Polymer/carbon, mechanical properties

Keywords Nanodiamonds, carbon nanotubes, graphene, functionalization, polymer nanocomposites, mechanical properties, tribological properties... 

Polymers used for seat and plug seals and internal static seals include PTFE (polytetrafluoroeth ene) and other fluorocarbons, polyethylene, nylon, polyether-ether-ketone, and acetal. Fluorocarbons are often carbon or glass-filled to improve mechanical properties and heat resistance. Temperature and chemical compatibility with the process fluid are the key selec tion criteria. Polymer-lined bearings and guides are used to decrease fric tion, which lessens dead band and reduces actuator force requirements. See Sec. 28, Materials of Construction, for properties. 

The mechanical properties of plastics materials may often be considerably enhanced by embedding fibrous materials in the polymer matrix. Whilst such techniques have been applied to thermoplastics the greatest developents have taken place with the thermosetting plastics. The most common reinforcing materials are glass and cotton fibres but many other materials ranging from paper to carbon fibre are used. The fibres normally have moduli of elasticity substantially greater than shown by the resin so that under tensile stress much of the load is borne by the fibre. The modulus of the composite is intermediate to that of the fibre and that of the resin. 

Composite structures that consist of carbon particles and a polymer or plastic material are useful for bipolar separators or electrode substrates in aqueous batteries. These structures must be impermeable to the electrolyte and electrochemical reactants or products. Furthermore, they must have acceptable electronic conductivity and mechanical properties. The physicochemical properties of carbon blacks, which are commonly used, have a major effect on the desirable properties of the conductive composite structures. Physicochemical properties such as the surface... 

The mechanical properties of X depend partly on the length of the oli-goethyleneoxy groups. The polymers are solid for x=l, highly viscous gums for x=3 and elastomers for x=7.2. The maximum conductivity of these complexes at 30 °C are reported in Table 16. Gel electrolytes have also been obtained by adding propylene carbonate (PC) (10-50 wt%) to these polynorbornene de-... 

Although polymers in-service are required to be resistant toward hydrolysis and solar degradation, for polymer deformulation purposes hydrolysis is an asset. Highly crystalline materials such as compounded polyamides are difficult to extract. For such materials hydrolysis or other forms of chemolysis render additives accessible for analysis. Polymers, which may profitably be depolymerised into their monomers by hydrolysis include PET, PBT, PC, PU, PES, POM, PA and others. Hydrolysis occurs when moisture causes chain scissions to occur within the molecule. In polyesters, chain scissions take place at the ester linkages (R-CO-O-R ), which causes a reduction in molecular weight as well as in mechanical properties. Polyesters show their susceptibility to hydrolysis with dramatic shifts in molecular weight distribution. Apart from access to the additives fraction, hydrolysis also facilitates molecular characterisation of the polymer. In this context, it is noticed that condensation polymers (polyesters, -amides, -ethers, -carbonates, -urethanes) have also been studied much... 

Stretching a polymer in two perpendicular directions, either successively or by blowing a bubble of molten material, leads to its biaxial orientation, which strongly improves mechanical properties in the stretching directions and/or gas permeability (e.g., biaxial orientation of polypropylene leads to BOPP (for biaxially oriented polypropylene) or biaxial orientation of poly(ethylene terephthalate) gives CC>2-impermeable bottles for carbonated beverages.) (Characterisation methods for determining molecular orientation are considered in Chapter 8.)... 

---