Manganese calculation

CL Eisher, J-L Chen, J Li, D Bashford, L Noodleman. Density-functional and electrostatic calculations for a model of a manganese superoxide dismutase active site in aqueous solution. J Phys Chem 100 13498-13505, 1996. 

The button cells that provide the energy for watches, electronic calculators, hearing aids, and pacemakers are commonly alkaline systems of the silver oxide-zinc or mercuric oxide-zinc variety. These alkaline systems provide a vei y high energy density, approximately four times greater than that of the alkaline zinc-manganese dioxide battery. 

Use Figure 17-11 to estimate the resistivities of two metal samples, one made of pure copper and the other of a copper-manganese alloy containing one atom of manganese for every one hundred copper atoms. Calculate the ratio of the cost due to power loss from wire of the impure material to the cost due to the power loss from wire of the pure material. 

Calculate the weights of magnesium, zinc, and manganese in the sample solution. 

It is shown that the numbers of valence electrons assigned to the y-alloys, /3-manganese and alloys with similar structure, and a-manganese by a new system of metallic valences agree closely with the electron numbers calculated for complete filling of important Brillouin poly-... 

Table III. X-ray reflection data for /3-manganese structure (AgsAl) and calculated electron densities.

C22-0036. Manganese has only one stable isotope. Calculate the A/ Z ratio for each of the following four... 

This calculation enables one to program easily the stoichiometric concentration, using a small calculator. If the molecule contains other atoms, silicon, tin, manganese, lead, etc, the most stable oxides thermodynamically are sought perhaps by using enthalpies of formation data listed for inorganic substances in Part Two. 

The melting points of chromium (1857 °C) and of manganese (1244 °C) are considerably lower than that of alumina. The heat requirement in respect of the reactions leading to the formation of these metals was calculated by considering alumina melting as the objective. The objective changes when aluminothermy is applied to the production of the refractory metals niobium and tantalum. Niobium melts at 2468 °C and tantalum at 3020 °C. Thus, when these metals are the products, the heat requirements for reaching temperatures in excess of 2500 °C and 3050 °C have to be calculated. 

Using the data given in Table 11.2, calculate the density of manganese. 

The theoretical yield of the method is less than 100%, as only 80 - 90% of the aqueous phase is removed after back-extraction. The actual yield obtained by 54 Mn counting was 69.5 7.8%, and this can be allowed for in the calculation of results. Environmental Protection Agency standard seawater samples of known manganese content (4370 ng/1) gave good manganese recoveries (4260 ng/1). 

The luminol reaction has also been used for the CL determination of organic substances such as penicillins [32] and tartrate ion [30] in pharmaceutical preparations by their inhibitory effect on the luminol-iodine and luminol-periodate-manganese(II)-TEA system, respectively. As can be seen from Table 1, the results were quite satisfactory. In the indirect determination of penicillins by their inhibitory effect on the luminol-iodine system, the stopped-flow technique improves the accuracy and precision of the analytical information obtained, and also the sample throughput [32], Thus, in only 2-3 s one can obtain the whole CL signal-versus-time profile and calculate the three measured parameters formation and... 

---