Liquid mobile phase, chromatography

D. E. Martire, Unified Approach to the Theory of Chromatography Incompressible Binary Mobile Phase (Liquid Chromatography) in Theoretical Advancement in Chromatography and Related Separation Techniques (Ed. F. Dondi, G. Guiochon, IGuwer, Academic Publishers, Dordrecht, The Netherlands,(l993)261. 

One of the first examples of the application of reverse-phase liquid chromatography-gas chromatography for this type of analysis was applied to atrazine (98). This method used a loop-type interface. The mobile phase was the most important parameter because retention in the LC column must be sufficient (there must be a high percentage of water), although a low percentage of water is only possible when the loop-type interface is used to transfer the LC fraction. The authors solved this problem by using methanol/water (60 40) with 5% 1-propanol and a precolumn. The experimental conditions employed are shown in Table 13.2. 

Figure 4-1. Components of a simple liquid chromatography apparatus. R Reservoir of mobile phase liquid, delivered either by gravity or using a pump. C Glass or plastic column containing stationary phase. F Fraction collector for collecting portions, called fractions, of the eluant liquid in separate test tubes.

The popularity of reversed-phase liquid chromatography (RPC) is easily explained by its unmatched simplicity, versatility and scope [15,22,50,52,71,149,288-290]. Neutral and ionic solutes can be separated simultaneously and the rapid equilibration of the stationary phase with changes in mobile phase composition allows gradient elution techniques to be used routinely. Secondary chemical equilibria, such as ion suppression, ion-pair formation, metal complexatlon, and micelle formation are easily exploited in RPC to optimize separation selectivity and to augment changes availaple from varying the mobile phase solvent composition. Retention in RPC, at least in the accepted ideal sense, occurs by non-specific hydrophobic interactions of the solute with the... 

Figure 4.29 An example of the use of ternary solvents to control mobile phase strength and selectivity in reversed-phase liquid chromatography. A, methanol-water (50 50) B, tetrahydrofuran-water (32 68) C, methanol-tetrahydrofuran-water (35 10 55). Peak identification 1 - benzyl alcohol 2 phenol 3 3-phenylpropanol 4 2,4-dimethylphenol 5 benzene and 6 -diethylphthalate. (Reproduced with permission from ref. 522. Copyright Elsevier Scientific Publishing Co.)...

Solvent optimization in reversed-phase liquid chromatography is commenced by selecting a binary mobile phase of the correct solvent strength to elute the seuaple with an acceptable range of capacity. factor values (1 < k <10 in general or 1 < k < 20 when a larger separation capacity is required). Transfer rules (section 4.6.1) are then used to calculate the composition of other isoeluotropic binary solvents with complementary selectivity. In practice, methanol, acetonitrile and tetrahydrofuran are chosen as the selectivity adjusting solvents blended in different... 

Figure 8.43 Separation of enantiomers using complexation chromatography. A, Separation of alkyloxiranes on a 42 m x 0.2S mm I.O. open tubular column coated with 0.06 M Mn(II) bis-3-(pentafluoro-propionyl)-IR-camphorate in OV-ioi at 40 C. B, Separation of D,L-amino acids by reversed-phase liquid chromatography using a mobile phase containing 0.005 M L-histidine methyl ester and 0.0025 M copper sulfate in an ammonium acetate buffer at pH 5.5. A stepwise gradient using increasing amounts of acetonitrile was used for this separation.

The mechanism of reversed phase chromatography can be understood by contrast with normal phase chromatography. Normal phase liquid chromatography (NPLC) is usually performed on a polar silica stationary phase with a nonpolar mobile phase, while reversed phase chromatography is performed on a nonpolar stationary phase with a polar mobile phase. In RPLC, solute retention is mainly due to hydrophobic interactions between the solutes and the nonpolar hydrocarbon stationary surface. The nonpolar... 

A comprehensive 2D HPLC can be carried out with two very similar columns in reversed-phase liquid chromatography (Ikegami et al., 2005). A mixture of water and tetrahydrofuran was used as a mobile phase in the lst-D separation, and a mixture of water and methanol (CH3OH) in the 2nd-D separation with a common Ci8 stationary phase. 

Ikegami, T., Hara, T., Kimura, H., Kobayashi, H., Hosoya, K., Cabrera, K., Tanaka, N. (2005). Two dimensional reversed-phase liquid chromatography using two monolithic silica C18 columns and different mobile-phase modifiers in the two dimensions. J. Chromatogr. A, Forthcoming. 

The second group of recently developed ionic liquids is often referred to as task specific ionic liquids in the literature [15]. These ionic liquids are designed and optimised for the best performance in high-value-added applications. Functionalised [16], fluorinated [17], deuterated [18] and chiral ionic liquids [19] are expected to play a future role as special solvents for sophisticated synthetic applications, analytical tools (stationary or mobile phases for chromatography, matrixes for MS etc.), sensors and special electrolytes. 

Mobile phase in chromatography, the phase (gaseous or liquid) responsible for moving an introduced sample through a porous medium to separate components of interest. 

Don, X., Wang, H., and Han, J.Y., Molecular dynamics simulation of the effects of mobile-phase modification on interactions in reversed-phase liquid chromatography, J. Liq. Chromatogr. Relat. TechnoL, 29, 2559, 2006. 

Hafkenscheid, T.L. and Tomlinson, E. Relationships between hydrophobic (lipophilic) properties ofbases and their retention in reversed-phase liquid chromatography using aqueous methanol mobile phases. J. Chromatogr. A, 292(2) 305-317, 1984. 

Waichigo, M. M., and Danielson, N. D., Comparison of ethylammonium formate to methanol as a mobile-phase modifier for reversed-phase liquid chromatography, /. Sep. Sci., 29,599-606, 2006. 

---