Polymers aggregation

However, the free acid quickly starts to condense with itself, accompanied by the elimination of water to form dimers, trimers and eventually polymeric silicic acid. The polymer continues to grow, initially forming polymer aggregates and then polymer spheres, a few Angstroms in diameter. These polymeric spheres are termed the primary particles of silica gel and must not to be confused with the macro-particles of silica gel that are packed into the LC column. 

These additives reduce the friction between the polymer aggregates or crystallites and also lower the adhesion between the polymer melt and metal surfaces (which occurs in rollers, extruders). This results in ... 

Nguyen TQ, Doan V, Schwartz BJ (1999) Conjugated polymer aggregates in solution control of interchain interactions. J Chem Phys 110 4068-4078... 

Then we address the dynamics of diblock copolymer melts. There we discuss the single chain dynamics, the collective dynamics as well as the dynamics of the interfaces in microphase separated systems. The next degree of complication is reached when we discuss the dynamic of gels (Chap. 6.3) and that of polymer aggregates like micelles or polymers with complex architecture such as stars and dendrimers. Chapter 6.5 addresses the first measurements on a rubbery electrolyte. Some new results on polymer solutions are discussed in Chap. 6.6 with particular emphasis on theta solvents and hydrodynamic screening. Chapter 6.7 finally addresses experiments that have been performed on biological macromolecules. 

The less concentrated PA as the additive in a casting dope does not make long enough crosslinks among CA molecules, so the effective size of dynamic polymer aggregates in the solution prior to the phase inversion is too small - the AEy values are lower. 

This study addresses two questions 1) Is polymer aggregation in solutions directly related to solvent quality 2) If not, does solvent quality exert an effect on the viscosity of semidilute solutions separate from the effect of aggregation The copolymer poly(vinylbutyral) (PVB) was chosen for this investigation. PVB is known to aggregate in several solvents (IS). Light scattering and intrinsic viscosity measurements were used to assess solvent quality. Viscosities were measured at one concentration in three solvents and temperatures from 25 to 55 C. 

---