NFPA Hazard Ratings

NFPA 704 is a voluntary standard. Table 5 lists the five degrees of hazard defined in NFPA 704. The NFPA hazard rating system primarily relies on qualitative criteria and judgment to assign chemical... 

The following table provides a listing of chemicals along with their NFPA hazard ratings. Refer to Chapter 1 for a definition of the hazard ratings. The terms W and oxy refer to water reactive and oxidizer, respectively. 

The author of this text considered HAZCOM as the process employee s best friend because of its requirement for a MSDS which is accessible in all the control rooms either as documents in binders or electronic documents on the site intranet. As a supervisor, the author advised all newly hired process employees to read the MSDS for each of the chemicals on their unit and take careful note of all NFPA hazard ratings of three or four. They were to think of a hazard rating of three or four as a coiled cobra prepared to strike. If the cobra bites them, it will hurt them very badly if not kill them. If they make a mistake with a chemical that has a hazard rating of three or four it is going to hurt them badly, if not kill them. 

NFPA Hazard Rating. The National Fire Protection Agency s rating system that addresses the health, flammability, reactivity, and related hazards of a material which may exist due to a short-term, acute exposure caused by a fire, spill, or similar emergency. 

In the USA flammable liquids are divided into six categories, again based on their flash point and boiling point as shown in Table 4.5. These are used in the NFPA hazard rating system [23] to provide a numerical rating of 0-4 for the three regular hazards health flammability and reactivity. Thousands of materials including solvents are covered. 

NFPA Hazard Diamond See NFPA Hazard Rating. 

FIGURE N.1 NFPA hazard rating. (Photo courtesy of D. P. Nolan.)... 

Analyzing toxicity from the point of view of NFPA hazard rating system, the nucleating agents have health rating of 0-1 (exception catbon nanotubes 1-2), This means either no unusual hazard or may be irritating . Also flammability and reactivity ratings are low (in most cases 0-1). 

Name NFPA Hazard Rating (H/F/R) Toxicity Global Reaction Efficiency Losses... 

Flammability Acetone is extremely flammable. The NFPA hazard rating is 3 (serious). In addition, poisonous gases are produced in fire. 

---