2- naphthaldehydes

Decant the ethereal solution from the yellow aldimine stannichloride which has separated, rinse the solid with two 50 ml. portions of ether, and transfer the solid to a 2-5 litre flask fitted for steam distillation and immersed in an oil bath at 110-120°. Pass steam through a trap (compare Fig. 11,40, 1,6) to remove condensed water, then through a superheater heated to 260° (Fig. I, 7, 2), and finally into the mixture (2). Continue the passage of y steam until the aldehyde is completely removed (4-5 litres 8-10 hours). Filter the white soUd at the pump, and dry in the air. The resulting p-naphthaldehyde, m.p. 53-54°, weighs 12 g. It may be further purified by distillation under diminished pressure (Fig. II, 19, ) -, pour the colourless distillate, b.p. 156-158°/15 mm., while hot into a mortar and powder it when cold. The m.p. is 57- 58°, and the recovery is over 90 per cent. 

In a 500 ml. flask, fitted with a reflux condenser, place 53 g. of 1-chloro-methylnaphthalene (Section IV.23), 84 g, of hexamethylenetetramine and 250 ml. of 1 1 acetic acid [CAUTION 1-Chloromethylnaphtha-lene and, to a lesser degree, a-naphthaldehyde have lachrymatory and vesicant properties adequate precautions should therefore be taken to avoid contact with these substances.] Heat the mixture under reflux for 2 hours it becomes homogeneous after about 15 minutes and then an oil commences to separate. Add 100 ml. of concentrated hydrochloric acid and reflux for a further 15 minutes this will hydrolyse any SchifiF s bases which may be formed from amine and aldehyde present and will also convert any amines into the ether-insoluble hydrochlorides. Cool, and extract the mixture with 150 ml. of ether. Wash the ether layer with three 50 ml. portions of water, then cautiously with 50 ml. of 10 per cent, sodium carbonate solution, followed by 50 ml. of water. Dry the ethereal solution with anhydrous magnesium sulphate, remove the ether by distillation on a steam bath, and distil the residue under reduced pressure. Collect the a-naphthaldehyde at 160-162718 mm. the yield is 38 g. 

P-Naphthaldehyde. This preparation illustrates the use of -bromo-succinimide (Section VI.26) in the conversion of the readily available P-methylnaphthalene into 2-bromomethylnaphthalene and of the latter into p-naphthaldehyde by the Sommelet reaction. 

P-Hydroxy-a-naphthaldehyde, Equip a 1 litre three-necked flask with a separatory funnel, a mercury-sealed mechanical stirrer, and a long (double surface) reflux condenser. Place 50 g. of p-naphthol and 150 ml. of rectified spirit in the flask, start the stirrer, and rapidly add a solution of 100 g. of sodium hydroxide in 210 ml. of water. Heat the resulting solution to 70-80° on a water bath, and place 62 g. (42 ml.) of pure chloroform in the separatory funnel. Introduce the chloroform dropwise until reaction commences (indicated by the formation of a deep blue colour), remove the water bath, and continue the addition of the chloroform at such a rate that the mixture refluxes gently (about 1 5 hours). The sodium salt of the phenolic aldehyde separates near the end of the addition. Continue the stirring for a further 1 hour. Distil off the excess of chloroform and alcohol on a water bath use the apparatus shown in Fig. II, 41, 1, but retain the stirrer in the central aperture. Treat the residue, with stirring, dropwise with concentrated hydrochloric acid until... 

Chapter IV. a-Chloromethylnaphthalene (IV,23) benzylamine (Gabriel synthesis) (IV,39) i r.N -dialkylanilines (from amines and trialkyl orthophosphates) (IV,42) a-naphthaldehyde (Sommelet reaction) (IV,120) a-phenyl-cinnamic acid (Perkin reaction using triethylamine) (IV,124) p-nitrostyrene (IV,129) p-bromonaphthalene and p naphthoic acid (from 2 naphthylamine-1 -sulphonic acid) (IV,62 and IV,164) diphenic acid (from phenanthrene) (IV,165). 

