Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Nuclear magnetic resonance bands

W. Gozdz, R. Holyst. Distribution functions for H nuclear magnetic resonance band shapes for polymerized surfactant molecules forming triply periodic surfaces. J Chem Phys 706 9305-9312, 1997. [Pg.741]

Evidence of molecular rotation may be given by non-crystallographic evidence the transition from a rotating to a non-rotating state is accompanied by sudden changes in specific heat, in dielectric constant, and in width of nuclear magnetic resonance bands (see Chapter VIII). [Pg.362]

Self diffusion coefficients can be obtained from the rate of diffusion of isotopically labeled solvent molecules as well as from nuclear magnetic resonance band widths. The self-diffusion coefficient of water at 25°C is D= 2.27 x 10-5 cm2 s 1, and that of heavy water, D20, is 1.87 x 10-5 cm2 s 1. Values for many solvents at 25 °C, in 10-5 cm2 s 1, are shown in Table 3.9. The diffusion coefficient for all solvents depends strongly on the temperature, similarly to the viscosity, following an Arrhenius-type expression D=Ad exp( AEq/RT). In fact, for solvents that can be described as being globular (see above), the Stokes-Einstein expression holds ... [Pg.198]

Table 14. Nuclear magnetic resonance bands of alkyl groups in amines (Groups containing the relevant protons are indicated by ). [Pg.70]

Proton chemical shift data from nuclear magnetic resonance has historically not been very informative because the methylene groups in the hydrocarbon chain are not easily differentiated. However, this can be turned to advantage if a polar group is present on the side chain causing the shift of adjacent hydrogens downfteld. High resolution C-nmr has been able to determine position and stereochemistry of double bonds in the fatty acid chain (62). Broad band nmr has also been shown useful for determination of soHd fat content. [Pg.132]

The side-chain chlorine contents of benzyl chloride, benzal chloride, and benzotrichlorides are determined by hydrolysis with methanolic sodium hydroxide followed by titration with silver nitrate. Total chlorine determination, including ring chlorine, is made by standard combustion methods (55). Several procedures for the gas chromatographic analysis of chlorotoluene mixtures have been described (56,57). Proton and nuclear magnetic resonance shifts, characteristic iafrared absorption bands, and principal mass spectral peaks have been summarized including sources of reference spectra (58). Procedures for measuring trace benzyl chloride ia air (59) and ia water (60) have been described. [Pg.61]

Infrared, nuclear magnetic resonance, ultraviolet, optical rotary dispersion and circular dichroism measurements have been used for the spectral analysis of thiiranes. A few steroidal thiiranes have been reported to possess infrared absorption in the range from 580 to 700 cm The intermediate thiocyanate derivatives (RSCN) have a strong sharp peak at 2130-2160 cm the isomeric isothiocyanate (RNCS) shows a much stronger but broad band at 2040-2180 cm. ... [Pg.42]

Methylcarborane is an air-stable, white crystalline solid which is soluble in common organic solvents. The infrared spectrum (Nujol mull) contains major absorption bands at 3.90 (s), 8.83 (w), 9.12 (w), 9.69 (w), 9.83 (w), 10.03 (w), and 13.85 (s) p. The proton nuclear magnetic resonance spectrum of a carbon tetrachloride solution of methylcarborane contains a broad —CH resonance of intensity 1 at 6.52 r and a —CH3 resonance of intensity 3 at 8.02 r. [Pg.106]

Both absorption and emission may be observed in each region of the spectrum, but in practice only absorption spectra are studied extensively. Three techniques are important for analytical purposes visible and ultraviolet spectrometry (electronic), infrared spectrometry (vibrational) and nuclear magnetic resonance spectrometry (nuclear spin). The characteristic spectra associated with each of these techniques differ appreciably in their complexity and intensity. Changes in electronic energy are accompanied by simultaneous transitions between vibrational and rotational levels and result in broadband spectra. Vibrational spectra have somewhat broadened bands because of simultaneous changes in rotational energy, whilst nuclear magnetic resonance spectra are characterized by narrow bands. [Pg.354]

