Phenolic molding

Molded articles Molded phenolic parts Molded rubber products... [Pg.641]

Molded flexible foam products, 25 470 Molded materials, ionomers in, 14 482—483 Molded phenolic parts, applications for, 18 786t... [Pg.594]

TABLE 15.16 "typical Properties of Molded Phenolic Plastics... [Pg.658]

Molded phenolic resins Benzylamine (at 200°C) All common solvents... [Pg.376]

Acetone extraction n. In molded phenolic products, the amount of acetone-soluble material that can be extracted from the material is an indication of the degree of cure. [Pg.14]

The causes of irritant contact dermatitis (20 cases) were wet work (3 cases), soaps and detergents (3 cases), physical and mechanical agents (3 cases), barley flour, grains or feed (2 cases), and clay, inorganic acids and alkalis, molds, phenol formaldehyde resin and salicylic acid (1 case each), unspecified chemical agent (3 cases), and another unspecified agent (1 case). [Pg.989]

Phenolics Molded Phenolics Molded (ASTM D651)... [Pg.1592]

MOLDED PHENOL FORMALDEHYDE, (Durez) PHENOL FURFURAL PLASTICS urea FORMALDEHYDE CASEIN PLASTICS EPOXY REilWii... [Pg.806]

Post-Treatment. A post-bake (post-curing) can have a beneficial effect on the thermal stability and dimensional stability of phenolic molded parts. Early work showed that the glass transition temperature Tg) increases with cure in phenolics.More recently it has become apparent that the Tg of an as-molded phenolic novolak part strongly influences the post-bake conditions to be used. If parts are molded above the Tg, an unacceptable expansion can occur 102,103 continues to increase during... [Pg.330]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...