Palladium-catalyzed amination reductive elimination

A general mechanism for the palladium-catalyzed amination of aryl halides is presented in Scheme 7. This picture has been developed from studies performed largely upon isolated complexes, with the oxidative addition and reductive elimination steps being investigated in the greatest detail. On... 

The overall mechanism for palladium-catalyzed amination of aryl halides is shown in Scheme 4. Initially, a palladium(O) complex is rapidly formed from Pd(OAc)2 and phosphine ligand in the presence of amine and base. If Pd(dba)2 is used, then either bisphosphine Pd(0) complexes are formed, as with P(Bu-f)3170, or mixed phosphine/dba palladium(O) complexes are formed as with arylphosphines171. When the reactions are initiated with dba complexes, dba is consumed under the reaction conditions, and simple bis-ligand Pd(0) complexes are formed. The mechanism for reduction of Pd(II) to Pd(0) has been studied172, but the process occurs more rapidly in the presence of amine and base than in the absence of these reagents, even when the amine cannot undergo /3 -hydrogen elimination. 

Detailed analysis of the reaction mixtures revealed that the reaction occurs with quantitative chemoselectivity as no fluoro-substituted products are observed. However, further analysis of the synthesis of 15a revealed 22 % of the known hydrodechlorinated product (17). Although the reducing agent has not been identified, reductions in palladium-catalyzed aminations have been observed where the amine acts as the reducing agent via a y0-hydrogen elimination path-way. 

Based on the above-mentioned stereochemistry of the allylation reactions, nucleophiles have been classified into Nu (overall retention group) and Nu (overall inversion group) by the following experiments with the cyclic exo- and ent/n-acetales 12 and 13[25], No Pd-catalyzed reaction takes place with the exo-allylic acetate 12, because attack of Pd(0) from the rear side to form Tr-allyl-palladium is sterically difficult. On the other hand, smooth 7r-allylpalladium complex formation should take place with the endo-sWyWc acetate 13. The Nu -type nucleophiles must attack the 7r-allylic ligand from the endo side 14, namely tram to the exo-oriented Pd, but this is difficult. On the other hand, the attack of the Nu -type nucleophiles is directed to the Pd. and subsequent reductive elimination affords the exo products 15. Thus the allylation reaction of 13 takes place with the Nu nucleophiles (PhZnCl, formate, indenide anion) and no reaction with Nu nucleophiles (malonate. secondary amines, LiP(S)Ph2, cyclopentadienide anion). 

The Pd-catalyzed amination of / -rm-butylphenyl bromide with pyrrole in the presence of Pd(OAc)2, dppf and one equivalent of NaOr-Bu led to the Af-arylation product 88. A simplified version of the mechanism commences with the oxidative addition of p-te/t-butylphenyl bromide to Pd(0), giving rise to the palladium complex 89. Ligand exchange with pyrrole followed by deprotonation by the base (NaOr-Bu) results in amido complex 90. Reductive elimination of 90 then gives the amination product 88 with concomitant regeneration of Pd(0) catalyst. If the amine had a (3-hydride in amido complex 90, a (3-hydride elimination would be a competing pathway, although reductive elimination is faster than P-hydride elimination in most cases. 

Two studies have been conducted that outline the effects of ligand steric and electronic properties on the relative rates for reductive elimination of amine and P-hydrogen elimination from amides. One study focused on the amination chemistry catalyzed by P(o-C6H4Me)3 palladium complexes [111], while the second focused on the chemistry catalyzed by complexes containing chelating ligands [88]. 

The transition metal catalyzed synthesis of arylamines by the reaction of aryl halides or tri-flates with primary or secondary amines has become a valuable synthetic tool for many applications. This process forms monoalkyl or dialkyl anilines, mixed diarylamines or mixed triarylamines, as well as N-arylimines, carbamates, hydrazones, amides, and tosylamides. The mechanism of the process involves several new organometallic reactions. For example, the C-N bond is formed by reductive elimination of amine, and the metal amido complexes that undergo reductive elimination are formed in the catalytic cycle in some cases by N-H activation. Side products are formed by / -hydrogen elimination from amides, examples of which have recently been observed directly. An overview that covers the development of synthetic methods to form arylamines by this palladium-catalyzed chemistry is presented. In addition to the synthetic information, a description of the pertinent mechanistic data on the overall catalytic cycle, on each elementary reaction that comprises the catalytic cycle, and on competing side reactions is presented. The review covers manuscripts that appeared in press before June 1, 2001. This chapter is based on a review covering the literature up to September 1, 1999. However, roughly one-hundred papers on this topic have appeared since that time, requiring an updated review. 

