Mass-transfer measurements basic theory

The basic theory of mass transfer to a RHSE is similar to that of a RDE. In laminar flow, the limiting current densities on both electrodes are proportional to the square-root of rotational speed they differ only in the numerical values of a proportional constant in the mass transfer equations. Thus, the methods of application of a RHSE for electrochemical studies are identical to those of the RDE. The basic procedure involves a potential sweep measurement to determine a series of current density vs. electrode potential curves at various rotational speeds. The portion of the curves in the limiting current regime where the current is independent of the potential, may be used to determine the diffusivity or concentration of a diffusing ion in the electrolyte. The current-potential curves below the limiting current potentials are used for evaluating kinetic information of the electrode reaction. 

Diffusion is the mass transfer caused by molecular movement, while convection is the mass transfer caused by bulk movement of mass. Large diffusion rates often cause convection. Because mass transfer can become intricate, at least five different analysis techniques have been developed to analyze it. Since they all look at the same phenomena, their ultimate predictions of the mass-transfer rates and the concentration profiles should be similar. However, each of the five has its place they are useful in different situations and for different purposes. We start in Section 15.1 with a nonmathematical molecular picture of mass transfer (the first model) that is useful to understand the basic concepts, and a more detailed model based on the kinetic theory of gases is presented in Section 15.7.1. For robust correlation of mass-transfer rates with different materials, we need a parameter, the diffusivity that is a fundamental measure of the ability of solutes to transfer in different fluids or solids. To define and measure this parameter, we need a model for mass transfer. In Section 15.2. we discuss the second model, the Fickian model, which is the most common diffusion model. This is the diffusivity model usually discussed in chemical engineering courses. Typical values and correlations for the Fickian diffusivity are discussed in Section 15.3. Fickian diffusivity is convenient for binary mass transfer but has limitations for nonideal systems and for multicomponent mass transfer. 

The zero length column (ZLC) technique has become a common tool to measure mass transfer kinetics in microporous adsorbents. The partial loading experiment is a variant of the traditional ZLC method in which the adsorbent is not allowed to reach full equilibration with the gas phase. Even though this variant of the ZLC experiment was introduced over 10 years ago, it has been applied only by few researchers. In this contribution we review the basic theory of the partial loading experiment and show that it can be used to establish the contributions of different mass transfer mechanisms. A detailed numerical model that includes the effects of nonlinearity of the isotherm and combined diffusion and surface barrier effects is presented to allow the correlation of complex sorbate-sorbent systems. 

---