The concentration of aluminum in serum can be determined by adding 2-hydroxy-1-naphthaldehyde p-methoxybenzoyl-hydrazone and measuring the initial rate of the resulting complexation reaction under pseudo-first-order conditions.The rate of reaction is monitored by the fluorescence of the metal-ligand complex. Initial rates, with units of emission intensity per second, were measured for a set of standard solutions, yielding the following results... 

Noncatalytic Reactions Chemical kinetic methods are not as common for the quantitative analysis of analytes in noncatalytic reactions. Because they lack the enhancement of reaction rate obtained when using a catalyst, noncatalytic methods generally are not used for the determination of analytes at low concentrations. Noncatalytic methods for analyzing inorganic analytes are usually based on a com-plexation reaction. One example was outlined in Example 13.4, in which the concentration of aluminum in serum was determined by the initial rate of formation of its complex with 2-hydroxy-1-naphthaldehyde p-methoxybenzoyl-hydrazone. ° The greatest number of noncatalytic methods, however, are for the quantitative analysis of organic analytes. For example, the insecticide methyl parathion has been determined by measuring its rate of hydrolysis in alkaline solutions. 

Hydroxy-l-naphthaldehyde [708-06-5] M 172.2, m 82 , b 192 /27mm, pKes, -7.8. Crystd from EtOH (1.5mL/g), ethyl acetate or water. 

The intermediacy of dipolar species such as 186 has been demonstrated by reaction of enamines with 2-hydroxy-1-aldehydes of the aromatic series (129). The enamine (113) reacts in benzene solution at room temperature with 2-hydroxy-1-naphthaldehyde to give the crystalline adduct (188) in 91 % yield. Oxidation with chromium trioxide-pyridine of 188 gave 189 with p elimination of the morpholine moiety. Palladium on charcoal dehydrogenation of 189 gave the known 1,2-benzoxanthone (129). 

Naphtoe-aldehyd, n. naphthaldehyde, naphthoic aldehyde, -skure, /. naphthoic acid. 

Although phenylmagnesium bromide and zinc chloride do form an equilibrium mixture of diphenylzinc and magnesium halide, diphenylzinc is not thought to be the actual organometal-lic reagent in this addition reaction. In fact, even at room temperature, the addition reaction of pure diphenylzinc to 2-naphthaldehyde in the presence of 21 is very slow, affording little of the addition product. 

In Refomiatsky reactions of + )-trans-(2-phenyleyclohex-l-yl)bromoacetaie with benz-aldehydc, acetophenone. 1-naphthaldehyde and butanal, the corresponding /1-hydroxycarboxylic acids arc obtained, after saponification, in 11-89% ee ... 

The reaction of butyllithium with 1-naphthaldehyde cyclohexylimine in the presence of (/C )-l,2-diphenylethane-1,2-diol dimethyl ether in toluene at —78 °C, followed by treatment with acetate buffer, gave 2-butyl-1,2-dihydronaphthalene-l-carbaldehyde, which was then reduced with sodium borohydride in methanol to afford (1 R,2.S)-2-butyl-1 -hydroxymcthyl-1,2-dihydronaphthalene in 80% overall yield with 91 % ee83. Similarly, the enantioselective conjugate addition of organolithium reagents to several a,/J-unsaturated aldimines took place in the presence of C2-symmetric chiral diethers, such as (/, / )-1,2-butanediol dimethyl ether and (/, / )- ,2-diphenylethane-1,2-diol dimethyl ether. 

The testing of 2-nitrobenzyltriphenylphosphonium bromide and methyl 4-formylbenzoate and four other aldehydes, 3-benzyloxybenzaldehyde, 2-naphthaldehyde, 5-nitrothiophene-2-carboxaldehyde and 4-[3-dimethylamino)propoxy]benzaldehyde, has been reported [13]. 

---