Leaving groups allylation

The reaction is a nucleophilic substitution in which the nucleophile (C6H5S ) becomes attached to the carbon that bore the chloride leaving group. Allylic rearrangement is not observed therefore, it is reasonable to conclude that an allylic carbocation is not involved. The mechanism is SN2. 

Depending on the internal energy and the substituents attached to the pentacoordinate silicon adduct anions, not only exchange processes, like reaction 146, or substitutions (reactions 143-145) occur, but alkane elimination is also frequently observed, in particular under ICR conditions. Alkane elimination is favoured if the adduct does not contain a good leaving group (allyl, alkoxide). Three instructive examples are described in reactions 147-149164b. 

Allylic acetoxy groups can be substituted by amines in the presence of Pd(0) catalysts. At substituted cyclohexene derivatives the diastereoselectivity depends largely on the structure of the palladium catalyst. Polymer-bound palladium often leads to amination at the same face as the aoetoxy leaving group with regioselective attack at the sterically less hindered site of the intermediate ri -allyl complex (B.M. Trost, 1978). 

The wM-diacetate 363 can be transformed into either enantiomer of the 4-substituted 2-cyclohexen-l-ol 364 via the enzymatic hydrolysis. By changing the relative reactivity of the allylic leaving groups (acetate and the more reactive carbonate), either enantiomer of 4-substituted cyclohexenyl acetate is accessible by choice. Then the enantioselective synthesis of (7 )- and (S)-5-substituted 1,3-cyclohexadienes 365 and 367 can be achieved. The Pd(II)-cat-alyzed acetoxylactonization of the diene acids affords the lactones 366 and 368 of different stereochemistry[310]. The tropane alkaloid skeletons 370 and 371 have been constructed based on this chemoselective Pd-catalyzed reactions of 6-benzyloxy-l,3-cycloheptadiene (369)[311]. 

Allylic amine is a less reactive leaving group[7], but the allylic ammonium salts 214 (quaternary ammonium salts) can be used for allylalion(l30,131]. Allylic sulfonium salts are also used for the allylation[130]. The allylic nitrile in the cyclic aminonitrile 215 can be displaced probably via x-allylic complex formation. The possibility of the formation of the dihydropyridinium salts 216 and subsequent conjugate addition are less likelyfl 32],... 

Imidazole can be A -allylated. The A -glycosylimidazole 299 is prepared by regiospecific amination at the anomeric center with retention of configuration. Phenoxy is a good leaving group in this reaction[181]. Heterocyclic amines such as the purine base 300 are easily allylatedfl 82]. 

Dienes and allylarcncs can be prepared by the Pd-catalyzcd coupling of allylic compounds with hard carbon nucleophiles derived from alkenyl and aryl compounds of main group metals. Allylic compounds with various leaving groups can be used. Some of them are unreactive with soft nucleophiles, but... 

Isopentenyl pyrophosphate and dimethylallyl pyrophosphate are structurally sim liar—both contain a double bond and a pyrophosphate ester unit—but the chemical reactivity expressed by each is different The principal site of reaction m dimethylallyl pyrophosphate is the carbon that bears the pyrophosphate group Pyrophosphate is a reasonably good leaving group m nucleophilic substitution reactions especially when as in dimethylallyl pyrophosphate it is located at an allylic carbon Isopentenyl pyrophosphate on the other hand does not have its leaving group attached to an allylic carbon and is far less reactive than dimethylallyl pyrophosphate toward nucleophilic reagents The principal site of reaction m isopentenyl pyrophosphate is the carbon-carbon double bond which like the double bonds of simple alkenes is reactive toward electrophiles... 

Section 26.9 Carbon-caibon bond fonnation between isoprene units can be understood on the basis of nucleophilic attack of the tt electrons of a double bond on a caibocation or an allylic caibon that bears a pyrophosphate leaving group. 

Treatment of allylic substrates ISO, possessing suitable leaving groups X in tlieir allylic positions, witli organocopper reagents may result eitlier in an S 2-type process fa-attack) or alternatively in an S 2 one fy-attack), giving tlie substitution products 151 and 152, respectively fSclieme G.30) [Ij]. 

Scli ir 6.34. Leaving group and reagent dependence of allylic cubctitution in ao/clic derivative 161. 

To acliieve diastereoselectivity in tlie course of allylic substitution, tlie cnnitoliing cliital inforniation may not only reside in tlie substtate skeleton but may also be pan of tlie allylic leaving group. Tlius, a cliital carbamate bas been developed as a... 

Hie use of chiral catalysts as an approach to enantiomer icaliy enriched products by means of coppet-mediated substitution reactions is covered in this chapter. Reactions in which a chiral auxiliary resides in the leaving group of the substrate w ill also he dealt with, since these reactions provide direct and efBcient routes to single enantiomers of the desired products. Most studies so far have been concerned with allylic substrates, with a new chiral center being produced in the course of a selec-... 

Hie Leterocydic component in tlie leaving group offers possiLililies for introduction of diirality. Optically active oxazolin-2-yl and tliiazolin-2-yl allyl tliioetliers 7 were tlius diosen as suLstrales (Sdienie 8.8) [17]. 

A result equivalent to an allylic substitution reaction with a chiral leaving group can also be achieved by a two-step procedure involving a conjugate addition reaction and a subsequent elimination reaction, as demonstrated by Tamura et al., wbo studied the reaction shown in Scheme 8.15 [27]. 

---