Hydrogen oxygen-free

Titanium disulfide can also be made by pyrolysis of titanium trisulfide at 550°C. A continuous process based on the reaction between titanium tetrachloride vapor and dry, oxygen-free hydrogen sulfide has been developed at pilot scale (173). The preheated reactants ate fed iato a tubular reactor at approximately 500°C. The product particles comprise orthogonally intersecting hexagonal plates or plate segments and have a relatively high surface area (>4 /g), quite different from the flat platelets produced from the reaction between titanium metal and sulfur vapor. The powder, reported to be stable to... 

In oxygen-free seawater, the J(U) curves, together with the Tafel straight lines for hydrogen evolution, correspond to Eq. (2-19) (see Fig. 2-2lb). A limiting current density occurs with COj flushing for which the reaction ... 

In oxygen-free water, the self-corrosion is practically solely due to hydrogen evolution... 

To estimate the current yield of magnesium alloys, the weight loss is determined indirectly over the volumetric measurement of the evolved hydrogen in the apparatus in Fig. 6-9 in Section 6.2.4. The mass balance for oxygen-free media follows from Eqs. (6-1) and (6-5a,b) or (6-14) ... 

The corrosion of tin by nitric acid and its inhibition by n-alkylamines has been reportedThe action of perchloric acid on tin has been studied " and sulphuric acid corrosion inhibition by aniline, pyridine and their derivatives as well as sulphones, sulphoxides and sulphides described. Attack of tin by oxalic, citric and tartaric acids was found to be under the anodic control of the Sn salts in solution in oxygen free conditions . In a study of tin contaminated by up to 1200 ppm Sb, it was demonstrated that the modified surface chemistry catalysed the hydrogen evolution reaction in deaerated citric acid solution. 

Propyl gallate is an antioxidant. It protects against oxidation by hydrogen peroxide and oxygen free radicals in a catalytic manner similar to superoxide dismutase. 

The standard cell potential for the hydrogen-oxygen reaction is then determined by the free energy of formation of water (gas) by... 

In a number of cases, the temperature of the filament and thermodynamic parameters allow one to calculate [9] the flux intensity of free atoms produced in dissociation of molecules. Specifically, in the case of dissociation of hydrogen, oxygen, and nitrogen molecules on hot metal filaments under pressures of molecular gases higher than lO" Torr, the flux intensity of atoms A originating from A2 molecules is given by... 

Janssen and Hoogland (J3, J4a) made an extensive study of mass transfer during gas evolution at vertical and horizontal electrodes. Hydrogen, oxygen, and chlorine evolution were visually recorded and mass-transfer rates measured. The mass-transfer rate and its dependence on the current density, that is, the gas evolution rate, were found to depend strongly on the nature of the gas evolved and the pH of the electrolytic solution, and only slightly on the position of the electrode. It was concluded that the rate of flow of solution in a thin layer near the electrode, much smaller than the bubble diameter, determines the mass-transfer rate. This flow is affected in turn by the incidence and frequency of bubble formation and detachment. However, in this study the mass-transfer rates could not be correlated with the square root of the free-bubble diameter as in the surface renewal theory proposed by Ibl (18). 

Q7. Propose a structure from Spectra 15.10-15.13. The compound is known to be a free base and is composed of only carbon, hydrogen, oxygen and nitrogen. It has a molecular weight of 267. To further complicate matters, the compound was extracted into CDCI3 solution from D20/sodium carbonate so that no exchangeable protons can be observed. 

Dry hydrogen or dry nitrogen may be used. The gas must be oxygen-free. Hydrogen tends to decrease the amount of oxidation to diselenide. 

---