Bulky ligands as above have also proved to be effective in other palladium-catalyzed reactions of aryl halides, e.g., amination [16-19], Suzuki-Miyaura reaction [20-22], Mizoroki-Heck reaction [23, 24], Migita-Kosugi-Stille reaction [25], and aryloxylation and alkoxylation [26-28] as well as the reaction with various carbon nucleophiles as described below. The ligands are considered to enhance both the initial oxidative addition of aryl halides and the reductive elimination of products [29, 30]. The effectiveness of the commercially available simple ligand, P(f-Bu)3, was first described for the amination by Nishiyama et al. [16]. 

A wide variety of nucleophiles add to an -rf-allyl ligand. Desirable nucleophiles typically include stabilized carbanions such as CH(COOR)2 or 1° and II0 amines. Unstabilized nucleophiles such as MeMgBr or MeLi often attack the metal first and then combine with the n-allyl by reductive elimination. The Tsuji-Trost reaction, which is typified by the addition of stabilized carbanions to T 3—allyl ligands complexed to palladium followed by loss of the resulting substituted alk-ene, comprises an extremely useful method of constructing new C-C bonds, and many applications of this reaction have appeared in the literature.61 Equation 8.43 illustrates an example of a Pd-catalyzed addition of a stabilized enolate to an allyl acetate.62 The initial step in the catalytic cycle is oxidative addition of the allyl acetate to the Pd(0) complex, followed by nq1 to nq3—allyl isomerization, and then attack by the nucleophile to a terminal position of the T 3—allyl ligand. We will discuss the Tsuji-Trost reaction, especially in regard to its utility in chiral synthesis,63 more extensively in Chapter 12. 

The generally accepted catalytic cycle for the Buchwald-Hartwig amination mirrors that of other palladium catalyzed cross-coupling reactions.10 11 irThere is an oxidative addition (A to B), followed by an exchange on palladium (B to C), and finally a reductive elimination (C to D and A). The main difference involves the exchange step. In a Suzuki, or Stille, reaction this step proceeds through a discrete transmetallation event, whereas... 

In a generahzed and simpHfied mechanism, the reaction usually follows the standard catalytic cycle of metal-catalyzed cross-coupling reactions oxidative addition of the C(sp ) -X bond to paUadium(O), followed by coordination of the amine to the resulting palladium complex, occurring with extrusion of HX that is captured by the base. Finally, reductive elimination yields the couphng product, regenerating the catalyticaUy active paUadium(O) species. 

In addition, reductive elimination of palladium and nickel complexes to form esters (Equations 8.67 and 8.68), amides, and tiiioesters has been reported. -" The reductive eliminations of esters and amides were observed during mechanistic studies on the palladium-catalyzed formation of esters and amides from aryl halides, carbon monoxide, and alcohols or amines. This catalytic process is presented in Qiapter 17 (carbonylation processes). The reductive elimination of thioesters from nickel complexes were studied, in part, to understand the C-S bond-forming process of acetyl coenzyme A synthase. Prior to this work, an iron-mediated synthesis of p-lactams had been reported that appears to occur by reductive elimination to form the amide C-N bond of the lactam. ... 

Balme has reported a one-pot threecomponent alkene carboamination between propargylic amines, alkylidene malonates, and aryl halides [43]. For example, treatment of N-methyl propargylamine (2 equiv), dimethyl benzylidene malonate (2 equiv) and 1,4-diiodobenzene (1 equiv) with n-BuLi and a palladium catalyst provided 43 as a single diastereomer (Eq. (1.20)) [43a]. The formation of the C—N bond in this process does not appear to be metal catalyzed. Instead, initial conjugate addition of the nitrogen nucleophile to the activated alkene affords a malonate anion, which undergoes carbopalladation followed by reductive elimination to afford the pyrrolidine product. 

---