Polarity of batteries

The polarity of batteries may sometimes lead to confusion, which we would like to dispel. The anode and the cathode are defined as the electrodes at which oxidation and reduction occurs, respectively. But is the anode the positive or the negative terminal of a battery This question is particularly relevant for the case of secondary batteries, where the electrode serving as the anode during discharge becomes the cathode during charging and vice versa. 

It follows that in batteries, the negative electrode is the anode and the positive electrode is the cathode. In an electrolyzer, to the contrary, the negative electrode is the cathode and the positive electrode is the anode. Therefore, attention must be paid to the fact that the concepts of anode and cathode are related only to the direction of current flow, not to the polarity of the electrodes in galvanic cells. 

A major part of the work with nonaqueous electrolyte solutions in modern electrochemistry relates to the field of batteries. Many important kinds of novel, high energy density batteries are based on highly reactive anodes, especially lithium, Li alloys, and lithiated carbons, in polar aprotic electrolyte systems. In fact, a great part of the literature related to nonaqueous electrolyte solutions which has appeared during the past two decades is connected to lithium batteries. These facts justify the dedication of a separate chapter in this book to the electrochemical behavior of active metal electrodes. 

If the polarity of the current is not allowed to change too rapidly, it is possible, since oxidation and reduction occur successively at each pole, to accomplish electrolyses with alternating currents. Experiments with this end in view have been made b Drechsel.1 Dehydration is a case of simultaneous reduction and oxidation. The supposition that in living organisms carbamide is produced from ammonium carbamate by the splitting off of water prompted Drechsel to make experiments in this direction. When an aqueous solution of ammonium carbamate is electrolyzed with a current from a battery of 4-6 Grove cells, and platinum electrodes used, carbamide is obtained independently of the electrode material when alternating currents are employed. The reactions are supposed to be either... 

In Fig. 15c, the resistor has been replaced by an electrochemical cell. This cell could be a recharging battery or a corrosion cell that is being studied electro-chemically. In either case, it will be a driven system. The driving is being done by the battery just discussed, or a power supply, or a potentiostat (more on this option below). Nonetheless, replacing the resistor with an electrochemical cell does nothing to change the polarity of the driven system. The electrode on the... 

Anode — Electrode where -> oxidation occurs and electrons flow from electrolyte to electrode. At the other electrode, which is called a - cathode, electrons flow from electrode to electrolyte. It follows that in a -> battery, the anode is the negative electrode. In - electrolysis, to the contrary, the anode is the positive electrode. Note that the concepts of anode and cathode are related only to the direction of electron flow, not to the polarity of the electrodes. The terms anode and cathode as well as anion , cation electrolyte etc. were introduced by - Faraday, who considered that anions migrated toward the anode, while cations migrated toward the cathode (see also - Whewell). However, it should be noted that the redox species, which gives electrons to the anode, is not necessarily an anion. 

Fig. 8M The potential of the two electrodes in a CiilZn battery during charge and discharge. Note that the polarity of the cell is not changed, although the potential it delivers is always smaller than the potential needed to charge it. Reprinted with permission from Moran and Gileadi, J. Chem. Education, 66, 912. 1989). Copyright 1989, Division of Chemical Education of the American Chemical Society.

---