Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Oxygen injection system

OXY I is an oxygen injection system for remediation of organics-contaminated groundwater. The oxygen enhances biodegradation of the contaminants, particularly methyl tertiary butyl ether... [Pg.636]

To study the effectiveness of the oxygen injection system, as well as to investigate other water-quality issues, the Waterways Experiment Station (WES), U.S. Army Corps of Engineers, conducted extensive studies in both Lake RBR and Lake Thurmond. These ongoing studies, which began prior to creation of the impoundment, provide a detailed picture of the course of events since impoundment. Reports containing these data (54) form a valuable basis for other studies. [Pg.500]

CONOx (2) A process for reducing NOx emissions from the FCC process. It combines a Shell process that redirects the airflow in an FCC regenerator with an oxygen injection system developed by Praxair that oxidizes CO and destroys NOx precursors. First installed at Valero s Ardmore refinery in 2013. [Pg.81]

Probably the most significant control technology breakthrough came m 1977, when Volvo released a computer-controlled, fuel-mjected vehicle equipped with a three-way catalyst. The new catalytic converters employed platinum, palladium, and rhodium to simultaneously reduce NO and oxidize CO and HC emissions under carefully controlled oxygen conditions. The new Bosch fuel injection system on the vehicle provided the precise air/fuel control necessary for the new catalyst to perform effectively. The combined fuel control and three-way catalyst system served as the foundation for emissions control on the next generation of vehicles. [Pg.451]

C04-0009. Combustion reactions require molecular oxygen. In an automobile the fuel-injection system must be adjusted to provide the right mix of gasoline and air. Compute the number of grams of oxygen required to react completely with 1.00 L of octane (CgHig,p = 0.80 g/mL). What masses of water and carbon dioxide are produced in this reaction ... [Pg.211]

Additionally, NO is reduced by H2 and by hydrocarbons. To enable the three reactions to proceed simultaneously - notice that the two first are oxidation reactions while the last is a reduction - the composition of the exhaust gas needs to be properly adjusted to an air-to-fuel ratio of 14.7 (Fig. 10.1). At higher oxygen content, the CO oxidation reaction consumes too much CO and hence NO conversion fails. If however, the oxygen content is too low, all of the NO is converted, but hydrocarbons and CO are not completely oxidized. An oxygen sensor (l-probe) is mounted in front of the catalyst to ensure the proper balance of fuel and air via a microprocessor-controlled injection system. [Pg.379]

Figure 10.2. Principle of the 2-probe oxygen sensor used to regulate the injection system to obtain the correct air-to-fuel ratio in the exhaust gas. Figure 10.2. Principle of the 2-probe oxygen sensor used to regulate the injection system to obtain the correct air-to-fuel ratio in the exhaust gas.
Sharp [48] has described a dry combustion-direct injection system built for oceanographic analyses. This unit used 100 xl samples, injected into a 900 °C oven in an atmosphere of oxygen. The output from a non-dispersive infrared carbon dioxide analyser was linearised and integrated. [Pg.496]

Several authors observed CL emission based on reduction reactions. Lu et al. [59] developed a method by applying a Jones reductor for producing unstable reductants. A column (100 X 3 mm i.d.) filled with Zn-Hg particles was inserted into the flow stream of a flow injection system. CL was measured using a homemade CL analyzer. Although the Jones reductor was more effective for the species studied in 0.5-5 mol/L H2S04 solution, the authors found that a lower acid concentration improved the CL emission. Hie optimal pH was 6.5 for V(II), 2.5 for Mo(III), 3.5 for U(III), 3.0 for W(III), 3.0 for Cr(II), 2.5 for Ti(III), and 2.5 for Fe(II). The methods allowed determination of the above-mentioned species at pg/mL to ng/mL levels. It was assumed that the CL reactions were related to the production of superoxide radicals by dissolved oxygen in the solutions. The proposed methods could be successfully applied to the determination of V [60], Mo [61], and U [62] in water or steel samples. [Pg.128]


See other pages where Oxygen injection system is mentioned: [Pg.500]    [Pg.507]    [Pg.426]    [Pg.152]    [Pg.540]    [Pg.696]    [Pg.500]    [Pg.507]    [Pg.426]    [Pg.152]    [Pg.540]    [Pg.696]    [Pg.483]    [Pg.337]    [Pg.157]    [Pg.451]    [Pg.87]    [Pg.299]    [Pg.300]    [Pg.82]    [Pg.99]    [Pg.121]    [Pg.124]    [Pg.127]    [Pg.1016]    [Pg.444]    [Pg.337]    [Pg.259]    [Pg.265]    [Pg.271]    [Pg.278]    [Pg.285]    [Pg.342]    [Pg.422]    [Pg.440]    [Pg.454]    [Pg.286]    [Pg.70]    [Pg.161]    [Pg.409]    [Pg.732]    [Pg.483]    [Pg.38]    [Pg.171]    [Pg.98]   


SEARCH



Injectable systems

Injecting system

Injection systems

Oxygen systems

© 2024 chempedia.info