Nuclear magnetic resonance , solids dependence

Silicagel is also called silica or bare silica. Its adsorptive properties depend on the hydroxyl groups attached to surface silicon atoms. Silicagel has a maximum silanol density of 8.0 yumolcs/ m2. Many of these silanols are buried deep in the porous structure and are available only to the smallest analytes. Silanols are either isolated, geminal, or vicinal they can be distinguished by means of Si solid-state nuclear magnetic resonance (NMR). The surface also contains siloxane bonds (Si-O-Si), which are considered hydrophobic. 

All the powerful methods of magnetic resonance, from solid-state nuclear magnetic resonance (NMR) to medical magnetic resonance imaging, depend on measuring the time evolution of a spin system following the application of one or more radio frequency pulses. In the visible and ultraviolet, ultrafast optical pulse sequences have been used for many years to measure both population dynamics and coherence phenomena. At low... 

J. Higinbotham, B. M. Wood and R. F. Code, Time dependence of spin conversion in solid 13CH3D by nuclear magnetic resonance. Can.. Phys., 1979, 57, 1752-1757. 

Comparing FTMS with Fourier transform nuclear magnetic resonance (FTNMR), we first notice how the frequency range to be covered here is very large. Second, relaxation in NMR is invariably linked with the interaction among liquid-phase or solid-phase molecules. In the gas phase, relaxation depends on the vacuum and on the stability of the ions being observed. If the vacuum is not sufficient, collisions slow the ions and their movement becomes incoherent. The observation of an ion is also limited to its lifetime. 

Plasticisers are added to PVC to achieve flexibility and workability. The flexibility or softness is determined by the type of plasticiser and level used in relation to the PVC (phr). They also operate as an internal lubricant between the PVC molecules. Based on organic esters, e.g., phthalates, adipates, trimellitates, phosphates, etc., addition levels can be as low as 20 phr for semi-rigid to 100 phr for very flexible applications. The effect on the thermal stability significantly depends on the physical state of the PVC-plasticiser system (260). The relative amount of crystalline PVC in PVC/diethylhexyl phthalate has been identified on the basis of a combination of carbon-13 solution and solid state nuclear magnetic resonance (NMR) (361). 

If the fat is cooled to some point below the melting point of the highest melting component and allowed to fully equilibrate (crystalhze to the maximum extent in the most stable polymorph), there will be some ratio of sohd to liquid fat dependent on the nature of the TAG mixture in the natural fat. This solid fat content (SFC) is often measured by a pulsed nuclear magnetic resonance (NMR) technique. A plot of the maximum amount of fat crystallized (SFC) at sequentially higher temperatures... 

Moisture was known to increase the mobility of the surface groups of protein as measured by solid-state nuclear magnetic resonance spectroscopy The distribution of water between the protein and the excipients in a freeze-dried powder depends on the crystalline or amorphous nature of the excipients. For example, if a protein is formulated with an amorphous excipient and stored in a sealed container, water would distribute according to the water affinity of the protein and excipients.When the amorphous excipient crystallizes (e.g., because of elevated temperatures), it will expel its sorbed water, which may cause stability problems in the protein. ... 

Burke PA, Griffin RG, and Klibanov AM. Solid-state Nuclear magnetic Resonance Investigation of Solvent Dependence of Tyrosyl Ring Motion in an Enzyme. Biotechnology and Bioengineering 1993 42 87—94. 

---