Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Photoconductivity excitation

Figure 3a shows several representative photoconductivity excitation spectra in pure xenon Fig. 3b for argon doped by ethane. In pure liquid and solid xenon and krypton, the value of as determined by means of the photoconductivity threshold is in full accord with its value as found from the limit of Wannier-Mott excitonic series (Asaf and Stelnberger, 1974 Laporte et al., 1985 see also below). This fact furnishes independent support for the applicability of solid-state concepts like energy... [Pg.238]

Another interesting applications area for fullerenes is based on materials that can be fabricated using fullerene-doped polymers. Polyvinylcarbazole (PVK) and other selected polymers, such as poly(paraphcnylene-vinylene) (PPV) and phenylmethylpolysilane (PMPS), doped with a mixture of Cgo and C70 have been reported to exhibit exceptionally good photoconductive properties [206, 207, 208] which may lead to the development of future polymeric photoconductive materials. Small concentrations of fullerenes (e.g., by weight) lead to charge transfer of the photo-excited electrons in the polymer to the fullerenes, thereby promoting the conduction of mobile holes in the polymer [209]. Fullerene-doped polymers also have significant potential for use in applications, such as photo-diodes, photo-voltaic devices and as photo-refractive materials. [Pg.85]

Madan et al. [515] have presented the effect of modulation on the properties of the material (dark conductivity and photoconductivity) and of solar cells. They also observe an increase in deposition rate as a function of modulation frequency (up to 100 kHz) at an excitation frequency of 13.56 MHz, in their PECVD system [159]. The optimum modulation frequency was 68 kHz, which they attribute to constraints in the matching networks. Increasing the deposition rate in cw operation of the plasma by increasing the RF power leads to worse material. Modulation with a frequency larger than 60 kHz results in improved material quality, for material deposited with equal deposition rates. This is also seen in the solar cell properties. The intrinsic a-Si H produced by RF modulation was included in standard p-i-n solar cells, without buffer or graded interface layers. For comparison, solar cells employing layers that were deposited under cw conditions were also made. At a low deposition rate of about 0.2 nm/s, the cw solar cell parameters... [Pg.156]

Quantum detectors are based on semiconductors. The absorption of a photon excites an electron from the valence band into the conduction band. This can be measured either through a change in resistance (photoconductive... [Pg.143]

NHE OCP ONO OPS PCD PDS PL PLE PMMA PP PP PS PSG PSL PTFE PVC PVDF normal hydrogen electrode (= SHE) open circuit potential oxide-nitride-oxide dielectric oxidized porous silicon photoconductive decay photothermal displacement spectroscopy photoluminescence photoluminescence excitation spectroscopy polymethyl methacrylate passivation potential polypropylene porous silicon phosphosilicate glass porous silicon layer polytetrafluoroethylene polyvinyl chloride polyvinylidene fluoride... [Pg.246]

This model has been confirmed by the fact that La202S-Eu3+ shows -type photoconductivity upon excitation into the and levels and the c.t. state (75). [Pg.65]

Electrical conductivity is due to the motion of free charge carriers in the solid. These may be either electrons (in the empty conduction band) or holes (vacancies) in the normally full valence band. In a p type semiconductor, conductivity is mainly via holes, whereas in an n type semiconductor it involves electrons. Mobile electrons are the result of either intrinsic non-stoichiometry or the presence of a dopant in the structure. To promote electrons across the band gap into the conduction band, an energy greater than that of the band gap is needed. Where the band gap is small, thermal excitation is sufficient to achieve this. In the case of most iron oxides with semiconductor properties, electron excitation is achieved by irradiation with visible light of the appropriate wavelength (photoconductivity). [Pg.115]


See other pages where Photoconductivity excitation is mentioned: [Pg.327]    [Pg.164]    [Pg.685]    [Pg.169]    [Pg.169]    [Pg.239]    [Pg.239]    [Pg.240]    [Pg.286]    [Pg.327]    [Pg.164]    [Pg.685]    [Pg.169]    [Pg.169]    [Pg.239]    [Pg.239]    [Pg.240]    [Pg.286]    [Pg.2216]    [Pg.2873]    [Pg.135]    [Pg.193]    [Pg.407]    [Pg.414]    [Pg.426]    [Pg.131]    [Pg.169]    [Pg.405]    [Pg.446]    [Pg.43]    [Pg.297]    [Pg.50]    [Pg.137]    [Pg.138]    [Pg.139]    [Pg.176]    [Pg.397]    [Pg.69]    [Pg.5]    [Pg.124]    [Pg.125]    [Pg.193]    [Pg.52]    [Pg.56]    [Pg.618]    [Pg.307]    [Pg.218]    [Pg.12]    [Pg.16]    [Pg.16]   
See also in sourсe #XX -- [ Pg.164 ]




SEARCH



Photoconducting

Photoconduction

Photoconduction excitation spectrum

Photoconductive

Photoconductivity

© 2024 chempedia.info