Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Maximum period

The currendy (ca 1992) marketed injectable and implantable contraceptives are designed to be effective for maximum periods of three months and five years, respectively. There is Htde evidence from programmatic or health reasons that an injectable formulation with a longer effective life span, eg, six months, would not be equally effective. The acceptabiUty and effectiveness of long-acting contraceptives may be determined by the means by which a community deUvers contraceptive products to the pubHc the active life of a product may be determined by economic rather than programmatic or health related factors. [Pg.117]

In calculating the number of secondary turns needed, one needs to consider that the resonant transition period is approximately 0.5qSec within a 2.5qSec maximum period per MOSFET at 200 kHz. That corresponds to an 84 percent duty cycle. So,... [Pg.177]

Drager tube Range of measurement for maximum period of use... [Pg.352]

The first filtration step should thus be carried out using a filter of at least F7 (EU7) quality, which should be changed after a maximum period of one year s continuous operation. The second filter of at least F7 (EU7) quality is not exposed to high RH, effectively stops microorganisms and particles, and can remain in place for about two years, provided the final pressure loss is not reached within this period. [Pg.687]

Other incidents that occurred because operators relied on automatic valves and did not back them up with hand valves are described in Sections 14.6 and 17.3 (b). In this incident the point to be emphasized in addition is that the operators were not clear on the difference between a stand-by and a shutdown. No maximum period for stand-by was defined. And no readings were taken during periods on stand-by. Plant instructions should give guidance on both these matters. [Pg.316]

Interruptible contract. There is an obligation for the user to provide an alternative standby fuel to be used at the request of the gas supplier. The maximum period of interruption is one of the conditions agreed in the contract. The advantage to the user is that he or she can obtain a more favorable gas price. The advantage to the supplier is that at times of peak demand, such as a cold winter, he can balance supply and demand without investing in excessive storage capacity. [Pg.262]

The outcome of the process will result in the inclusion of the substance in one of four Annexes to the regulation. If the conclusion is that safe M RLs can be established, then final MRLs for the substance are added to Annex I. A substance will be inserted in Annex II if it is concluded that residues cannot cause a risk to human health. If some uncertainty remains over the proposed MRLs, then these can be included in Annex III as provisional MRLs for a maximum period of 5 years. Finally, if it is concluded that no safe residue limits can be set, the substance is placed in Annex IV, which means that it cannot be used in medicines for treatment of food-producing animals (Table 7.3). [Pg.142]

Eye ointments are prepared in a semi-sohd base (e.g. Simple Eye Ointment BP, which consists of yellow soft paraffin, eight parts hqnid paraffin, one part wool fat, one part). The base is filtered when molten to remove particles and sterilized at 160°C for 2 hours. The drug is incorporated prior to sterilization if heat stable, or added aseptically to the sterile base. Finally, the prodnct is aseptically packed in clear sterile alumirtinm or plastic tnbes. Since the prodnct contains virtnally no water, the danger of bacteria proliferating in the ointment is neghgible. Therefore, there is no recommended maximum period during which they can be nsed. [Pg.418]

Ernst et al. performed a retrospective analysis of 20 consecutive patients (median NIHSS 21) who presented within 3 hours of stroke symptoms and were treated using IV rt-PA (0.6 mg/kg) followed by LA rt-PA (up to 0.3 mg/kg or 24 mg, whichever was less, over a maximum period of 2 hours) in 16 of the 20 patients. Despite a high number of ICA occlusions (8/16), TIMI 2 and 3 recanalization rates were... [Pg.68]

Dermal exposure was performed using pre-washed cotton gloves covering the hands and forearms (stretch-cotton, 200 g/m2 surface (one-sided) 370 cm2 J. van der Wee BV Riel, The Netherlands). A pair of gloves was used for a maximum period of one hour in order to prevent breakthrough of the pesticide(s). Anew pair was provided after each hour of harvesting, or earlier... [Pg.124]

