Metal tube drawing

Metals Tube drawing Electric fields - ultrasound... 

One of the consequences of this is that improvements in the cold drawing of metal tubing can be achieved when the die to be used is subjected to radial ultrasonic vibrations. There are several advantages obtained from drawing round products through a die ultrasonically vibrating in a radial mode, these include ... 

The accompanying drawing is taken from the basic US patent 3535063. Pertinent callouts are (2) lamp envelope, (8) initiating assembly, (10) metal tube, (12) wire anvil.,... 

The first commercial metal membranes for hydrogen separation and purification were made of palladium alloyed with 23-25 wt % silver. These membrane were of the unsupported type and tubular in shape. Nevertheless, the wall thickness was substantial by current standards—typically at least 100- an thick. Advances in drawing thin-walled metal tubes has allowed for palladium-silver tubular membranes to be made with much thinner walls, about 20- an thick. Composite membranes are also usually at least 25-/an thick. REB Research and Consulting (Oak Park, MI) provides tubular composite metal membranes consisting of a palladium coating over a tantalum base metal, although other group 4 or 5 base metals may be used. 

Metal wire and tube drawing tools Wear components... 

Cholestenone. Place a mixture of 1 0 g. of purified cholesterol and 0-2 g. of cupric oxide in a test-tube clamped securely at the top, add a fragment of Dry Ice in order to displace the air by carbon dioxide, and insert a plug of cotton wool in the mouth of the tube. Heat in a metal bath at 300-315° for 15 minutes and allow to cool rotate the test-tube occasionally in order to spread the melt on the sides. Warm with a few ml. of benzene and pour the black suspension directly into the top of a previously prepared chromatographic column (1) rinse the test-tube with a little more benzene and pour the rinsings into the column. With the aid of shght suction (> 3-4 cm. of mercury), draw the solution into the alumina column stir the top 0 -5 cm. or so with a stout copper wire to... 

Drawing is a method of reducing the diameter of wire, rod, and tubing. It is similar to extmsion, except that the metal is pulled through the die instead of pushed through it, as shown in Figure 13i. 

The impetus for the synthesis of WC and subsequent development of cemented carbides came from the wire drawing industry where the hard metals are stUl used. The most commonly used grade is WC-6 wt % Co with medium grain size (1—2 p.m). Compositions having higher cobalt content are used in drawing tubes, rods, and bars. 

Defects in finished components can sometimes be traced as far back as casting problems in the ingot or billet from which the component was eventually produced. Defects in welded tubes may be linked to defective metal or to the welding process itself Defects in seamless tubes can originate in extrusion or drawing processes. 

The mobile phase reservoir is made of an inert material, usually glass. There is usually a cap on the reservoir that is vented to allow air to enter as the fluid level drops. The purpose of the cap is to prevent particulate matter from falling into the reservoir. It is very important to prevent particulates from entering the flow stream. The tip of the tube immersed in the reservoir is fitted with a coarse metal filter. It functions as a filter in the event that particulates do find their way into the reservoir. It also serves as a sinker to keep the tip well under the surface of the liquid. In addition, in specially designed mobile phase reservoirs, this sinker/filter is placed into a well on the bottom of the reservoir so that it is completely immersed in solvent, even when the reservoir is running low. This avoids drawing air into the line under those conditions. These details are shown in Figure 13.3. 

---