Lead bromide hydrate

Lead, tris(ethyldithiocarbonato)-stereochemistry. 1,82 structure, 1, 82 Lead bromide, 3.194 Lead bromide hydrate, 3, 195 Lead carboxylatcs, 3,222 Lead complexes, 3,183-223 r 6-arene, 3,220 bivalent... 

A variety of silver(I) carbenes can be prepared by interaction of a series of imidazolium salts with silver(I) oxide or silver(I) carbonate (OOJCS(D) 4499). With 3-tert-butyl-l-(2 -pyridylmethyl)imidazolium bromide hydrate and 3-(2", 6"-di-Ao-propylphenyl)-l-(2 -pyridylmethyl)imidazolium bromide hydrate, complexes 85 (R = t-Bu, 2",6"-/-Pr2CgH3) result. 3-(2",4",6"-Trimethylphenyl)-l-(2 -pyridylmethyl)imidazolium bromide in turn leads to 86 (R= 2",4",6"-MejCgH2). 3-(2",6"-Di-wo-propylphenyl)-l-(2 -pyridyl)... 

Glattfeld and Hanke applied this procedure to the oxidation of maltose hydrate. An aqueous solution of the sugar was shaken with lead carbonate and bromine since lead bromide separated from the reaction mixture, only aeration was necessary to remove the excess bromine, and treatment with silver oxide and hydrogen sulfide removed the last bromide, silver and lead ions. The maltobionic acid was isolated as the calcium salt. Here the neutralization of the hydrobromic acid was beneficial in preventing any hydrolysis of the aldobionic acid. 

Lead (II) bromide [10031-22-8] M 367.0, m 373°. Crystallised from water containing a few drops of HBr (25mL of water per gram PbBr2) between 100° and 0°. A neutral solution was evaporated at 110° and the crystals that separated were collected by rapid filtration at 70°, and dried at 105° (to give the monohydrate). To prepare the anhydrous bromide, the hydrate is heated for several hours at 170° and then in a Pt boat at 200° in a stream of HBr and H2. Finally fused [Clayton et al. J Chem Soc, Faraday Trans 1 76 2362 1980]. 

Of special interest is the dehydration of polynuclear technetium bromide clusters, which contain hydroxonium cations with different numbers of hydration water molecules. Analysis of the results obtained leads us to conclude that at 140-200 °C dehydration occurs with a partial decomposition of the [H30(H20)3] + cations (30). 

In 1953 Olson and Konecny (19) studied the conductance of lithium bromide in acetone-water mixtures at 25°C and 35°C. They calculated KD and Ao in the acetone-rich solvents by the Fuoss method and Ao in the water-rich solvents by extrapolation of the phoreogram. They found that as the water content increases Kd increases, Ao decreases but then undergoes an increase, and a increases from slightly less than the sum of the crystal ionic radii to the sum of the radii of the fully hydrated ions. Extrapolation of their data for A0 to zero water content is not reliable because of the large concave upward negative slope however, it would appear to lead to a value of about 220 U l cm2 eq-1. Similar extrapolations of values for Kd and a yield 2.0 X 10 4 and 2.2 A, respectively. 

Anhydrous hydrazine dssolves many salts, thus, 100 parts of solvent at 12-5°-13° dissolve 12-2 parts of sodium chloride 8 5, of potassium chloride 56-4, of potassium bromide 135-7, of potassium iodide 26-6, of sodium nitrate 21-7, of potassium nitrate and 814, of barium nitrate. The hydrazine seemed to unite with sodium chloride with a warm soln. of ammonium chloride, ammonia is evolved, and in the cold, there seems to be a state of equilibrium a complex salt seems to be formed with lead nitrate. An aq. soln. of hydrazine hydrate also dissolves a number of salts, potassium bromide and iodide, ammonium sulphate, potassium cyanide, barium nitrate, magnesium sulphate, etc. According to T. W. B. Welsh and H. J. Broderson, the solubility of the metal haloids seems to... 

Most ionic halides dissolve in water to give hydrated metal ions and halide ions. However, the lanthanide and actinide elements in the +3 and +4 oxidation states form fluorides insoluble in water. Fluorides of Li, Ca, Sr, and Ba also are sparingly soluble, the lithium compound being precipitated by ammonium fluoride. Lead gives a sparingly soluble salt PbCIF, which can be used for gravimetric determination of F . The chlorides, bromides, and iodides of Ag1, Cu1, Hg1, and Pbn are also quite insoluble. The solubility through a series of mainly ionic halides of a... 

The cyclic vinyl ether 2,3-dihydro-1,4-dioxin is converted into its cyclic hemiacetal hydration product, tetrahydro-2-hydroxy-1,4-dioxin, in aqueous solution by an acid-catalyzed reaction <870K2746, 89JP043). Treatment of an alcohol with excess of 2,3-dihydro-1,4-dioxin at room temperature in the presence of copper(II) bromide in tetrahydrofuran leads to the corresponding acetal. This new protective group for alcohols, which is stable towards lithium aluminum hydride and organolithium reagents, can be removed by treatment with acidified aqueous methanol <85S806>. 

---