Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Nuclear Overhauser enhancement relaxation

N-protonation the absolute magnitude of the Ad values is larger than for Af-methylation <770MR(9)53>. Nuclear relaxation rates of and have been measured as a function of temperature for neat liquid pyridazine, and nuclear Overhauser enhancement has been used to separate the dipolar and spin rotational contributions to relaxation. Dipolar relaxation rates have been combined with quadrupole relaxation rates to determine rotational correlation times for motion about each principal molecular axis (78MI21200). NMR analysis has been used to determine the structure of phenyllithium-pyridazine adducts and of the corresponding dihydropyridazines obtained by hydrolysis of the adducts <78RTC116>. [Pg.8]

The main contribution to the spin-lattice relaxation of C nuclei which are connected to hydrogen is provided by the dipole-dipole interaction (DD mechanism, dipolar relaxation). For such C nuclei a nuclear Overhauser enhancement of almost 2 will be observed during H broadband decoupling according to ... [Pg.65]

The 50.31 MHz 13C NMR spectra of the chlorinated alkanes were recorded on a Varian XL-200 NMR spectrometer. The temperature for all measurements was 50 ° C. It was necessary to record 10 scans at each sampling point as the reduction proceeded. A delay of 30 s was employed between each scan. In order to verify the quantitative nature of the NMR data, carbon-13 Tj data were recorded for all materials using the standard 1800 - r -90 ° inversion-recovery sequence. Relaxation data were obtained on (n-Bu)3SnH, (n-Bu)3SnCl, DCP, TCH, pentane, and heptane under the same solvent and temperature conditions used in the reduction experiments. In addition, relaxation measurements were carried out on partially reduced (70%) samples of DCP and TCH in order to obtain T data on 2-chloropentane, 2,4-dichloroheptane, 2,6-dichloroheptane, 4-chloroheptane, and 2-chloroheptane. The results of these measurements are presented in Table II. In the NMR analysis of the chloroalkane reductions, we measured the intensity of carbon nuclei with T values such that a delay time of 30 s represents at least 3 Tj. The only exception to this is heptane where the shortest T[ is 12.3 s (delay = 2.5 ). However, the error generated would be less than 10%, and, in addition, heptane concentration can also be obtained by product difference measurements in the TCH reduction. Measurements of the nuclear Overhauser enhancement (NOE) for carbon nuclei in the model compounds indicate uniform and full enhancements for those nuclei used in the quantitative measurements. Table II also contains the chemical... [Pg.360]

NOE Nuclear Overhauser effect/nuclear Overhauser enhancement. Enhancement of the intensity of a signal via augmented relaxation of the nucleus to other nearby nuclei that are undergoing saturation. See also ... [Pg.208]

T3C n.m.r. spectra were recorded for the oils produced at 400°, 450°, 550° and 600°C. As the temperature increased the aromatic carbon bands became much more intense compared to the aliphatic carbon bands (see Figure 8). Quantitative estimation of the peak areas was not attempted due to the effect of variations in spin-lattice relaxation times and nuclear Overhauser enhancement with different carbon atoms. Superimposed on the aliphatic carbon bands were sharp lines at 14, 23, 32, 29, and 29.5 ppm, which are due to the a, 8, y, 6, and e-carbons of long aliphatic chains (15). As the temperature increases, these lines... [Pg.277]

C (or 15N) spin-lattice relaxation times (T C), spin-spin relaxation times (T2c) and nuclear Overhauser enhancement (NOE rj) are generally given... [Pg.8]

The 13C NMR sensitivity can sometimes be a problem, but for the kind of samples studied here the effective concentration of monomer units is several molar which does not place excessive demands on present Fourier transform NMR spectrometers. In addition to the sensitivity of the chemical shift to structure (9), the relaxation of protonated carbons is dominated by dipole-dipole interaction with the attached proton (9). The dependence of the relaxation parameters T, or spin-lattice, and Tor spin-spin, on isotropic motional correlation time for a C-H unit is shown schematically in Figure 1. The T1 can be determined by standard pulse techniques (9), while the linewidth at half-height is often related to the T2. Another parameter which is related to the correlation time is the nuclear Overhauser enhancement factor, q. The value of this factor for 13C coupled to protons, varies from about 2 at short correlation times to 0.1 at long correlation... [Pg.503]

C Spin-Lattice Relaxation-Times, Line Widths, and Nuclear Overhauser Enhancements (n.O.e.) of PS 13140... [Pg.34]

