Pull-winding

Manufacturing methods for composites vary from manual to fully automated processes, whereby the latter have better quality control than the former. Wet layup, pultrusion, and filament winding are all discussed in some detail, while other techniques such as pull-winding, resin transfer moulding, vacuum bag moulding, and injection moulding are left to specialized composite materials texts. 

A combination of the pultrusion with the winding process is commonly known as the pull-winding process (Rg. 8.13). The fibers are laid to the... 

Aerodynamic Downwash Should the stack exit velocity be too low as compared with the speed of the crosswind, some of the effluent can be pulled downward by the low pressure on the lee side of the stack. This phenomenon, known as stack-tip downwash, can be minimized by keeping the exit velocity greater than the mean wind speed (i.e., typically twice the mean wind speed). Another way to minimize stack-tip downwash is to fit the top of the stack with a flat disc that extends for at least one stack diameter outward from the stack. 

These are required to make threads, i.e. the final drawing, twisting and winding of cotton. Such motors must possess very smooth acceleration to eliminate breakage of threads. They are recommended to have a starting torque of 150-200% of T, and a pull-out torque of 200-275% of with a mean acceleration torque ol 150-175%. A normal acceleration time of 5-10 seconds is recommended. Faster acceleration may cause more breakages, while a slower acceleration may result in snarls and knots in the yarn as a result of insufficient tension. 

Semiconductor control modules gate the thyristors, which switch cm rent to the motor field at the optimum motor speed and precise phase angle. This assures synchronizing with minimum system disturbance. On pull-out, the discharge resistor is reapplied and excitation is removed k> provide protection to the rotor winding, shaft, and external electrical system. The control resynchronizes the motor after the cause of pull-out i.n removed, if sufficient torque is available. The field is automatically applied if the motor synchronizes on reluctance torque. The control is calibrated at the factory and no field adjustment is required. The opti-... 

The damper and field windings each produce an effect on accelerating torque. The resistance of the damper winding is usually selected to produce its maximum torque during the first part of the starting period and a field-discharge resistor is selected so that the field-circuit torque peaks near pull-in speed. 

Figure 13.6 Myosin and actin molecules and myosin crossbridges. Each kind of filament is composed of a different protein myosin in the thick filaments and actin in the thin filaments. In the case of actin, the individual F-actins are more or less spherical but a large number of these combine to produce a long chain, two of which wind around each other, rather like a rope, to produce the thin filament. The myosin molecule is more complex and shaped somewhat like a golf club. To form the thick filament, the shafts aggregate to leave the heads protruding on all sides. These heads form the cross-bridges and are responsible for pulling the thin filaments into the spaces between the thick filaments (see Figure 13.5).

---