Metal electrodes tungsten

Figure 22. The tunneling current, I, measured between two metal electrodes (tungsten en platinum) separated by a vacuum barrier as a function of the difference in electrochemical potential (here denoted as C/emitter-anode) the distance between the two electrodes (12, 20, 17 A) is indicated in the figure. Reprinted from Scanning Probe Microscopy and Spectroscopy , R. Wiesendanger, Cambridge University Press 1994...

In a mirror-polished metal electrode substitute for the tungsten electrode we have a smart mirror. A similar photodetector-actuator automatically darkens a smart mirror in a car when a rear car uses high-beam lights. 

Iron, nickel, cobalt, tungsten and chromium do not behave reproducibly due to crystal strain or oxide coatings. Metal electrodes which respond directly to solutions of their own ions are called Class I or first order. ... 

No effect of the nature of metallic electrodes was found on the tumor destruction,7 38 39 e.g., silver and tungsten electrodes gave results similar to platinum 7 this also means that a slight anodic dissolution of platinum that might occur during the ECT experiment is not responsible for the necrosis of the tumor.7... 

Fig. 5.37. (a) I/V characteristics of typical MDMO-PPV/PCBM solar cells with a LiF/A1 electrode of various LiF thicknesses ( 3 A, 6 A, 12 A) compared to the performance of a MDMO-PPV/PCBM solar cell with a pristine A1 electrode ( ). (b) and (c) are box plots with the statistics of the FF and Voc from 6 separate solar cells. LiF or SiOx were thermally deposited at a rate of 1-2 A/min from a tungsten boat in a vacuum system with a base pressure of 10-4 Pa. We emphasize that, for thickness values of the order of 1 nm, LiF/SiOx does not form a continuous, fully covering layer, but instead consists of island clusters on the surface of the photoactive layer. Slow evaporation conditions are essential for more homogenous distribution of the LiF on the organic surface. The nominal thickness values given here represent an average value across the surface of the substrate. The metal electrode (either aluminum or gold) was thermally deposited with a thickness of 80 nm... 

Ultraviolet light sources are based on the mercury vapor arc. The mercury is enclosed ia a quart2 tube and a potential is appHed to electrodes at either end of the tube. The electrodes can be of iron, tungsten, or other metals and the pressure ia a mercury vapor lamp may range from less than 0.1 to >1 MPa (<1 to >10 atm). As the mercury pressure and lamp operating temperatures are iacreased, the radiation becomes more iatense and the width of the emission lines iacreases (17). 

To exploit the energy produced in this reaction, the half reactions are separated. The oxidation reaction is carried out at a zinc electrode (Zn Zir + 2 electrons) and the reduction reaction is carried out at a copper electrode (Cu"" + 2 electrons Cu metal). Electrons flow through a metal wire from the oxidizing electrode (anode) to the reducing electrode (cathode), creating electric current that can be harnessed, for example, to light a tungsten bulb. 

---