Metal ions adsorption capacity

The effect of pH on heavy metal ion adsorption capacity was studied by previous researchers using the shake flask experiments. Eric and Roux used the shake flask experiment to study the influence of pH on the heavy metal ion binding onto a fimgus-derived bio-sorbent in the year, 1992. Also the evaluation of the effect of the hydrochloric acid concentration on the adsorption of platinum group metal ions onto chemically modified chitosan was done by Inoue et al., using the shake flask experiment [85]. Depending upon the type of P complexation with the surface such as monodentate, bidentate mononuclear, and bidentate binuclear the phosphorus desorption is potentially controlled. These complexes can be either non protonated or protonated depending on the suspension pH [184]. 

Porosity and pore size distributions, both before and after surface modification, are analyzed from N2 adsorption data. Both capacity as well as adsorption free energies are obtained from metal ion adsorption isotherms from aqueous solution as described in the experimental section. 

In the case of single metal ions adsorption, it has been seen (Fig.l) that the adsorption capacities order following Pb > Cu " > Ni " [16]. Smith and Martell [17] and Makridou et al. [18] have shown that Pb presents a higher stability constant with galacturonic acid than Cu. Moreover, no value are featured for Ni and Makridou et al. [18] assert that a complex between this metal and galacturonic acid does not exist. These results confirm... 

The clay mineral bentonite (sodium montmorillonite) has an excellent ion exchange and adsorption capacity. Films can be applied to electrode surfaces from colloidal clay solutions by simple dip or spin coating that become electroactive after incorporation of electroactive cations or metal particles 136-143)... 

Biosorption is a rather complex process affected by several factors that include different binding mechanisms (Figure 10.4). Most of the functional groups responsible for metal binding are found in cell walls and include carboxyl, hydroxyl, sulfate, sulfhydryl, phosphate, amino, amide, imine, and imidazol moieties.4 90 The cell wall of plant biomass has proteins, lipids, carbohydrate polymers (cellulose, xylane, mannan, etc.), and inorganic ions of Ca(II), Mg(II), and so on. The carboxylic and phosphate groups in the cell wall are the main acidic functional groups that affect directly the adsorption capacity of the biomass.101... 

Spirodela intermedia, L. minor, and P. stratiotes were able to remove Pb(II), Cd(II), Ni(II), Cu(II), and Zn(II), although the two former ions were removed more efficiently. Data fitted the Langmuir model only for Ni and Cd, but the Freundlich isotherm for all metals tested. The adsorption capacity values (K ) showed that Pb was the metal more efficiently removed from water solution (166.49 and 447.95 mg/g for S. intermedia and L. minor, respectively). The adsorption process for the three species studied followed first-order kinetics. The mechanism involved in biosorption resulted in an ion-exchange process between monovalent metals as counterions present in the macrophytes biomass and heavy metal ions and protons taken up from water.112... 

In a separate study, Igwe and Abia46 determined the equilibrium adsorption isotherms of Cd(II), Pb(II), and Zn(II) ions and detoxification of wastewater using unmodified and ethylenediamine tetraacetic acid (EDTA)-modified maize husks as a biosorbent. This study established that maize husks are excellent adsorbents for the removal of these metal ions, with the amount of metal ions adsorbed increasing as the initial concentrations increased. The study further established that EDTA modification of maize husks enhances the adsorption capacity of maize husks, which is attributed to the chelating ability of EDTA. Therefore, this study demonstrates that maize husks, which are generally considered as biomass waste, may be used as adsorbents for heavy metal removal from wastewater streams from various industries and would therefore find application in various parts of the world where development is closely tied to affordable cost as well as environmental cleanliness.46... 

As conclusion, bifunctional fibers having both phosphonic acid and sulfonic acid groups exhibit the characteristic metal ion selectivity and high breakthrough capacities in addition to the extremely fast adsorption rates. Studies on behavior of FPS-f in adsorption of other heavy metals like Fe(III) are now in progress. The bifunctional fiber developed in this work is attractive to application to the protection of the environment because of its extremely rapid adsorption rates and characteristic metal ion selectivity. 

---