Maximum dynamic

F, = maximum dynamic force that may develop on a fault... 

The P-i concept can also be used to collapse the results of a number of dynamic response calculations for structural elements into compact dimensionless design curves. A number of illustrations are given in Ref. 15, with one for blast-loaded beams with various boundary conditions appearing in Fig. 20. These curves give predictions of maximum dynamic bending strains and displacements for beams with a variety of boundary conditions. Details appear in Ref. 15, so we do not try to define all parameters here. 

Check maximum dynamic reaction from frame analysis v m = 22,600 lbs (100.5 kN)... 

Certain simplifications that allow the dynamic response to be reconciled with equivalent static loadings are examined. In earthquake loading the dominant effects are found to occur in the lowest mode for which no cross sectional distortion takes place. In wind loading the dynamic response is spread over several modes. The maximum dynamic tensile stresses at the windward base of the tower can be estimated using simple gust effect factors. 20 refs, cited. 

Maximum amplitude (MA) greatest amplitude on the TEG trace. MA represents the absolute strength of the fibrin clot and is a direct function of the maximum dynamic strength of fibrin and platelets. 

Figure 10 Nuclear magnetic relaxation times of sucrose relative to that of water as a function of sucrose concentration and showing the phenomenon of maximum dynamic coupling between sucrose and water at 50% w/w (4 mol%), which disappears, as the glass transition is approached. Redrawn from Girlich and Ludemann ...

A major limitation to the capacity of 2-DE to display complete proteomes is the veiy high dynamic range of protein abundance, estimated at 10 for cells and tissues (Corthals et al., 2000) and 10 for plasma (Anderson and Anderson, 2002). This is beyond the dynamic range of 2-DE, with an estimated maximum dynamic range of 10" (Rabilloud, 2002). Clearly, the development of reliable and reproducible prefractionation strategies will be essential to access and retrieve quantitative data for the less abundant proteins present in biological samples such as the heart. 

The pressure acting on a structure hit by the wave is not equal to the above mentioned peak pressure unless the structure is hit sideways, that is when the structure wall considered is parallel to the direction of propagation of the wave. In any other case, the maximum dynamic pressure on the wall is higher than the peak one by a factor of 2-4 (theoretically, 8) for a wall perpendicular to the wave direction of propagation, due to the reflection of the wave itself. 

For mixture with D < 11 and indentation <2.5 mm when tested in accordance to CEN EN 12697-20, the maximum dynamic indentation should range from 1.0 to 4.5 mm, assigned... 

The design basis flood is a series of parameters that maximize the challenge to plant safety as a consequence of a flood the parameters may be associated, for example, with the maximum water level, the maximum dynamic effect on the protection or the maximum rate of increase in water level... 

It can be shown that the average wave setup depends on the ratio H2/H1 as shown in Table 1.1. The fourth column presents the ratios of the maximum dynamic wave set amplitude to the average wave setup component. 

---