Ketones hazardous reaction products

Scheme 9.1 shows a generalized sequence of reactions for the oxidation of an alkane, via alcohol, ketone and carboxylic acid, to the completely oxidized products, water and carbon dioxide. The latter are often referred to as combustion products as they are the same as those formed by burning hydrocarbons. These are not normally desirable chemical products unless it is necessary to destroy a toxic, hazardous or otherwise unwanted waste material. Oxidation itself is not difficult to achieve, and is a highly exothermic or even explosive process. Selective oxidation, however, is a much greater challenge, as it is important to stop the sequence at the desired product without proceeding further down the oxidation pathway. 

Diisopropylbenzene Hydroperoxide — Fire Hazards Flash Point (deg. F) 175 Flammable Limits in Air (%) Data not available Fire Extinguishing Agents Foam, dry chemical, carbon dioxide Fire Extinguishing Agents Not to be Used Water may be ineffective Special Hazards of Combustion Products Flammable alcohol and ketone gases are formed in fires Behavior in Fire Burns with a flare effect. Containers may explode Ignition Temperature (deg. F) Data not available Electrical Hazard Data not available Burning Rate Data not available Chemical Reactivity Reactivity with Water No reaction Reactivity with Common Materials Aluminum, copper, brass, lead, zinc salts. 

Diazotization in the presence of boron trifluoride enables diazonium tetrafluoroborates to be isolated from the reaction mixture and purified. Subsequent controlled decomposition produces the required fluoroaromatic. Although explosion hazards and the toxicity of the isolated salts are significant concerns with this process, known as the Balz-Schiemann process, 4,4 -di-fluorobenzophenone (BDF. 6) has been prepared by this route as a monomer for the production of the engineering plastic poly(ether ether ketone) , or PEEK , by condensation with 1,4-dihydroxybenzene in the presence of potassium carbonate. BDF 6 is superior to its chlorine analog because in aromatic systems the nucleophilic displacement of fluorine is more facile than that of chlorine, leading to a shorter polymerization time and a better quality product containing less degradation impurities. 

The determination of peroxides has two goals one is to monitor peroxide concentration used as initiator and catalysts and the other is to detect formation of hazardous peroxides formed as autoxidation products in ethers, acetals, dienes, and alkylaromatic hydrocarbons. A sample is dissolved in a mixture of acetic acid and chloroform. The solution is deaerated and potassium iodide reagent is added and let to react for 1 h in darkness. The iodine formed in reaction is measured by absorbance at 470 nm and result calculated to active oxygen in the sample. The method can determine hydroperoxides, peroxides, peresters, and ketone peroxides. Oxidizing and reducing agents interfere with flic determination. 

---