A review has appeared regarding the infrared and nuclear magnetic resonance spectroscopic investigations of quinolizidine alkaloids (303). The connection between the C/D ring junction and the existence of Bohlmann bands in the IR spectra of indolo[2,3-a]quinolizidines has been reinvestigated and interpreted (304). [Pg.248]

The determination of the various types of geometric isomers associated with unsaturation in Polymer chains is of great importance, for example, in the study of the structure of modern synthetic rubbers. In table below are listed some of the important infrared absorption bands which arise from olefinic groups. In synthetic "natural" rubber, cis-1, 4-polyisoprene, relatively small amounts of 1, 2 and 3, 4-addition can easily be detected, though it is more difficult to distinguish between the cis and trans-configurations. Nuclear magnetic resonance spectroscopy is also useful for this analysis. [Pg.79]

As shown in the infrared absorbance spectrum of the condensation polymer (See Fig. 1), bands characteristic of absorbance of the urea resin at 3,400 cm-1, 3,000 cm-1, 1,680 cm-1, 1,540 cm-1, 1,380 cm-1, 1,100 cm-1, 1,020 cm-1, 780 cm-1, and characteristic absorbance of acrylami demethyl base at 800 cm-1 are present judging from this data, it is considered that N-methylacrylamide is connected with the end group of urea resin main chains and the imino group. The nuclear magnetic resonance (See Fig. 2) spectrum of the oligomer shows a resonance value of 6.48 ppm based on CH2= and a resonance value of 5.74 ppm based on -CH=. [Pg.264]

Binsch, G. Band-Shape Analysis." In Dynamic Nuclear Magnetic Resonance Spectroscopy Jackman, L. M. Cotton, F. A., Eds. Academic Press New York, 1975 pp. 45-81. See also Binsch, G. Top Stereochem., 1968, 3, 97-192. [Pg.76]

The infrared spectrum of y-crotonolactone shows two bands in the carbonyl r on at 5.60 and 5.71 fi in carbon tetrachloride (5%) [shifted to 5.61 and 5.71 fi in chloroform (5%)] and carbon-carbon stretching absorption at 6.23 fjt. The nuclear magnetic resonance spectrum shows olefinic peaks centered at 2.15r (pair of triplets) and 3.85r (pair of triplets), each due to one proton, and a two-proton triplet centered at 5.03t (in CCU). [Pg.76]

Nuclear magnetic resonance spectra show that the compound exists as a monomer in the molten state IR and Raman data show that the same molecular structure exists for the solid state Sawodny and Goubeau calculated the force constants from the normal vibrations of the molecule, after they had corrected the original assignments of the bands A bond number of 0.78 was found for the P—B bond. The chemical shifts and coupling constants from the H and B n.m.r. spectra for molten BH3PH3 are given in Table 9... [Pg.33]

The H nuclear magnetic resonance spectrum of chlorpromazine hydrochloride in CDCI3 is shown in Figure 5 [13]. The data were recorded on a Varian XL 200 MHz spectrometer using tetramethylsilane as the internal reference. Assignments for the observed resonance bands are presented in Table 3. [Pg.112]

The carbon-13 nuclear magnetic resonance spectrum of a 4.7% (w/v) solution of dorzolamide hydrochloride was obtained in deuterated dimethyl sulfoxide, and is shown in Figure 9. The spectrum was recorded using a Brucker model AM-400 NMR spectrometer. The band assignments were referenced relative to dimethyl sulfoxide-ds (39.5 ppm), and the carbon atom assignments (using the same numbering system as just described) are collected in Table 5. [Pg.305]


See other pages where Nuclear magnetic resonance bands is mentioned: [Pg.258]    [Pg.165]    [Pg.258]    [Pg.165]    [Pg.391]    [Pg.42]    [Pg.84]    [Pg.10]    [Pg.370]    [Pg.131]    [Pg.485]    [Pg.188]    [Pg.5]    [Pg.55]    [Pg.104]    [Pg.108]    [Pg.327]    [Pg.371]    [Pg.355]    [Pg.211]    [Pg.37]    [Pg.17]    [Pg.242]    [Pg.108]    [Pg.183]    [Pg.350]    [Pg.510]    [Pg.196]    [Pg.275]    [Pg.299]    [Pg.107]   
See also in sourсe #XX -- [ Pg.18 ]




SEARCH



© 2024 chempedia.info