Oxygen-free surfaces

Suspensions of base metals can be generated at the cathode at high current densities ( 0.5 A cm ) in two-phase systems. Since very small particles with oxygen-free surfaces are generated, the reactivity of these metal suspensions clearly surpasses that of commonly employed metals In this way zinc, copper,... 

Because of the irreversible and not well-understood change of the electrocatalyst surface above 1.0 V, early mechanistic studies were conducted under ill-defined conditions. Thus, while anodic evolution of Oj takes place always in the presence of oxygen-covered electrodes, the cathodic reaction proceeds on either oxygen-covered or oxygen free surfaces with different mechanisms (77,158). The electrochemical oxide path, proposed for oxide-covered platinum metals in alcaline electrolytes (759,160), has been criticized by Breiter (7), in view of the inhibition of oxygen reduction by the oxygen layers. Present evidence points to the peroxide-radical mechanism (77,... 

Titanium disulfide can also be made by pyrolysis of titanium trisulfide at 550°C. A continuous process based on the reaction between titanium tetrachloride vapor and dry, oxygen-free hydrogen sulfide has been developed at pilot scale (173). The preheated reactants ate fed iato a tubular reactor at approximately 500°C. The product particles comprise orthogonally intersecting hexagonal plates or plate segments and have a relatively high surface area (>4 /g), quite different from the flat platelets produced from the reaction between titanium metal and sulfur vapor. The powder, reported to be stable to... 

Activation by a metal surface also takes place in the commercially important anaerobic adhesives. These one-part adhesives are stable in the package, but cure quickly in an oxygen-free environment such as a tightly controlled bond line. Important applications include thread-locking, sealing, retaining, and some structural bonding [111]. A representative model formulation has recently been described [112] (Fig. 3). 

The corrosion of tin by nitric acid and its inhibition by n-alkylamines has been reportedThe action of perchloric acid on tin has been studied " and sulphuric acid corrosion inhibition by aniline, pyridine and their derivatives as well as sulphones, sulphoxides and sulphides described. Attack of tin by oxalic, citric and tartaric acids was found to be under the anodic control of the Sn salts in solution in oxygen free conditions . In a study of tin contaminated by up to 1200 ppm Sb, it was demonstrated that the modified surface chemistry catalysed the hydrogen evolution reaction in deaerated citric acid solution. 

Polyunsaturated fats can combine easily with oxygen at the points where there is a double bond between two carbon atoms. This is why they make good antioxidants they combine with the oxygen free radicals so they don t damage other molecules. It is also how oils harden, and is thus important to painters. Oil paints made with linseed oil are almost three-quarters trilinolein. They dry to form a tough plastic film that incorporates the pigments and holds them onto the surface to be painted. 

Another typical example of inhomogeneity in rheometry is the oxidation of a polymer in a rotational rheometer in which a disk-shaped sample is held between metal fixtures. The oxygen enters the sample through the free surface (at the outer diameter) and diffuses radially inwards. The result is a radial gradient in properties which changes with time. If the reaction with oxygen results in... 

Figure 9.26 Cr 2p spectra and negative SIMS spectra of two model catalysts and a blank reference. The blank (bottom) shows only Si,0, fragments on a chromium-loaded catalyst CriCf fragments appear after thermal activation (Ar/02). If desorption of chromium is made impossible (in oxygen-free argon), Cr2Or clusters can also be detected. In combination, this is strong evidence that chromate anchors to the silica surface as a monomer (courtesy of P.C. Thiine and R. Linke, Eindhoven).

---