Radioactive emissions ionization

Radiation Dosimetry. Radioactive materials cause damage to tissue by the deposition of energy via their radioactive emissions. Thus, when they are internally deposited, all emissions are important. When external, only those emissions that are capable of penetrating the outer layer of skin pose an exposure threat. The biological effects of radiation exposure and dose are generally credited to the formation of free radicals in tissue as a result of the ionization produced (17). 

Reviews of spark chambers and thek uses have been previously published (6,7). Essentially, the spark chamber consists of electrodes contained in a chamber filled with an ionizable gas, a mixture of argon containing 10% methane, and this gives a high sensitivity to P radiation. The gas is ionized by radioactive emissions, and these emissions are recorded on film with a camera. The Polaroid film integrates the individual flashes produced over a suitable exposure period. Due to the intensity of the sparks, the film is rapidly saturated, leading to blackening of the film, and hence direct quantitation is not possible. 

The numerical combination of protons and neutrons in most nuclides is such that the nucleus is quantum mechanically stable and the atom is said to be stable, i.e., not radioactive however, if there are too few or too many neutrons, the nucleus is unstable and the atom is said to be radioactive. Unstable nuclides undergo radioactive transformation, a process in which a neutron or proton converts into the other and a beta particle is emitted, or else an alpha particle is emitted. Each type of decay is typically accompanied by the emission of gamma rays. These unstable atoms are called radionuclides their emissions are called ionizing radiation and the whole property is called radioactivity. Transformation or decay results in the formation of new nuclides some of which may themselves be radionuclides, while others are stable nuclides. This series of transformations is called the decay chain of the radionuclide. The first radionuclide in the chain is called the parent the subsequent products of the transformation are called progeny, daughters, or decay products. 

Emission of ionizing radiations in radioactive decay, nuclear particle and y-ray spectrometry. Quantitative and qualitative analysis by intensity and spectrometric measurements respectively. 

The electron capture detector is another type of ionization detector. Specifically, it utilizes the beta emissions of a radioactive source, often nickel-63, to cause the ionization of the carrier gas molecules, thus generating electrons that constitute an electrical current. As an electrophilic component, such as a pesticide, from the separated mixture enters this detector, the electrons from the carrier gas ionization are captured, creating an alteration in the current flow in an external circuit. This alteration is the source of the electrical signal that is amplified and sent on to the recorder. A diagram of this detector is shown in Figure 12.13. The carrier gas for this detector is either pure nitrogen or a mixture of argon and methane. 

The emission of nuclear particles or radiation from an isotope during its disintegration is commonly referred to as radioactivity. These emissions are classified as of the three basic types a, 0 and y. a-Particles, which are helium nuclei, have only weak penetrating power and may be stopped by 5-10 cm of air or thin metallic sheets. They are, however, highly energetic, ranging from 4 to 10 MeV. Thus they have a high ionization capacity... 

---