Minimum Monitoring Requirements

Food-grade Tara gum is obtained by the purification of the endosperm. The determination of moisture, protein, and acid-insoluble residue, generally regarded as the minimum monitoring requirement, tests the efficiency of the purification process The presence of the germ is reflected in a high protein, shell residues show a high acid-insoluble residue. Moisture contents of above 15% or lower than 8%, excess moisture balance and indicate an abnormal treatment at some point or points from the harvest of the seed until the powder. 

The contractor at Site H had established area and personnel sampling consistent with HAZWOPER requirements. A photo ionization detector (PID) and a real-time aerosol monitor (RAM) were used on a daily basis to screen for potentially hazardous levels of contaminants. On a weekly basis, personal air samples were collected and submitted for laboratory analysis. PPE requirements, however, were often not based on this data because the oversight agency had established inflexible minimum PPE requirements. The audit team found many of the PPE requirements on Site H to be excessive in light of site monitoring data and hazard determinations. 

Minimum computer requirements to run THERdbASE are a 486 CPU, IBM or clone, at leasi 8 MB of RAM, at least 40 MB of disk space, color VGA monitor, a mouse, Microsoft Windows. v I To install THERdbASE, execute the File/Run option from within Windows and specify SETUP.F.XE found in the THERDCD directory. This program leads you through the installation. Updates foi THERdbASE can be obtained over the World Wide Web from the Harry Reid Center for Environmental Studies at the University of Nevada, Las Vegas (http //www.eeynre. -hrc, nevada.edu),... 

The most important determinant of appropriate dosing is clinician s judgment of the patients response to therapy the clinician must monitor the patients response in terms of clinical control and adjust the dose accordingly. Once control of asthma is achieved, the dose medication should be carefully titrated to the minimum dose required to marntam control, thus reducing the potential for adverse effects. 

The reaction conditions used in solution synthesis are generally adapted to the SPS the reaction times are usually increased, the reagents in solution are added in excess, and their concentration is increased to drive the SPS steps to completion. Typical experimental conditions are three- to fivefold excess of solution reagents and 0.2-1 M concentrations, while the optimal reaction time is evaluated via on-bead (FTIR) or off-bead reaction monitoring. If the reagents in solution are precious, a smdy to determine the minimum excess required to drive the reaction to completion will be necessary. 

A typical cycle requires about 1 sec. The masses of the ions are detected with a certain resolution m/5m, where 5m is the minimum difference required for two masses to be resolved. Magnetic sector instruments may work at low resolution (e.g. 1000) or at high resolution (10000 or higher). Magnetic sector systems can have excellent sensitivity (5 10 C pg ). Besides the scan mode, the mass spectrometers may work at a fixed m/z (or at a few selected m/z values), which is called single ion monitoring (SIM). 

L.7.1.4.4 The team shouid review the avaiiabie information and fiii out Tabie L.1 to determine whether the equipment shouid be approved for use and to identify any minimum practices required for successfui operation. Per the approvai section, devices having the not approved or pending box checked wiii not be added to the approved iist. Where data is oniy sufficient to support use in a controi or diagnostic/monitoring appiication, this shouid be indicated by a mark in appropriate data coiumn of the approved iist. if a device is approved for use in a safety appiication, but with restrictions, those restrictions wiii aiso be documented in the approved iist, e.g., oniy approved for river water service, etc. 

For 3-D modeling and FEA applications, a Pentium 100 MHz processor running on a 32-bit Windows NT operating system works significantly better. The minimum memory requirement for Windows NT is 32 MB and the operating system requires 160 MB of hard-drive space. The system should have a 16-K internal cache with 256 K to 512 K of external cache for increased performance. The monitor for these applications should be 21 inch with 0.25 ultrafine dot pitch, high resolution (1600 x 1280), and 65,536 colors Peripheral component interconnect (PCI) local bus (a high-bandwidth, processor-independent bus) and a minimum 1-GB SCSI-2 hard drive are also required. 

What is the minimum number and types of fixed radiation monitors required to be operable by Technical Specifications ... 

Use most-effective sampling and monitoring techniques, test methods, recordkeeping systems or reporting protocols (beyond minimum legal requirements) ... 

---