Polystyrene purification

Sodium phosphate dibasic dihydrate purification, Cu Calcium phosphide purification, Cu alloys Calcium phosphide purification, enzymes Polystyrene purification, gasoline Potassium phosphate tribasic purification, glucose Sodium acetate anhydrous purification, glycerin Polystyrene purification, hydrogen Copper oxide (ic)... 

The final purification step is drying. The polystyrene leaving this unit must meet the specifications set in the scope (0.03% water). The blower for the hot air entering... 

In the method shown in Figure 9B, a firefly luciferase gene is introduced for sensitive bioluminescent detection of target DNA [5], The luciferase-coding DNA requires no posttranslational modification, and the activity of the luciferase produced can be readily measured in the transcription/translation mixture without prior purification. In this assay system, the digoxigenin-labeled probe is first immobilized to polystyrene wells coated with antidigoxigenin antibody. The target... 

MP borohydride catches one equivalent of the titanium catalyst, while the polystyrene-bound diethanolamine resin (PS-DEAM) can scavenge the remaining titanium catalyst. The borohydride reagent also assists in the reductive animation reaction. Final purification of the crude amine product is achieved with a polystyrene-bound toluene sulfonic acid resin scavenger that holds the amine through an ion exchange reaction, while impurities are washed off. The pure amine can be recovered with methanol containing 2M ammonium hydroxide. 

These polystyrene-based catalysts are effective for the cyanide displacements of 1-bromooctane and 1-chlorooctane, and also for the generation of dichlorocarbene from chloroform and aqueous sodium hydroxide, giving quantitative yields of (2,2-dichlorocyclopropyl)benzene from styrene. The catalysts may be recovered simply by filtering the reaction mixture. Unfunctionalized polystyrene does not catalyse these reactions. As well as improving product purification and catalyst recovery, this approach also avoids... 

Straight chain alkanes from Applied Science, aromatics from Fisher Scientific Company and polystyrene standards from Waters Associates were used without purification for the linear molecular size calibration of the GPC. Since the solubility of the larger alkanes in THF is very low, appproximately 0.2 -1 mg of each standard was dissolved in 50 microliters of the THF for the molecular size calibrations. 

Many other polymeric systems are of interest in polymer LEDs. Polythiophenes have been known for some time but it was not until improved synthetic methods were developed that their potential was realised. The process involves the reaction of the substituted monomer with FeClj in chloroform solution. After polymerisation has occurred the product precipitates and is isolated and washed. Further special purification methods are required to obtain satisfactorily pure materials. One product, of commercial interest, developed by Bayer is poly(ethylenedioxy)thiophene, known as PEDOT (3.110). This product when doped with polystyrene sulfonate, sold as Baytron P, has been found to be effective as a conducting, hole-injecting layer on the ITO electrode. ... 

The nonionic surfactant, nonylphenol deca(oxyethylene glycol) monoether, NP-EO10, supplied by Berol Kemi AB, Stenungsund, Sweden, was of technical grade and used without further purification. The main impurity is free polyethylene oxide. Analysis of the sample gave a polyethylene oxide content of = 3% (4). Note, that polyethylene oxide adsorbs on polystyrene latexes ( ), but a monolayer is reached at solution concentrations that are 10 times the concentration required to obtain a monolayer coverage with NP-EO q. The free polyethylene oxide, therefore, is expected to have negligible influence on the adsorption measurements. 

---