Methylene chloride is distilled from calcium hydride under argon at atmospheric pressure immediately before use. It is important to keep the methylene chloride wash in contact with the Schwartz s Reagent for a maximum period of 10 min use of a frit filter is essential. [Pg.176]

The dermal LD50 of undiluted phenol in rats was reported to be 669.4 mg/kg (Conning and Hayes 1970). The LD50 of an unspecified concentration of phenol in rabbits was reported to be 1,400 mg/kg (Vemot et al. 1977). Flickinger (1976) determined a dermal LD50 by exposing male albino rabbits to 0, 252, 500, 1,000, or 2,000 mg/kg phenol which was placed in contact with abraded and intact skin for a maximum period of 24 hours. No animals died in the 0, 252, or 500 mg/kg groups whereas 3 of 4 in the... [Pg.80]

A pool of erythrocyte samples. This is made up of erythrocytes from left-over EDTA-blood of a large number of different patients. Aliquots of 300 pi suspension are stored in BHT-treated Eppendorf vials at -20°C for a maximum period of 1 year. One of these samples is included in each weekly series of analyses. The results of ten selected fatty acids are plotted on an electronic Shewhart chart. [Pg.214]

In all cases search for sources and ventilate intensively and if necessary lay down utilization and ventilation conditions and initiate suitable minimization measures. Any occupancy of the room which may be necessary can only be tolerated with a time restriction for each dav over a maximum period... [Pg.200]

Table 7.6 Comparison of maximum periods of teratogenic sensitivity for various organs/systems in humans... Table 7.6 Comparison of maximum periods of teratogenic sensitivity for various organs/systems in humans...
The test session is performed at least 2 hours after the second habituation session. Rats are placed on the rotarod for a maximum period of 3 minutes. The number of animals which fall off before the end of this period is counted and the latency to fall off is recorded (maximum 3 minutes). [Pg.24]

A. SEAL 1—Below this limit survivors can remain in the compartment without wearing respiratory protection for a maximum period of 10 d. Respiratory or nervous functions should not be impaired sufficiently to significantly increase the risks of escape or rescue. Above this level (but below SEAL 2) the atmosphere is still breathable for 24 hours without wearing EABs. [Pg.37]

Industry is granted a maximum period of five years to implement its final proposal for a risk reduction strategy. In cases where voluntary measures are insufficient or impracticable, the strategy specifies that Government will consider alternative measures at a national or European level. [Pg.393]

Drager tubes for long-term measurements Drager tube Range of measurement in absolute units (20°C, 1013 mharl Range of measurement for maximum period of use... [Pg.227]

Because the validation batches were produced under GMP conditions, it was not possible to recover the opened ampoules during the lyophilizer unloading. The ampoules were therefore collected only after sealing. As the trays of ampoules were sealed in twos, the ampoules selected for analysis arose from pairs of trays, and not from individual trays (see Figure 4B and C). The sealing of the ampoules of a pair of trays took about 2.6 min. Thus, the ampoules of the first two trays were exposed to laminated air for a maximum period of 2.6 min and those of the last two trays for 13-15.6 minutes. [Pg.403]


See other pages where Maximum period is mentioned: [Pg.29]    [Pg.280]    [Pg.788]    [Pg.788]    [Pg.227]    [Pg.221]    [Pg.352]    [Pg.70]    [Pg.243]    [Pg.816]    [Pg.67]    [Pg.234]    [Pg.48]    [Pg.263]    [Pg.357]    [Pg.31]    [Pg.748]    [Pg.461]    [Pg.944]    [Pg.92]    [Pg.235]    [Pg.175]    [Pg.21]    [Pg.305]    [Pg.243]    [Pg.263]    [Pg.216]    [Pg.191]    [Pg.543]   
See also in sourсe #XX -- [ Pg.34 ]




SEARCH



© 2024 chempedia.info