Manual layup techniques

The ATL and AFP processes are thus a cross between filament winding with its elaborate automated patterns of fibre laydown and unidirectional prepreg layup with its reliance on the autoclave. The use of automated robotic machinery for the layup gives increased layup speed (vital to economically manufacture these large items in feasible timescale), consistency and freedom from errors compared with manual techniques, as well as ensuring precision in the placement of the tows and tapes. 

Manufacturing methods for composites vary from manual to fully automated processes, whereby the latter have better quality control than the former. Wet layup, pultrusion, and filament winding are all discussed in some detail, while other techniques such as pull-winding, resin transfer moulding, vacuum bag moulding, and injection moulding are left to specialized composite materials texts. 

Hand Layup (Contact Molding or Open Mold Process). The oldest and simplest technique is primarily manual. An open mold is waxed to lubricate it. The surface of the proposed product is applied to the mold, usually as an unreinforced gel coat or sometimes as a thermoformed plastic sheet. A layer of fabric is hand cut and hand laid into the mold. Catalyzed resin is poured over the fabric and worked into it with brush, roUer, and squeegee to eliminate air bubbles. Another layer of fabric is laid over this, often oriented in a specific direction to optimize properties. Again, catalyzed resin is poured over it and worked into it. The process is repeated as many times as required to build up the desired thickness and optimum orientation of the layers. If the cure reaction is inhibited by air, a wax may be dissolved in the resin it exudes to the surface and forms a barrier to exclude air and permit complete cure. The resin may be allowed to cure at room temperature, or the assembly may be heated to complete or hasten the cure reaction. 

---