Laser types infrared

In all three instrumental configurations, it is possible to induce decomposition of the ion trapped inside the ICR cell not only by collisional experiments, but also by interaction with slow electrons (electron capture dissociation, ECD) or by irradiation with an infrared (IR) laser beam (infrared multi photon dissociations, IRMPD). Experiments of this type (mainly devoted to polypeptide identification) allow to maintain the high-vacuum conditions inside the ICR cell, which are necessary to achieve the high-resolution conditions. 

Numerous applications of SFR lasers to high-resolution infrared spectroscopy have demonstrated the capabilities of this tunable laser type regarding spectral resolution and achievable signal-to-noise ratio (Sect.6.6). 

Figure C3.3.4 shows a schematic diagram of an apparatus tliat can be used to study collisions of tlie type described above [5, 9,12,16]. Donor molecules in a 3 m long collision cell (a cylindrical tube) are excited along tlie axis of tlie cell by a short-pulse excimer laser (typically 25 ns pulse widtli operating at 248 mil), and batli molecules are probed along tliis same axis by an infrared diode laser (wavelengtli in tlie mid-infrared witli continuous light-output...

Reaction with vatious nucleophilic reagents provides several types of dyes. Those with simple chromophores include the hernicyanine iodide [16384-23-9] (20) in which one of the terminal nitrogens is nonheterocyclic enamine triearbocyanine iodide [16384-24-0] (21) useful as a laser dye and the merocyanine [32634-47-2] (22). More complex polynuclear dyes from reagents with more than one reactive site include the trinuclear BAB (Basic-Acidic-Basic) dye [66037-42-1] (23) containing basic-acidic-basic heterocycles. Indolizinium quaternary salts (24), derived from reaction of diphenylcyclopropenone [886-38-4] and 4-picoline [108-89-4] provide trimethine dyes such as (25), which absorb near 950 nm in the infrared (23). 

Symmetrical, long-chain cyanine dyes for laser appHcations provide output from 680 to 980 nm (76). Although these dyes were obtained through early screening procedures, infrared dyes for other technologies use similar stmetures. A long-chain indolenine-type cyanine dye, general stmeture as in dye (34), has been described as the sensitizer in optical disk memories (77). 

The main use of elemental As is in alloys with Pb and to a lesser extent Cu. Addition of small concentrations of As improves die properties of Pb/Sb for storage batteries (see below ), up to 0.75% improves the hardness and castabilily of type metal, and 0 5-2.0% improves the sphericity of Pb ammunition. Automotive body solder is Pb (92%),, Sb (5 0%), Sn (2.5%) and As (0.5%). Intcrnxitallic compounds with Al, Ga and In give the 111-V semiconductors (p 255) of which GaAs and InAs are of particular value for light-emitting diodes (LEDs), tunnel diodes, infrared emitters, laser windows and Hall-effect devices (p. 258). 

Laser radiation can be obtained nowadays over a wide spectral range from the ultraviolet to the far infrared region, covering the range of optical spectroscopy. Fignre 2.4 shows schematically the spectral zones covered by different types of lasers. Although there are some specific regions in which direct laser action is not available. 

The optical features of a center depend on the type of dopant, as well as on the lattice in which it is incorporated. For instance, Cr + ions in AI2O3 crystals (the ruby laser) lead to sharp emission lines at 694.3 nm and 692.8 nm. However, the incorporation of the same ions into BeAl204 (the alexandrite laser) produces a broad emission band centered around 700 nm, which is used to generate tunable laser radiation in a broad red-infrared spectral range. 

Whether laser flash photolysis (LFP) is used to detect RIs before they react, or matrix isolation at very low temperatures is employed to slow down or quench these reactions, spectroscopic characterization of RIs is frequently limited to infrared (IR) and/or ultraviolet-visible (UV-vis) spectroscopy. Nuclear magnetic resonance (NMR) spectroscopy, which is generally the most useful spectroscopic technique for unequivocally assigning structures to stable organic molecules, is inapplicable to many types of RI. 

---