Injection large-volume injectors

Several sample preparation techniques are performed inside the inlet system. Large-volume injection can be carried out by a number of methods including programmed temperature vaporisation (PTV). Automated SPE may be interfaced to GC using a PTV injector for large volume injection. SPE-PTV-GC with on-column injection is suited to analysis of thermola-bile compounds. 

Principles and Characteristics Although early published methods using SPE for sample preparation avoided use of GC because of the reported lack of cleanliness of the extraction device, SPE-GC is now a mature technique. Off-line SPE-GC is well documented [62,63] but less attractive, mainly in terms of analyte detectability (only an aliquot of the extract is injected into the chromatograph), precision, miniaturisation and automation, and solvent consumption. The interface of SPE with GC consists of a transfer capillary introduced into a retention gap via an on-column injector. Automated SPE may be interfaced to GC-MS using a PTV injector for large-volume injection [64]. LVI actually is the basic and critical step in any SPE-to-GC transfer of analytes. Suitable solvents for LVI-GC include pentane, hexane, methyl- and ethylacetate, and diethyl or methyl-f-butyl ether. Large-volume PTV permits injection of some 100 iL of sample extract, a 100-fold increase compared to conventional GC injection. Consequently, detection limits can be improved by a factor of 100, without... 

There are three injection techniques for introducing a sample into a GC equipped with a capillary column split injection, splitless injection, and on-column injection. Split injection is the most often used injection technique. When a certain amount of FAME sample (1 to 3 ll) is introduced into the GC injector that is normally set at a temperature much higher than the boiling point of the solvent, the solvent vaporizes instantly in the carrier gas and creates a large volume of gas that contains all of the injected FAME in it. The carrier gas that contains the FAME is then divided into two streams from the injector one is directed onto the column, and the second is vented to the atmosphere, clearing the sample out of the injection chamber momentarily. This way, only a limited amount of sample is introduced into the column, to avoid column overloading, and injection time is short, to avoid peak broadening. 

In this separation, a 10-mL sample (large volume) containing a solution in tert-butyl methyl ether (tBME) of the pyrolysate of 1 mg cellulose obtained at 600° C was injected (off-line pyrolysis). The PTV injector was programmed at 20° C initial temperature for 2 min. and ramped with 10° C/min at 250° C and kept at this temperature for 1 min. Then the injector was further heated at 300° C. The split vent purge time was 2.5 min. The oven temperature for the first dimension separation was kept at 35° C for 2.5 min. then heated with 30° C/min. at 55° C and further heated with 3° C/min. to 240° C. The detector used in the first dimension was an MS system, which allowed the identification of a series of compounds from this chromatogram. The peak identification is given in Table 5.2.2. 

It has been shown that the PTV injector is a very useful technique for large-volume injection, especially for the analysis of a dirty sample. Because the vaporization of the solvent is carried out at a low temperature, nonvolatile matrix constituents remaining in the liner will not contaminate the GC column. However, the PTV injection technique is less suited when analyzing volatile compounds because only components with volatility significantly below that of the solvent are trapped in the cold liner, unless liners packed with a selective adsorbent is used [4]. 

---