Injection rotor valve seals

The basic difference between this type of valve and the normal external loop sample valve is the incorporation of an extra port at the front of the valve. This port allows the injection of a sample by a syringe directly into the front of the sample loop. Position (A) shows the load position. Injection in the front port causes the sample to flow into the sample loop. The tip of the needle passes through the rotor seal and, on... 

It should be stressed that only those surfaces that actually come in contact with the sample need to be bio-compatible and the major parts of the valve can still be manufactured from stainless steel. The actual structure of the valve varies a little from one manufacturer to another but all are modifications of the basic sample valve shown in figure 13. The valve usually consists of five parts. Firstly there is the control knob or handle that allows the valve selector to be rotated and thus determines the load and sample positions. Secondly, a connecting device that communicates the rotary movement to the rotor. Thirdly the valve body that contains the different ports necessary to provide connections to the mobile phase supply, the column, the sample loop if one is available, the sample injection port and finally a port to waste. Then there is the rotor that actually selects the mode of operation of the valve and contains slots that can connect the alternate ports in the valve body to provide loading and sampling functions. Finally there is a pre-load assembly that furnishes an adequate pressure between the faces of the rotor and the valve body to ensure a leak tight seal. 

High-pressure injection valve clogged Replace rotor seal and/or stator. 

This is an example of a manual HPLC iryector valve. It consists of a port, an injection lever, a body, a rotor seal, a stator, and a loop. 

---