Negative ions observations

A type of molecular resonance scattering can also occur from the formation of short-lived negative ions due to electron capture by molecules on surfrices. While this is frequently observed for molecules in the gas phase, it is not so important for chemisorbed molecules on metal surfaces because of extremely rapid quenching (electron transfer to the substrate) of the negative ion. Observations have been made for this scattering mechanism in several chemisorbed systems and in phys-isorbed layers, with the effects usually observed as smaU deviations of the cross section for inelastic scattering from that predicted from dipole scattering theory. 

A similar kinetic model has been developed for the measurement of ion complex formation kinetics and energies involving both dissociative and nondissociative electron capture, for example, the hydration of halide ions and of 02( ). The ratio of negative ions observed in NIMS can be used to determine energies of complex formation. In this case the sequential formation of the higher complexes must be added to the kinetic model. These studies are important because they demonstrate that the API mass spectrometer can be used to measure thermodynamic quantities. When we use the data for hydrates of 02(—) as an example, the kinetic expression is given by... 

The only primary negative ion observed was I, which underwent charge exchange with I2 so that I2 was formed by the reaction... 

The astrochemistty of ions may be divided into topics of interstellar clouds, stellar atmospheres, planetary atmospheres and comets. There are many areas of astrophysics (stars, planetary nebulae, novae, supemovae) where highly ionized species are important, but beyond the scope of ion chemistry . (Still, molecules, including H2O, are observed in solar spectra [155] and a surprise in the study of Supernova 1987A was the identification of molecular species, CO, SiO and possibly ITf[156. 157]. ) In the early universe, after expansion had cooled matter to the point that molecules could fonn, the small fraction of positive and negative ions that remained was crucial to the fomiation of molecules, for example [156]... 

By using a beam of fast atoms or ions incident onto a nonvolatile liquid containing a sample substance, good molecular or quasi-molecular positive and/or negative ion peaks can be observed up to about 4000-5000 Da. Ionization is mild, and, since it is normally carried out at 25-35°C, it can be used for thermally labile substances such as peptides and sugars. 

Bombardment of a liquid surface by a beam of fast atoms (or fast ions) causes continuous desorption of ions that are characteristic of the liquid. Where the liquid is a solution of a sample substance dissolved in a solvent of low volatility (often referred to as a matrix), both positive and negative ions characteristic of the solvent and the sample itself leave the surface. The choice of whether to examine the positive or the negative ions is effected simply by the sign of an electrical potential applied to an extraction plate held above the surface being bombarded. Usually, few fragment ions are observed, and a sample of mass M in a solvent of mass S will give mostly [M + H] (or [M - H] ) and [S -I- H]+ (or [S - H] ) ions. Therefore, the technique is particularly good for measurement of relative molecular mass. 

Mostly, positive-ion FAB yields protonated quasi-molecular ions [M -i- H]+, and the negative-ion mode yields [M - H]. In the presence of metal salts (e.g., KCl) that are sometimes added to improve efficiency in the LC column, ions of the type [M -i- X]+are common, where X is the metal. Another type of ion that is observed is the so-called cluster, a complex of several molecules with one proton, [M -i- H]+ with n = 1, 2, 3,. .., etc. Few fragment ions are produced. 

Using a set of (partial) atomic charges is often called the generalized Born model. It can be noted that the Born model predicts equal solvation for positive and negative ions of the same size, which is not the observed behaviour in solvents like H2O. 

Near room temperature there is scarcely any difference between the two. When a deuteron has been removed from a molecule in D20, the electrostatic energy associated with the negative ion will scarcely differ from that associated with the field of a similar ion in H20 from which a proton has been removed. Furthermore, the energy associated with the electric field surrounding a (D30)+ ion in D20 will scarcely differ from that of the field surrounding a (H30)+ ion in 1I20. We must conclude then that the observed differences between the degrees of dissociation of weak acids in D20 and H20 are due entirely to a difference in the quantum-mechanical forces. 

Furlei and coworkers44 studied the negative ion mass spectra of several cyclic sulfones (82-98) upon dissociative electron capture and concluded that the negative molecular ions were notably stabilized by the introduction of electron-withdrawing substituents and/or unsaturation. Some difference was found in the negative ion mass spectra of configurational isomers (85 vs. 86 and 87 vs. 88) in contrast to the situation in their positive ion spectra. A strong S02 ion (m/z 64) was observed also for all the compounds studied. 

