Metallocenes classification

Metallocenes with substituted cyclopentadienyl rings. Metallocenes with methylated rings were among the first heavy alkaline earth metallocenes to be structurally characterized, but many other substituents have been incorporated into bis(cyclopentadienyl) complexes. Under this classification are included compounds with indenyl ligands, which in... 

Norbornene-ethene copolymer, 16 113 Norbornene-ethylene copolymers, 20 433 physical properties of, 20 420-422 Norbornenodiazetine derivatives, 13 306 Nordel IP (metallocene), 7 637 Nordihydroguaiaretic acid, antioxidant useful in cosmetics, 7 830t Nordstrandite, 2 421, 425 activation, 2 394 classification, 2 422 decomposition sequence, 2 392 from gelatinous boehmite, 2 427 structural properties of, 2 423t NO-reduction reactions, TWC catalyst, 10 49... 

For films. Table 4.1 proposes an arbitrary classification of the polyethylene subfamilies (where m indicates metallocene catalysis). 

Table 1.2 provides a summary of commonly used classifications in the polyethylene industry. A brief note is warranted here to conclude the survey of polyethylene classifications and nomenclature. In the early 1990s, several types of polyethylene manufactured with metallcxiene catalysts (a type of single site catalyst, see Chapter 6) were introduced to the market. To differentiate polyethylene produced with metallocenes from polyethylene manufactured using older conventional catalysts, metallocene grades are sometimes abbreviated mVLDPE, mLLDPE, etc. 

Since, for secrecy reasons, information on new processes and the state of their development is not always published, or only after long delays, the classification applied or recent developments may be misleading. For example, the potential of phase-transfer catalyzed processes may already be more important than the present literature indicates. The same statement could apply for areas such as amidocarbonylation, the synthesis of fine chemicals by means of metallocenes, the reductive/oxidative carbonylation of aromatic amines or nitro derivatives, Heck coupling using palladacycles and heterocyclic carbene complexes, catalytic McMurry coupling, or other proposed methods. Recent developments must therefore leave open the stage of development reached, perhaps signaling that at the time of publication no commercialized, licensable process is yet known to the scientific community. 

There are many complexes of the type [Cp2ML ] (n = l, 3), where M is a transition metal towards the left of the periodic classification (M = Ti, y Zr, Hf, Mo, for example). In these complexes, the CP2M fragment is bent, rather than linear as in the metallocenes. The other bgands are all located in the plane that is perpendicular to that defined by the M atom and the centres of the two Cp rings (3-47 and 3-48). If n = 3, this arrangement imposes very small L—M—L angles (about... 

Classification Metallocene Empin cal C10H10C0 Formula (C5Hs)2Co... 

Classification Metallocenes Empirical CioHioNi Formula (C5H5)2Ni... 

For the synthesis of stereospecific metallocene catalysts for propylene polymerization, C2 symmetric precursors are necessary to obtain a catalyst for isospecific polymerization, and C5 symmetric precursors to produce a catalyst for syndiospecific polymerization. Asymmetric precursors can be used to synthesize metallocene catalysts that produce hemiisotactic and isotactic-stereoblock PP. Farina et al. [7] have proposed an useful classification of metallocene catalysts based on their symmetry (Figure 3). 

FIG. 3 Representative examples of metallocenes with classification by stereoselectivity. 

---