Malonic esters formation

The formation of adducts of enamines with acidic carbon compounds has been achieved with acetylenes (518) and hydrogen cyanide (509,519,520) (used as the acetone cyanohydrin). In these reactions an initial imonium salt formation can be assumed. The addition of malonic ester to an enamine furnishes the condensation product, also obtained from the parent ketone (350,521). 

The Gould-Jacobs reaction is a sequence of the following reactions (1) condensation of an arylamine 1 with either alkoxy methylenemalonic ester or acyl malonic ester 2 providing the anilidomethylenemalonic ester 3 (2) cyclization of 3 to the 4-hydroxy-3-carboalkoxyquinoline 4 (3) saponification to form acid 5, and (4) decarboxylation to give the 4-hydroxyquinoline 6. All steps of this process will be described herein with emphasis on the formation of intermediates like 3 and 4. 

Oxidadve cross-conphng reactions of alkylated derivatives of activated CH compounds, such as malonic esters, acetylacetone, cyanoacetates, and ceitain ketones, v/ithnitroalkanes promoted by silver nitrate or iodine lead to the formation of the nitroalkylated products. This is an alternative way of performing Spj l reactions using cr.-halo-nitroalkanes. 

Anschutz 1 treated aceto-salicylic chloride with sodium-malonic ester, with the formation of ethyl acetate and y3-hydroxy-coumarin-alpha-car-hoxylic ethyl ester—... 

The reaction between anihnes and malonic esters generates two equiv of ethanol, which could affect the equilibriiun between the starting material and the product (Fig. 5). Therefore, in a sealed tube reaction, it is necessary to keep the volume and reactant concentrations low in order to shift the equi-hbrium towards product formation. Thus, large-scale experiments are not practical using this procedure (Fig. 5). 

Fig. 5 Tentative mechanism for the formation of 3-substituted 4-hydroxyquinolones 13 in the reaction between anilines and substituted malonic esters via an a-oxoketene 12...

The cz5-aziridine substrate shows, as expected on the basis of this model, predominant formation of the trans-cyclopropane product. The starting materials for this MIRC reaction can readily be obtained from the aziridine esters by reduction to the corresponding aldehyde and a subsequent Knoevenagel reaction with malonate ester (Scheme 25) [34]. 

Acyl imidazolides are more reactive than esters but not as reactive as acyl halides. Entry 7 is an example of formation of a (3-ketoesters by reaction of magnesium enolate monoalkyl malonate ester by an imidazolide. Acyl imidazolides also are used for acylation of ester enolates and nitromethane anion, as illustrated by Entries 8, 9, and 10. (V-Methoxy-lV-methylamides are also useful for acylation of ester enolates. 

Nucleophilic Substitution of xi-Allyl Palladium Complexes. TT-Allyl palladium species are subject to a number of useful reactions that result in allylation of nucleophiles.114 The reaction can be applied to carbon-carbon bond formation using relatively stable carbanions, such as those derived from malonate esters and (3-sulfonyl esters.115 The TT-allyl complexes are usually generated in situ by reaction of an allylic acetate with a catalytic amount of fefrafcz s-(triphenylphosphine)palladium... 

Some functionalized thiophenes have been investigated in order to assess the scope of ylide-derived chemistry. As already mentioned, 2-(hydroxymethyl)thiophene still gives the S-ylide upon Rh2(OAe)4-catalyzed reaction with dimethyl diazomalonate 146 but O/H insertion instead of ylide formation seems to have been observed by other workers (Footnote 4 in Ref. 2S4)). From the room temperature reaction of 2-(aminomethyl)thiophene and dimethyl diazomalonate, however, salt 271 was isolated quite unexpectedly 254). Rh2(OAc)4, perhaps deactivated by the substrate, is useless in terms of the anticipated earbenoid reactions. Formation of a diazo-malonic ester amide and amine-catalyzed cyclization to a 5-hydroxytriazole seem to take place instead. 

Another example of the necessity to perform open-vessel microwave synthesis in specific cases is outlined in Scheme 4.11, namely the formation of 4-hydroxyquino-lin-2-(lH)-ones from anilines and malonic esters. The corresponding conventional... 

Scheme 4.11 Formation of 4-hydroxyquinolin-2-(l H)-ones from anilines and malonic esters.

The carbanions are involved in a number of substitutaion reactions. The example are the formation of mono and dialkyl malonic esters. 

Consecutive C-C bond formation leading to C-substituted malonic esters... 

With malonic esters and amides substituted at the central carbon, triazole formation is accompanied by decarboxylation and 4-alkyl-or 4-aryl-5-hydroxytriazoles are isolated. ... 

This example illustrates the synthesis of cyclic compounds by intramolecular alkylation reactions. The relative rates of cyclization for ca-haloalkyl malonate esters are 650,000 1 6500 5 for formation of three-, four-, five-, and six-membered rings, respectively.28 (See Section 3.9 of Part A to review the effect of ring size on Sn2 reactions.)... 

The use of /i-ketocstcrs and malonic ester enolates has largely been supplanted by the development of the newer procedures based on selective enolate formation that permit direct alkylation of ketone and ester enolates and avoid the hydrolysis and decarboxylation of ketoesters intermediates. Most enolate alkylations are carried out by deprotonating the ketone under conditions that are appropriate for kinetic or thermodynamic control. Enolates can also be prepared from silyl enol ethers and by reduction of enones (see Section 1.3). Alkylation also can be carried out using silyl enol ethers by reaction with fluoride ion.31 Tetraalkylammonium fluoride salts in anhydrous solvents are normally the... 

When a catalytic amount of base is used, the reaction proceeds with thermodynamic control of enolate formation. The most effective nucleophiles under these conditions are carbanions derived from relatively acidic compounds such as /i-kctocstcrs or malonate esters. The adduct anions are more basic and are protonated under the reaction conditions. Scheme 1.11 provides some examples. 

To avoid the formation of ketenes by alkoxide elimination, ester enolates are often prepared at low temperatures. If unreactive alkyl halides are used, the addition of BU4NI to the reaction mixture can be beneficial [134]. Examples of the radical-mediated a-alkylation of support-bound a-haloesters are given in Table 5.4. Further methods for C-alkylating esters on insoluble supports include the Ireland-Claisen rearrangement of O-allyl ketene acetals (Entry 6, Table 13.16). Malonic esters and similar strongly C,H-acidic compounds have been C-alkylated with Merrifield resin [237,238]. 

Without postulating the formation of dichloronaphthalide 368, one may explain using Scheme 7 the reaction of naphthaloyl dichloride 367 with two molecules of sodium malonic ester, which does not result in the expected 1,8-dimalonylnaphthyl diketone 372, but leads to a 2-malonylydene derivative of naphtho[cd]pyran-9-one 373 (36MI3). However, we do not insist on the suggested mechanisms for the reactions of naphthaloyldichloride 367 with aromatic compounds or sodium malonic ester one can assume the alternative course via dichloronaphthalide 368. Moreover, hemo-... 

A palladium-cataly/ed C-C coupling reaction—the Heck reaction — is used in the construction of bicyclic system 13. Cyclization leads to a q3-alIyl-Pd complex, which undergoes nucleophilic attack by malonic ester anion 12. This in turn leads to formation of the C4 side chain The mechanism of this reaction therefore differs from that of a normal Heck reaction. 

Malonic esters are more acidic than simple esters, so that alkylations can be carried out via enolate formation promoted by relatively mild bases such as sodium alkoxide, and subsequent alkylation with halides. An excess of ester must be used to prevent dialkylated products. Carboxylic acids may optionally be obtained after hydrolysis and decarboxylation. 

---