Reactions of D with D20 and of 0 with 02, N20, and N02 have been studied with a magnetic sector mass spectrometer. Competition between electron transfer and ion-atom interchange has been observed in the production of 02 by reaction of 0 with 02, an endothermic reaction. The negative ion of the reacting neutral molecule is formed in 02, N2Of and N02 but not in D20. Rate constants have been estimated as a function of repeller potential. 

As mentioned above, negative ion currents at m/e 32, 44, and 46 were observed. The current at m/e 32 varied with the second power of the sample pressure and showed the same dependence upon electron energy as the m/e 16 current. The reaction ... 

Origin of Ions in Hydrocarbon Flames. Many ions, both positive and negative, are observed in hydrocarbon flames studied by mass spectrometric methods (9, 14, 26). Most of these are produced by ion-molecule reactions following the formation of primary ions from neutral species. 

Since under Green s conditions, a 10-7 cm.3 molecule-1 sec.-1 (unpublished experiments at AeroChem), n+ ne- 1011 cm.-3, /iH2o 3 X 1017 cm.-3, and n0h- 109 cm.-3, then kz 3 X 10-16 cm.3 molecule-1 sec.-1 This is some three orders of magnitude greater than the maximum value of kz calculated on the basis of Buchel nikova s data. Therefore, dissociative attachment of electrons to water is too slow to account for the observed concentrations of negative ions. 

The work of Bleekrode and Nieuwpoort (3) suggests that at 1 torr in a stoichiometric C2H2/02 flame, tic2 1013 cm.-3 The observed rate of production of negative ions would thus necessitate a three-body rate constant for attachment of electrons to C2 of about 5 X 10-28 cm.6 molecule-2 sec.-1 This seems somewhat high but is not altogether impossible. 

Flames, either with or without metallic additives, are rich in ion-molecule reactions of both positive and negative ions. The use of flames as media in which these reactions may be studied over broad ranges of temperature and pressure is in its infancy. Most of the phenomena observed can be explained qualitatively, and some quantitative results have been obtained. 

Carbocations are intermediates in several kinds of reactions. The more stable ones have been prepared in solution and in some cases even as solid salts, and X-ray crystallographic structures have been obtained in some cases. An isolable dioxa-stabilized pentadienylium ion was isolated and its structure was determined by h, C NMR, mass spectrometry (MS), and IR. A P-fluoro substituted 4-methoxy-phenethyl cation has been observed directly by laser flash photolysis. In solution, the carbocation may be free (this is more likely in polar solvents, in which it is solvated) or it may exist as an ion pair, which means that it is closely associated with a negative ion, called a counterion or gegenion. Ion pairs are more likely in nonpolar solvents. 

To check the identity and purity of the products obtained in the above reactions it is not sufficient to analyze for the sulfur content since a mixture may incidentally have the same S content. Either X-ray diffraction on single crystals or Raman spectra of powder-like or crystalline samples will help to identify the anion(s) present in the product. However, the most convincing information comes from laser desorption Fourier transform ion cyclotron resonance (FTICR) mass spectra in the negative ion mode (LD mass spectra). It has been demonstrated that pure samples of K2S3 and K2S5 show peaks originating from S radical anions which are of the same size as the dianions in the particular sample no fragment ions of this type were observed [28]. 

These arise either by an analogous process to that described above for Cl, i.e. the adduction of a negatively charged species such as Cl , and the abstraction of a proton to generate an (M — H) ion, or by electron attachment to generate an M ion. The ions observed in the mass spectrum are dependent on the species generated by the reagent gas and the relative reactivities of these with each other and with the analyte molecule. 

Electrospray is the softest mass spectrometry ionization technique and electrospray spectra therefore usually consist solely of molecular ions. Electrospray is unique, however, in that if the analyte contains more than one site at which protonation (in the positive-ion mode) or deprotonation (in the negative-ion mode) may occur, a number of molecular ions with a range of charge states is usually observed. For low-molecular-weight materials (< 1000 Da), the number of sites... 

In practice, the valne depends on the type of analysis being attempted. Structural studies may require the extent of fragmentation to be maximized, while quantification may require the opposite, i.e. the efficient prodnction of a small number of ions of different m/z ratios, in order to maximize sensitivity. Selectivity may be obtained simply by monitoring of the molecular ions formed. On occasions, when significant background is observed, this may not be adequate and fragmentation of the molecnlar species may be necessary to provide a number of ions to be monitored. Some componnds may be ionized very effectively under positive-ionization conditions, while others may require the formation of negative ions to allow analysis. 

---