D. Cross-relaxation rates - nuclear Overhauser enhancement (nOe) factors... [Pg.3]

D. Cross-relaxation Rates - Nuclear Overhauser Enhancement (nOe) Factors... [Pg.13]

Spin-lattice relaxation times were measured by the fast inversion-recovery method (24) with subsequent data analysis by a non-linear three parameter least squares fitting routine. (25) Nuclear Overhauser enhancement factors were measured using a gated decoupling technique with the period between the end of the data acquisition and the next 90° pulse equal to eibout four times the value. Most of the data used a delay of eibout ten times the Ti value. (26)... [Pg.183]

The results that have been obtained indicate that the major influence of the crystalline regions on segmental motions, and hence to the structure of the non-crystalline regions, is in the linewidth and T2. The different morphologies are reflected in different values of T2- The segmental motions in long chain molecules which exert major influence on the spin-lattice relaxation times and the nuclear Overhauser enhancements are not in general the same motions which determine the resonant linewidth. [Pg.200]

The layout of this chapter is as follows. The aspects of relaxation theory of interest for this article are summarized very briefly in Section 2. Section 3 deals with general aspects of relaxation measurements, including polarization transfer techniques for improving the sensitivity. Sections 4, 5 and 6 cover measurements of T, T2 and the nuclear Overhauser enhancement, respectively. [Pg.328]

The terms pc and py correspond to 1/Tic and 1/Tih, respectively, and CTCH is the cross-relaxation rate. It should be stressed that the simplicity of the above equation is a consequence of the rareness of the I spins and of the dominant strength of the dipolar interaction between directly bonded nuclei. The situation for homonuclear proton spin systems is often more complicated, since the protons usually constitute a much larger spin system, and a separation into distinct two-spin systems may be not valid in this case. The broadband irradiation of the protons yields, in a steady state, Mhz = 0 and M z = Mj (1 rj). The factor 1 + 77 is called, as introduced above, the nuclear Overhauser enhancement factor. The NOE factor is related in a simple way to the equilibrium magnetizations of the I- and S-spins (which are proportional to the magnetogyric ratios 71 and 7s), the cross-relaxation rate and the relaxation rate of the I-spin ... [Pg.344]

R. Mathur-De Vre, C. Maerschalk and C. Delporte, Spin-lattice relaxation times and nuclear Overhauser enhancement effect for P metabolites in model solutions at two... [Pg.146]

Nuclear Overhauser enhancements and spin-lattice relaxation times are individual for each carbon. As a result, signal intensities cannot be evaluated from PFT 13C NMR spectra obtained with continuous proton broadband decoupling. [Pg.50]

Spin-lattice relaxation times of carbon-13 in different polypropylene stereosequences differ slightly while nuclear Overhauser enhancements are almost identical (1.8-2.0) [533] isotactic sequences display larger Tx values than the syndiotactic stereoisomers. Other vinyl polymers behave correspondingly [534]. Carbon-13 spin-lattice relaxation times further indicate that dynamic properties in solution depend on configurational sequences longer than pentads. The ratio 7J(CH) 7J(CH2) varies between 1.6 to 1.9 thus, relaxation can be influenced by anisotropic motions of chain segments or by unusual distributions of correlation times [181],... [Pg.313]

Si NMR studies of solutions are difficult because of the long spin-lattice relaxation times of the nucleus and its negative nuclear Overhauser enhancement. The 29Si-1H dipole-dipole relaxation is inefficient because in most compounds the intemuclear distance is large. Fortunately, the problem of relaxation can often be overcome by resorting to cross-polarization (see Section II,E). [Pg.218]


See other pages where Nuclear Overhauser enhancement relaxation is mentioned: [Pg.1510]    [Pg.396]    [Pg.10]    [Pg.168]    [Pg.84]    [Pg.126]    [Pg.111]    [Pg.152]    [Pg.29]    [Pg.44]    [Pg.67]    [Pg.54]    [Pg.144]    [Pg.144]    [Pg.156]    [Pg.194]    [Pg.249]    [Pg.271]    [Pg.331]    [Pg.164]    [Pg.168]    [Pg.74]    [Pg.53]    [Pg.51]    [Pg.75]    [Pg.164]    [Pg.254]    [Pg.55]    [Pg.125]    [Pg.620]    [Pg.49]    [Pg.119]   
See also in sourсe #XX -- [ Pg.164 , Pg.165 , Pg.166 ]




SEARCH



Nuclear Overhauser

Nuclear Overhauser enhancement

Nuclear Overhauser enhancement relaxation times

Nuclear Overhauser enhancement relaxation-rate measurements

Nuclear relaxation

Overhauser

Overhauser enhancement

Relaxation enhancement

© 2024 chempedia.info