Nitriles substitution reactions

The enhancement of the electrophilic properties of thaHium(III) ttifluoroacetate makes it a very important thaHation reagent. The products of thaHation, eg, arylthaHium bis(ttifluoracetate), undergo a variety of substitution reactions, yielding iodides, fluorides, nitriles, thiophenols, phenols, and biaryls. 

Substitution reactions by the ionization mechanism proceed very slowly on a-halo derivatives of ketones, aldehydes, acids, esters, nitriles, and related compounds. As discussed on p. 284, such substituents destabilize a carbocation intermediate. Substitution by the direct displacement mechanism, however, proceed especially readily in these systems. Table S.IS indicates some representative relative rate accelerations. Steric effects be responsible for part of the observed acceleration, since an sfp- caibon, such as in a carbonyl group, will provide less steric resistance to tiie incoming nucleophile than an alkyl group. The major effect is believed to be electronic. The adjacent n-LUMO of the carbonyl group can interact with the electnai density that is built up at the pentacoordinate carbon. This can be described in resonance terminology as a contribution flom an enolate-like stmeture to tiie transition state. In MO terminology,.the low-lying LUMO has a... 

Nucleophilic substitution by cyanide ion (Sections 8.1, 8.13) Cyanide ion is a good nucleophile and reacts with alkyl halides to give nitriles. The reaction is of the S m2 type and is limited to primary and secondary alkyl halides. Tertiary alkyl halides undergo elimination aryl and vinyl halides do not react. 

Closely related to the carboxylic acids and nitriles discussed in the previous chapter are the carboxylic acid derivatives, compounds in which an acyl group is bonded to an electronegative atom or substituent that can net as a leaving group in a substitution reaction. Many kinds of acid derivatives are known, but we ll be concerned primarily with four of the more common ones acid halides, acid anhydrides, esters, and amides. Esters and amides are common in both laboratory and biological chemistry, while acid halides and acid anhydrides are used only in the laboratory. Thioesters and acyl phosphates are encountered primarily in biological chemistry. Note the structural similarity between acid anhydrides and acy) phosphates. 

Arylamines are converted by diazotization with nitrous acid into arenediazonium salts, ArN2+ X-. The diazonio group can then be replaced by many other substituents in the Sandmeyer reaction to give a wide variety of substituted aromatic compounds. Aryl chlorides, bromides, iodides, and nitriles can be prepared from arenediazonium salts, as can arenes and phenols. In addition to their reactivity toward substitution reactions, diazonium salts undergo coupling with phenols and arylamines to give brightly colored azo dyes. 

Michael reaction, 894-895 mutarotation. 986 nitrile hydrolysis, 768-769 nucleophilic acyl substitution reaction. 790... 

Addition and substitution reactions of nitrile-stabilized carbanions S. Arseniyadis, K. S. Kyler and D. S. Watt, Organic Reactions 31,1 (1984). Note. Includes ArC (OTMS)CN, and HetAr (OTMS)CN. 

Salts of aliphatic or aromatic carboxylic acids can be converted to the corresponding nitriles by heating with BrCN or CICN. Despite appearances, this is not a substitution reaction. When R COO was used, the label appeared in the nitrile, not in the C02, and optical activity in R was retained. The acyl isocyanate... 

As noted in Section 11.2.2, nucleophilic substitution of aromatic halides lacking activating substituents is generally difficult. It has been known for a long time that the nucleophilic substitution of aromatic halides can be catalyzed by the presence of copper metal or copper salts.137 Synthetic procedures based on this observation are used to prepare aryl nitriles by reaction of aryl bromides with Cu(I)CN. The reactions are usually carried out at elevated temperature in DMF or a similar solvent. 

In Section 8.2.3.2, we discussed arylation of enolates and enolate equivalents using palladium catalysts. Related palladium-phosphine combinations are very effective catalysts for aromatic nucleophilic substitution reactions. For example, conversion of aryl iodides to nitriles can be done under mild conditions with Pd(PPh3)4 as a catalyst. 

Another important click reaction is the cycloaddition of azides. The addition of sodium azide to nitriles to give l//-tetrazoles is shown to proceed readily in water with zinc salts as catalysts (Eq. 11.71).122 The scope of the reaction is quite broad a variety of aromatic nitriles, activated and nonactivated alkyl nitriles, substituted vinyl nitriles, thiocyanates, and cyanamides have all been shown to be viable substrates for this reaction. The reaction of an arylacetylene with an azide in hot water gave 1,4-disubstituted 1,2,3-triazoles in high yields,123 while a similar reaction between a terminal aliphatic alkyne and an azide (except 111 - nitroazidobenzcnc) afforded a mixture of regioisomers with... 

Owing to the good ligand properties of isocyanides for complexation of gold(i), complexes of the type [(RNC)2Au]+X are readily available through a variety of synthetic routes. One new approach is the substitution of organic nitriles. The reaction is carried out in acetonitrile and gives quantitative yields (Equation (43)).2... 

Thioamides have been transformed into the corresponding nitriles. Treatment of primary thioamides by tellurium tetrachloride or selenium tetrachloride in combination with triethylamine affords nitriles.66 Treatment of primary amides and thioamides with l-(3-dimethylaminopropyl)-3-ethylcarbodiimide hydrochloride (EDCI) gives nitriles.67 Reactions of thioamides with metal carboxylates in organic solvents enables the selective preparation of nitriles, imides or amides depending on the substitution pattern of the starting material (Scheme 33).68... 

Machiguchi, Nozoe and coworkers have very recently observed that in contrast to chemical reactivity of tropones, the tosylate of tropone oxime undergoes a facile ring-opening to 6-substituted (Z,Z,Z)-1,3,5-hexatriene nitriles on reaction with various nucleophiles305. For example, reaction of phenyl lithium results in the corresponding hexatriene carbonitrile (equation 183). 

Cycloalkene Derivatives Cyclopropenes readily interact with nitrile oxides. Reactions of a broad series of 3,3-disubstituted cyclopropenes with 4-substituted benzonitrile, methoxycarbonyl- and cyanoformonitrile oxides (229) as well as with di(isopropoxy)phosphorylformonitrile oxide (230) give 2-oxa-3-azabicyclo[3.1.0]hexene derivatives 62. Stereoselectivity of the cycloaddition is governed by both steric and polar factors. In particular, steric factors are supposed to prevail for 3-methyl-3-phenylcyclopropene affording 62 [R1 =... 

Insertion of phenyl, trimethylsilyl, and nitrile-stabilized metalated epoxides into zircona-cyclcs gives the product 160, generally in good yield (Scheme 3.37). With trimethylsilyl-substituted epoxides, the insertion/elimination has been shown to be stereospecific, whereas with nitrile-substituted epoxides it is not, presumably due to isomerization of the lithiated epoxide prior to insertion [86]. With lithiated trimethylsilyl-substituted epoxides, up to 25 % of a double insertion product, e. g. 161, is formed in the reaction with zirconacyclopentanes. Surprisingly, the ratio of mono- to bis-inserted products is little affected by the quantity of the carbenoid used. In the case of insertion of trimethylsilyl-substituted epoxides into zirconacydopentenes, no double insertion product is formed, but product 162, derived from elimination of Me3SiO , is formed to an extent of up to 26%. 

The addition of sodium azide to nitriles to give IH-tetrazoles is shown to proceed readily in water with zinc salts as catalysts. The scope of the reaction is quite broad a variety of aromatic nitriles, activated and unactivated alkyl nitriles, substituted vinyl nitriles, thiocyanates, and cyanamides have all been shown to be viable substrates for this reaction. 

---