). Because each propane molecule contains three carbon atoms and because carbon dioxide (with one carbon atom) is the only product that contains carbon, each propane molecule that reacts must produce three CO2 molecules. Similarly, the eight hydrogen atoms from each propane molecule should produce four water molecules. These data give ten oxygen atoms in the products (from three CO2 and four H2O molecules), so there must be five O2 molecules in the reactants. Thus, the chemical equation for this reaction is... 

---