Lightly doped drain implant

These processes are considerably more complex in actual CMOS fabrication. First, the lower layers of a CMOS stmcture typically have a twin-tub design which includes both PMOS and NMOS devices adjacent to each other (see Fig. 3b). After step 1, a mask is opened such that a wide area is implanted to form the -weU, followed by a similar procedure to create the -weU. Isolation between active areas is commonly provided by local oxidation of sihcon (LOCOS), which creates a thick field oxide. A narrow strip of lightly doped drain (LDD) is formed under the edges of the gate to prevent hot-carrier induced instabiUties. Passivation sidewalls are used as etch resists. A complete sequence of fabrication from wafer to packaged unit is shown in Figure 10. 

---