Kinetics hydride generation

Like most other FI analytical processes, the separations are also almost always performed under non-equiiibrated conditions, and the phase transfer factors P are rarely higher than 0.3. usuall> being in the range 0.05-0.2. While this sometimes may have some unfavourable effects on sensitivity, they may be compensated for whenever necessary, by preconcentration measures during the gas-liquid separation. On the other hand, the non-equilibrium conditions may be exploited favourably to improve selectivity through kinetic discrimination (cf. Sec. 5.5.1 Tolerance of interferences in FI hydride generation systems). 

The reaction time for the hydride generation process in an FI system can be precisely controlled by the flow-rate and line lengths to favour the main reactions which are usually fast. The slower interfering reactions are often suppressed by using shorter reaction coil lengths. Such kinetic discriminations are not possible in batch procedures. 

There have been few satisfactory demonstrations that decompositions of hydrides, carbides and nitrides proceed by interface reactions, i.e. either nucleation and growth or contracting volume mechanisms. Kinetic studies have not usually been supplemented by microscopic observations and this approach is not easily applied to carbides, where the product is not volatile. The existence of a sigmoid a—time relation is not, by itself, a proof of the occurrence of a nucleation and growth process since an initial slow, or very slow, process may represent the generation of an active surface, e.g. poison removal, or the production of an equilibrium concentration of adsorbed intermediate. The reactions included below are, therefore, tentative classifications based on kinetic indications of interface-type processes, though in most instances this mechanistic interpretation would benefit from more direct experimental support. 

Abeywickrema and Beckwith162 have measured the primary hydrogen-deuterium kinetic isotope effect for the reaction between an aryl radical and tributyltin hydride. The actual isotope effect was determined by reacting tributyltin hydride and deuteride with the ort/ro-alkcnylphcnyl radical generated from 2-(3-butenyl)bromobenzene (equation 111). 

Some reactions of the type H+hydride - hydride radical+H2 have been studied, mainly at lower temperatures, with H atoms generated by an external source. There might be appreciable errors in extrapolation of these rate coefficients to temperatures where thermal decomposition takes place. In many cases only a lower or upper limit of the rate of consecutive reactions can be given, especially if the decomposition takes place at temperatures appreciably above 1000 °K. We will not discuss reaction mechanisms in detail which lead to untested rate phenomena nor those which are based upon product analysis without a well-defined time history. It is true, however, that no decomposition of a hydride consisting of more than two atoms has a mechanism which is fully understood and which can be completely described in terms of the kinetics of the elementary reactions. 

Figure 1.11 provides an example of H NMR monitoring in the Pd-catalyzed cy-doisomerization of dimethyl diallyl malonate, 39 [28]. The kinetic profile reveals a pronounced induction period after which the exocydic alkene 40a is formed predominantly as the kinetic product. A hydropalladation mechanism was proposed on the basis of NMR experiments, and the transient spedes 41, formed by allylpalla-dation of the coordinated diene, could be detected and identified with the help of and labeling. The hydride Pd catalyst, 42, would be generated from 41 by water-promoted P-hydride elimination. The observed induction period is assodated with the formation of the Pd-hydride 42. 

Kinetics of oxidation of toluene and cumene to the corresponding a-hydroxy compounds by stoich. trani-[Ru(0)(bpy)(tpy)] VCH3CN were reported a two-electron hydride-ion transfer step may be involved [672]. Electro-oxidation of side-chains in alkylaromatics by [Ru(0)(bpy)(tpy)] (generated electrochemicaUy in situ from [Ru(OH)(bpy)(tpy)] V BuOH/water pH 6.8/Pt electrodes/50°C) was effected toluene gave benzoic acid and ethylbenzene gave acetophenone (Table 4.1) [673]. 

---