Lithium chloride solutions vapor pressure

Data on the two lithium salts which are useful for air dehydration are presented in Table 11-9 and Figures 11-49 and 11-50. As shown in the figures, lithium bromide is considerably more soluble in water, and the saturated solutions of this salt have a lower vapor pressure than lithium chloride solutions at the same temperature and thus can provide a greater degree of dehydration. For most operations, however, the degree of dehydration provided by lithium... 

Anionic polymerization of vinyl monomers can be effected with a variety of organometaUic compounds alkyllithium compounds are the most useful class (1,33—35). A variety of simple alkyllithium compounds are available commercially. Most simple alkyllithium compounds are soluble in hydrocarbon solvents such as hexane and cyclohexane and they can be prepared by reaction of the corresponding alkyl chlorides with lithium metal. Methyllithium [917-54-4] and phenyllithium [591-51-5] are available in diethyl ether and cyclohexane—ether solutions, respectively, because they are not soluble in hydrocarbon solvents vinyllithium [917-57-7] and allyllithium [3052-45-7] are also insoluble in hydrocarbon solutions and can only be prepared in ether solutions (38,39). Hydrocarbon-soluble alkyllithium initiators are used directiy to initiate polymerization of styrene and diene monomers quantitatively one unique aspect of hthium-based initiators in hydrocarbon solution is that elastomeric polydienes with high 1,4-microstmcture are obtained (1,24,33—37). Certain alkyllithium compounds can be purified by recrystallization (ethyllithium), sublimation (ethyllithium, /-butyUithium [594-19-4] isopropyllithium [2417-93-8] or distillation (j -butyUithium) (40,41). Unfortunately, / -butyUithium is noncrystaUine and too high boiling to be purified by distiUation (38). Since methyllithium and phenyllithium are crystalline soUds which are insoluble in hydrocarbon solution, they can be precipitated into these solutions and then redissolved in appropriate polar solvents (42,43). OrganometaUic compounds of other alkaU metals are insoluble in hydrocarbon solution and possess negligible vapor pressures as expected for salt-like compounds. 

The reaction involves two electrons per thionyl chloride [7719-09-7] molecule (40). Also, one of the products, SO2, is a Hquid under the internal pressure of the cell, facihtating a more complete use of the reactant. Finally, no cosolvent is required for the solution, because thionyl chloride is a Hquid having only a modest vapor pressure at room temperature. The electrolyte salt most commonly used is lithium aluminum chloride [14024-11-4] LiAlCl. Initially, the sulfur product is also soluble in the electrolyte, but as the composition changes to a higher SO2 concentration and sulfur [7704-34-9] huA.ds up, a saturation point is reached and the sulfur precipitates. 

Liquid Sorption. If a moist gas is passed through sprays of a liquid sorbent, such as lithium chloride or an ethylene glycol solution, moisture is removed from the air at a rate depending on the vapor pressure difference. This is a function of the absorbent concentration and is maintained at the required level by a regeneration cycle. The regeneration process is continuous and is achieved by allowing a percentage of the chemical into the exhaust-heated air. 

Hgure 11-49. Vapor pressure of saturated solutions of lithium chloride and bromide. Data of Foote Minerals Company (1956)... 

---