Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Installation damage testing

Laboratory small-scale Installation damage testing... [Pg.207]

Although the laboratory-scale installation damage test does not develop retained strength values useable for reinforcement design, it has proved useful to index... [Pg.207]

Test Specimens In carrying out plant tests it is necessary to install the test specimens so that they wih not come into contact with other metals and alloys this avoids having their normal behavior disturbed by galvanic effects. It is also desirable to protect the specimens from possible mechanical damage. [Pg.2438]

For reduced cost and complexity, it is desirable to use commercially available aluminum-fiber pressure vessels for insulated pressure vessels. However, commercially available pressure vessels are not designed for operation at cryogenic temperature. A series of tests has been carried out to verify that commercially available pressure vessels can be operated at cryogenic temperature with no performance losses. All analysis and experiments to date indicate that no significant damage has resulted. Future activities include a demonstration project in which the insulated pressure vessels will be installed and tested on two vehicles. A draft standard will also be generated for obtaining certification for insulated pressure vessels. [Pg.212]

The situation inside monitoring module CCD is designed and installed to test the change of explosion gas jet-flow in vacuum module and whether vacuum module is damaged or not in the experimental process. [Pg.839]

When materials are not handled properly, they can be damaged. The damage may go unnoticed until a system is installed and tested. This has happened more than once. For example, there was a crew installing a PVC pipeline in cold weather. The installation went well, until the test was performed on the system. It was then that long cracks in the PVC pipe were discovered. [Pg.88]

Air pressure is often used on nonpressurised installations during testing. But, air and gasses should never be used when testing pressurized systems. There is far too much risk of property and personal damage when a pressurized system is tested with air. Potable water is the preferred medium for testing pressurized systems. [Pg.266]

In the context of geotextile reinforcements, it is common to measure the installation damage that will be experienced during application. In general, test procedures to measure resistance to installation damage differ slightly in their approach, but some common features enable testing and research laboratories to accommodate the requirements established by all. [Pg.205]

The desirable operating characteristics of equipment include simplicity, convenience and low cost of maintenance simplicity, convenience and low cost of assembly and disassembly convenience in replacing worn or damaged components ability to control during operation and test before permanent installation continuous operation and steady-state processing of materials without excessive noise, vibration or upset conditions a minimum of personnel for its operation and, finally, safe operation. Low maintenance often... [Pg.1]


See other pages where Installation damage testing is mentioned: [Pg.205]    [Pg.206]    [Pg.207]    [Pg.205]    [Pg.206]    [Pg.207]    [Pg.205]    [Pg.206]    [Pg.207]    [Pg.205]    [Pg.206]    [Pg.207]    [Pg.28]    [Pg.27]    [Pg.756]    [Pg.794]    [Pg.115]    [Pg.148]    [Pg.62]    [Pg.115]    [Pg.148]    [Pg.17]    [Pg.442]    [Pg.124]    [Pg.444]    [Pg.15]    [Pg.153]    [Pg.284]    [Pg.312]    [Pg.355]    [Pg.115]    [Pg.81]   
See also in sourсe #XX -- [ Pg.207 , Pg.208 ]

See also in sourсe #XX -- [ Pg.207 , Pg.208 ]




SEARCH



© 2024 chempedia.info